ESP VOLKSWAGEN JETTA 1998 Repair Manual

Downloaded from www.Manualslib.com manuals search engine 01-286



- Now perform test drive for maximum 50 seconds
at a speed of 15km/h...30km/h:

It must be driven so that no ABS, EDL, ASR or
ESP regulation is performed.

Make a turn with steering wheel turned at least
90 .
When the ABS warning lamp -K47- and ESP
warning lamp -K155- go out, the ESP driving
test has been successfully completed.

WARNING!

Always comply with road traffic regulations
and drive according to the traffic conditions.

Note:

If the ABS warning light -K47- does not go out,
then the ESP driving test has not been
performed correctly.

If the ABS warning light -K47- does not go out
and the ESP control lamp -K155- lights up
again, check DTC memory Page 01
-170 .
Стр. 128из 129 On Board Diagnostic (OBD), performing

Downloaded from www.Manualslib.com manuals search engine 01-289



The test steps Page 01-297 apply only to
vehicles with ABS/EDL/ASR/ESP
For vehicles on which the On Board Diagnostic
(OBD) does not give any indication of the
source of the malfunction. Work through the
complete electrical check.

For vehicles on which the OBD provides a
direct indication of the source of the
malfunction. Only carry out the test steps
recommended in the DTC table (directed entry).
An overview of all the test steps in the electrical
check Page 01
-297 .
Стр. 2из 38 Electrical check of Mark 60

Downloaded from www.Manualslib.com manuals search engine
01-293


Contact
Wiring connection to component ...
1
Voltage supply fr om battery +
2
Connector T16/7, K wire
3

Longitudinal acceleration sens or -G251- sensor wire(4MOTION vehicles only)
Vacant (4MOTION vehicles with ESP-sensor unit -G419, vehicles from 11.01)
4
Voltage supply from igni tion/starter switch
5

Longitudinal acceleration se nsor -G251- Ground(4MOTION vehicles only)
Vacant (4MOTION vehicles with ESP-sensor unit -G419- , vehicles from 11.01)
6

Sensor for transverse acceleration -G200-
Voltage supply for ESP-sensor unit -G419-, vehicles from 02.02
7

Longitudinal acceleration se nsor -G251- voltage supply(4MOTION vehicles
only)
Vacant (4MOTION vehicles with ESP-sensor unit -G419- , vehicles from 11.01)
8
Vehicles with navi gation system only
9
Coding bridge to contact 12 (vehicle s with ABS/EDL/ASR/ESP 4MOTION
only)
10
Vehicles with navi gation system only
11
Data bus wire Wiring diagrams
12
Coding bridge to contact 9 (vehicles with ABS/EDL/ASR/ESP 4MOTION only)
Coding bridge to contact 38 (vehicles with ABS/EDL/ASR/ESP front wheel
drive only)
Стр. 6 из 38
Electrical check of Mark 60
Volkswagen Technical Site: http://v olkswagen.msk.ru http://vwts.info http://vwts.ru
огромный архив документации по автомобилям Volkswagen, Skoda, Seat, Audi

Downloaded from www.Manualslib.com manuals search engine 01-294


Contact
Wiring connection to component ...
13
ASR/ESP button -E256-
14
Coding bridge to contact 38 (vehicles with ABS and ABS/EDL/ASR front wheel
drive only)
15
Data bus wire Wiring diagrams
16 Ground point on left-hand longitudinal member
17
Vacant
18
Sender 1 for brake booster -G201- voltage supply
19
Sender 1 for brake booster -G201- signal wire
20
Sender 1 for brake booster -G201- ground wire
21
Vacant
22
Vacant
23
Vacant
24

Ground wire for sensor for transverse acceleration -G200- and sender for
rotation rate -G202-
Ground wire for ESP-sensor unit -G419-, vehicles from 02.02
25

Vacant
Data bus wire for ESP-sensor unit -G419-, vehicles from 02.02
26
Voltage supply for sensor for transverse acceleration -G200- and sender for
rotation rate -G202-
Стр. 7из 38 Electrical check of Mark 60

