lock TOYOTA VENZA 2016 Owners Manual

5
When trouble arises
5955-2. Steps to take in an emergency
VENZA_OM_OM73030U_(U) If the electronic key does no t operate properly (vehicles with smar t key system)Locking and unlocking the door s and key linked functions
Using the mechanical key
(  P. 29) in order to perform
the following operations.
Locks all doors
Unlocks all doors Turning the key rearward unlocks
the driver’s door. Turning the key
once again within 3 seconds
unlocks the other doors.If communication between the electronic key and vehicle is inter-
rupted (  P. 30) or the electronic key cannot be used because the
battery is depleted, the smart key system and wireless remote con-
trol cannot be used. In such cases, the doors can be opened or the
engine can be started by following the procedure below.

5
When trouble arises
5975-2. Steps to take in an emergency
VENZA_OM_OM73030U_(U) ■ Stopping the engine
Shift the shift lever to “P” and press the “ENGINE START STOP” switch as
you normally do when stopping the engine.
■ Replacing the key battery
As this above procedure is a temporary measure, it is recommended that the
electronic key battery be replaced immediately when the battery depletes.
(  P. 523)
■ Alarm
Using the mechanical key to lock the doors will not set the alarm system.
If a door is unlocked using the mechanical key when the alarm system is set,
the alarm may be triggered. (  P. 112)
■ Changing “ENGINE START STOP” switch mode
Release the brake pedal and press the “ENGINE START STOP” switch in
above.
The engine does not start and modes will be changed each time the switch
is pressed. (  P. 174) STEP 3

6005-2. Steps to take in an emergency
VENZA_OM_OM73030U_(U) ■ Starting the engine when the battery is discharged
The engine cannot be started by push-starting.
■ Avoiding a discharged battery
● Turn off the headlights and the audio system while the engine is turned
off.
● Turn off any unnecessary electrical components when the vehicle is run-
ning at a low speed for an extended period, such as in heavy traffic, etc.
■ When the battery is removed or discharged
● The power back door must be initialized. (  P. 60)
● Make sure that the key is not inside the vehicle when recharging or
replacing the battery. The key may be locked in the vehicle if the alarm is
activated. (  P. 114)Start the engine of the second vehicle. Increase the engine
speed slightly and maintain at that level for approximately 5
minutes to recharge the battery of your vehicle.
Vehicles with smart key system: Open and close any of the
doors with the “ENGINE START STOP” switch off.
Maintain the engine speed of the second vehicle and turn
the “ENGINE START STOP” switch to IGNITION ON mode
(vehicles with smart key system) or turn the engine switch
to the “ON” position (vehicles without smart key system),
then start your vehicle’s engine.
Once the vehicle’s engine has started, remove the jumper
cables in the exact reverse order in which they were con-
nected.
Once the engine starts, have the vehicle checked at your Toyota
dealer as soon as possible. STEP 2
STEP 3
STEP 4
STEP 5

5
When trouble arises
6095-2. Steps to take in an emergency
VENZA_OM_OM73030U_(U) CAUTION■ If the engine has to be turned off while driving
● Power assist for the brake and steering wheel will be lost, making the
brake pedal harder to depress and the steering wheel heavier to turn.
Decelerate as much as possible before turning off the engine.
● Vehicles without a smart key system: Never attempt to remove the key, as
doing so will lock the steering wheel. Vehicles with a smart key sys-
tem: To stop the engine, press
and hold the “ENGINE START
STOP” switch for 2 consecu-
tive seconds or more, or press
it briefly 3 times or more in
succession.
Stop the vehicle in a safe place by the road. STEP 4
Press and hold for 2 seconds or more,
or press briefly 3 times or more
STEP 5

6146-1. Specifications
VENZA_OM_OM73030U_(U) ■ Engine number
2GR-FE engine
The engine number is stamped
on the engine block as shown.
1AR-FE engine

6206-1. Specifications
VENZA_OM_OM73030U_(U) Automatic transaxle
* : The fluid capacity is a reference quantity. If replacement is necessary, con-
tact your Toyota dealer.
Transfer (AWD models) Fluid capacity
* 2GR-FE engine
1AR-FE engine 2WD models: 6.9 qt. (6.5 L, 5.7 Imp.qt.)
AWD models: 7.1 qt. (6.7 L, 5.9 Imp.qt.)
6.9 qt. (6.5 L, 5.7 Imp.qt.)
Fluid type Toyota Genuine ATF WS
NOTICE■ Automatic transaxle fluid type
Using transaxle fluid other than “Toyota Genuine ATF WS” may cause dete-
rioration in shift quality, locking up of your transaxle accompanied by vibra-
tion, and ultimately damage the transaxle of your vehicle.
Oil capacity 0.8 qt. (0.8 L, 0.7 Imp.qt.)
Oil type and viscosity Toyota Genuine Differential gear oil LT
75W-85 GL-5 or equivalent

6466-2. Customization
VENZA_OM_OM73030U_(U) Item Function Default
setting Customized
setting
Smart key
system
(  P. 30) Smart key system ON OFF — O
Select doors to
unlock Driver’s
door All doors — O
Wireless
remote control
(  P. 45) Wireless remote
control ON OFF — O
Unlocking operation Driver’s
door
unlocked in
one step,
all doors
unlocked in
two step All doors
unlocked in
one step OO
Open door warning
function (when
locking the vehicle) ON OFF — O
Panic function ON OFF — O

6476-2. Customization
6
Vehicle specifications
VENZA_OM_OM73030U_(U) Item Function Default
setting Customized
setting
Smart key
system
(  P. 30)
and wireless
remote control
(  P. 45) Operation signal
(Emergency
flashers) ON OFF O O
Operation signal
(Buzzer) Level 7 Level 1 to 6
—O
OFF
Time elapsed before
automatic door lock
function is activated
if door is not opened
after being unlocked 60 seconds OFF
OO30 seconds
120
seconds
Power easy
access system
(  P. 75) Driver’s seat
movement when
exiting the vehicle ON OFF — O

6486-2. Customization
VENZA_OM_OM73030U_(U) Item Function Default
setting Customized
setting
Door lock
(  P. 50) Unlocking using
a key Driver’s
door
unlocked in
one step, all
doors
unlocked in
two step All doors
unlocked in
one step —O
Speed-detecting
automatic door lock
function OFF ON O O
Shifting the shift
lever to position
other than “P” locks
all doors ON OFF O O
Shifting the shift
lever to “P” unlocks
all doors ON OFF O O
Opening driver’s
door unlocks all
doors OFF ON O O

6506-2. Customization
VENZA_OM_OM73030U_(U) Item Function Default
setting Customized
setting
Illumination
(  P. 430) Time period before
lights turn off 15 seconds 7.5 seconds
OO
30 seconds
Vehicles with smart
key system:
Operation after the
“ENGINE START
STOP” switch is
turned off
Vehicles without
smart key system:
Operation after the
engine switch is
turned to the “LOCK”
position ON OFF — O
Operation when the
doors are unlocked ON OFF — O
Operation when you
approach the
vehicle with the
electronic key on
your person (When
the personal/interior
light main switch is
door position.)
(vehicles with smart
key system) ON OFF — O