bulb TOYOTA YARIS GRMN 2017 User Guide

3036-3. Do-it-yourself maintenance
YARIS_GRMN_OM_Europe_OM52J40E
6
Maintenance and care
Install the connector.
Shake the bulb base gently to
check that it is not loose, turn
the front fog light, on once and
visually confirm that no light is
leaking through the mounting.
Reinstall the fender liner.
Attach the end of the fender liner
to the inside of the front bumper.
Attach the fender liner
retainer.
Install the screw.

3046-3. Do-it-yourself maintenance
YARIS_GRMN_OM_Europe_OM52J40E
■Front turn signal lights
Turn the bulb base counter-
clockwise.
Remove the light bulb
When installing, reverse the steps listed.

3056-3. Do-it-yourself maintenance
YARIS_GRMN_OM_Europe_OM52J40E
6
Maintenance and care
■Side turn signal lights
Depress the mirror.
Remove the mirror.
To prevent damaging the vehi-
cle, wrap the screwdriver with a
tape.
Remove the bulb base.
Remove the light bulb.

3066-3. Do-it-yourself maintenance
YARIS_GRMN_OM_Europe_OM52J40E
After installing the new bulb,
secure the bulb base to the
mirror body.
Align the tabs, and secure
the mirror by pushing in each
diagonally-opposite pair of
tabs in order.
Make sure to insert the tabs in
order as shown in the illustra-
tion, and push them in until a
click is heard.
If you do not hear the click, do
not force the tabs in. Instead,
remove the mirror and check
that the tabs are aligned.

3076-3. Do-it-yourself maintenance
YARIS_GRMN_OM_Europe_OM52J40E
6
Maintenance and care
■Rear turn signal lights
Open the back door and
remove the cover.
To prevent damaging the vehi-
cle, wrap the screwdriver with a
tape.
Turn the bulb base counter-
clockwise.
Remove the light bulb.

3086-3. Do-it-yourself maintenance
YARIS_GRMN_OM_Europe_OM52J40E
Install the new bulb.
Turn and secure the bulb
base.
Install the cover.
Align the cover claws with
the notches.
Press the cover until it is
fixed.

3096-3. Do-it-yourself maintenance
YARIS_GRMN_OM_Europe_OM52J40E
6
Maintenance and care
■License plate light
Remove the lens.
lnsert a small flathead-
screwdriver, etc. into either
the right or left hole of the
lens
Push the screwdriver side-
ways in the direction of the
arrow shown in the illustra-
tion, disengage the hook,
and then remove the lens.
To prevent damage to the
vehicle, wrap the tip of the
screwdriver with tape.
Remove the light bulb.
Install a new light bulb.
Lens
Hook

3116-3. Do-it-yourself maintenance
YARIS_GRMN_OM_Europe_OM52J40E
6
Maintenance and care
■Back-up light
Open the back door and
remove the cover.
Press down on the notch on the
cover and remove the cover.
It is recommended for safe-
guarding to wrap the tip of the
screwdriver with a cloth, etc., in
order to prevent scratches to the
vehicle.
Turn the bulb base counter-
clockwise.
Remove the light bulb.
Install a new light bulb.
STO73AP199

3126-3. Do-it-yourself maintenance
YARIS_GRMN_OM_Europe_OM52J40E
Install the bulb base.
Install the back door cover.
Align the cover 2 tabs on the
cover and install.

3136-3. Do-it-yourself maintenance
YARIS_GRMN_OM_Europe_OM52J40E
6
Maintenance and care
■Replacing the following bulbs
If any of the lights listed below has burnt out, have it replaced by
any authorized Toyota retailer or Toyota authorized repairer, or any
reliable repairer.
● Front position lights and daytime running lights
● Stop lights
● Tail lights
● High mounted stoplight
● Rear fog light
■LED Lights
The front position lights and daytime running lights, stop lights, tail lights, high
mounted stoplight and rear fog light consists of a number of LEDs. If any of
the LEDs burn out, take your vehicle to any authorized Toyota retailer or
Toyota authorized repairer, or any reliable repairer to have the light replaced.
If one or more LEDs in a stop light burn out, your vehicle may not conform to
local laws (ECE).
■ Condensation build-up on the inside of the lens
Temporary condensation build-up on the inside of the headlight lens does not
indicate a malfunction. Contact any authorized Toyota retailer or Toyota
authorized repairer, or any reliable repairer for more information in the follow-
ing situations:
● Large drops of water have built up on the inside of the lens.
● Water has built up inside the headlight.
■ When replacing light bulbs
 P. 296