Downloaded from www.Manualslib.com manuals search engine 01-295


Contact
Wiring connection to component ...
27
Vacant
28
Vacant
29

Vacant
Data bus wire for ESP-sensor unit -G419-
30
Vacant
31
Vacant
32
Voltage supply from battery +
33
Right front ABS wheel speed sensor -G45-
34
Right front ABS wheel speed sensor -G45-
35
Vacant
36
Left rear ABS wheel speed sensor -G46-
37
Left rear ABS wheel speed sensor -G46-
38

Coding bridge to contact 12 (vehicles with ABS/EDL/ASR/ESP front wheel
drive only)
Coding bridge to contact 14 (vehicles with ABS and ABS/EDL/ASR front wheel
drive only)
Стр. 8из 38 Electrical check of Mark 60

Downloaded from www.Manualslib.com manuals search engine 01-298


Component to be tested

Voltage signal of left rear ABS wheel speed sensor -G46-
- Perform test step 12
Warning lamp function for ABS warning light -K47-
- Perform test step 13
Warning lamp function for warning light for brake system -K118-
- Perform test step 14
Warning lamp function for ESP control lamp -K155-
- Perform test step 15
Function of ASR/ESP button -E256-
- Perform test step 16
Activation of steering angle sensor -G85-
- Perform test step 17
Activation of sensor for transverse acceleration -G200-
Activation of sender for rotation rate -G202- - Perform test step 18
Activation of sender 1 for brake booster -G201-
- Perform test step 19
Check of data bus wiring
- Perform test step 20
Voltage supply for V.A.G 1551, connector T16
- Perform test step 21
Resistance of K wire for self-diagnosis, connector T16
- Perform test step 22
Coding bridge
- Perform test step 23
Стр. 11из 38 Electrical check of Mark 60

Downloaded from www.Manualslib.com manuals search engine 01-310


Functional check: ESP Control Lamp -K155-
Test
step V.A.G
1598
sockets Item
tested
Test
conditions
- Additional
operations Specification
Measures for
deviations from
specification
15 - Function of
ESP
control
lamp -
K155-
Ignition
switched
on
- Switch
ignition on ESP control lamp -
K155- lights up for 2
seconds and goes
out again Electrical Wiring
Diagrams,
Troubleshooting &
Component Locations
binder
Repair Manual,
Body Interior,Repair
Group 70; instrument
panel - Check wiring using
wiring diagram
- Malfunction in
instrument cluster
Стр. 23из 38 Electrical check of Mark 60

Downloaded from www.Manualslib.com manuals search engine 01-311


Functional check: warning lamp for ASR/ESP button -E256-
Test
step V.A.G
1598
sockets Item
tested
Test conditions
- Additional
operations Specification
Measures for
deviations from
specification
16 - Function of
ASR/ESP
button -
E256-
Ignition
switched on
The function of
the ESP Control
Lamp -K155-
was checked in
test step 15. ESP control lamp -
K155- lights up for
2 seconds and
goes out again

- Operate
ASR/ESP button -
E256- ESP control lamp -
K155- lights up

- Operate
ASR/ESP button -
E256- again ESP control lamp -
K155- goes out
Test step 16: Continued on next page.
Стр. 24из 38 Electrical check of Mark 60

Downloaded from www.Manualslib.com manuals search engine 01-312


Continuation of test step 16
Test
step V.A.G
1598
sockets Item
tested
Test
conditions
- Additional
operations Specification
Measures for deviations
from specification

Electrical Wiring
Diagrams, Troubleshooting
& Component Locations
binder - Check wiring using wiring
diagram
ASR/ESP button
-E256- faulty
Repair Manual, Body
Interior,Repair Group 70;
instrument panel - Replace ASR/ESP button
-E256-
Стр. 25из 38 Electrical check of Mark 60

Downloaded from www.Manualslib.com manuals search engine 01-325


Switch to measuring range:
Resistance measurement (200 )
Test
step V.A.G
1598
sockets Item tested Test
conditions
- Additional
operations Specification
Measures for
deviations from
specification
23 14 + 38 Coding bridge for
ABS and
ABS/EDL/ASR
front wheel drive
Ignition
switched
off 0.0 -1.0
12 + 38 Coding bridge for
ABS/EDL/ASR/ESP
front wheel drive
12 + 9 Coding bridge for
ABS/EDL/ASR/ESP
4MOTION

Electrical Wiring
Diagrams,
Troubleshooting &
Component
Locations binder - Check wiring
using wiring
diagram
Стр. 38из 38 Electrical check of Mark 60