key YAMAHA GIGGLE50 2007 User Guide
[x] Cancel search | Manufacturer: YAMAHA, Model Year: 2007, Model line: GIGGLE50, Model: YAMAHA GIGGLE50 2007Pages: 72, PDF Size: 1.05 MB
Page 32 of 72

5-3
1
2
3
4
5
6
7
8
9
OPERATION AND IMPORTANT RIDING POINTS
EAU17212
ParkingWhen parking, stop the engine, and
then remove the key from the main
switch.
EWA10310
w● ●● ●
●
Since the engine and exhaust
system can become very hot,
park in a place where pedestri-
ans or children are not likely to
touch them.
● ●● ●
●
Do not park on a slope or on soft
ground, otherwise the vehicle
may overturn.
ECA10380
cCNever park in an area where there are
fire hazards such as grass or other
flammable materials.
Engine break-in
Parking
EAU16830
Engine break-inThere is never a more important period
in the life of your engine than the period
between 0 and 1000 km (600 mi). For
this reason, you should read the follow-
ing material carefully.
Since the engine is brand new, do not
put an excessive load on it for the first
1000 km (600 mi). The various parts in
the engine wear and polish themselves
to the correct operating clearances.
During this period, prolonged full-throttle
operation or any condition that might
result in engine overheating must be
avoided.
EAU16950
0 ~ 150 km (0 ~ 90 mi)
Avoid prolonged operation above 1/3
throttle.
After every hour of operation, stop the
engine, and then let it cool for five to
ten minutes.
Vary the engine speed from time to time.
Do not operate the engine at one set
throttle position.150 ~ 500 km (90 ~ 300 mi)
Avoid prolonged operation above 1/2
throttle.
Rev the engine freely through the gears,
but do not use full throttle at any time.
500 ~ 1000 km (300 ~ 600 mi)
Avoid prolonged operation above 3/4
throttle.
ECA10350
cCAfter 1000 km (600 mi) of operation,
the engine oil must be changed and
the oil strainer cleaned.1000 km (600 mi) and beyond
Avoid prolonged full-throttle operation.
Vary the speed occasionally.
ECA10270
cCIf any engine trouble should occur
during the engine break-in period,
immediately have a Yamaha dealer
check the vehicle.
15P-F8199-E0_ch5.pmd2007/06/13, 11:17 3
Page 53 of 72

6-21
1
2
3
4
5
6
7
8
9
EAU17226
PERIODIC MAINTENANCE AND MINOR REPAIR
EAUT2021
Replacing the fuseZAUM00**
1
1. FuseThe fuse holder is located beside the
battery. Remove panel C to access the
fuse. (See page 6-6.)
If the fuse is blown, replace it as follows.
1. Turn the key to “OFF” and turn off
all electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.Specified fuse:
15 A
Fuse, replacing
ECAT1061
cC● ●● ●
●
Do not use a fuse of a higher
amperage rating than recom-
mended to avoid causing exten-
sive damage to the electrical
system and possibly a fire.
● ●● ●
●
After removing and installing the
main fuse, be sure to turn the
main switch from “ON” to “OFF”
three times in 3 seconds inter-
vals to initialize the idle speed
control system.
3. Turn the key to “ON” and turn on
the electrical circuits to check if the
devices operate.
4. If the fuse immediately blows again,
have a Yamaha dealer check the
electrical system.
● ●● ●
●
To charge a sealed-type (MF)
battery, a special (constant-volt-
age) battery charger is required.
Using a conventional battery
charger will damage the battery.
If you do not have access to a
sealed-type (MF) battery
charger, have a Yamaha dealer
charge your battery.
● ●● ●
●
After installing the battery, be
sure to turn the main switch
from “ON” to “OFF” three times
in 3 seconds intervals to initial-
ize the idle speed control sys-
tem.
15P-F8199-E0_ch6.pmd2007/06/21, 11:09 21
Page 65 of 72

9-1
1
2
3
4
5
6
7
8
9
CONSUMER INFORMATION
EAU26351
Identification numbersRecord the key identification number,
vehicle identification number and model
label information in the spaces provided
below for assistance when ordering
spare parts from a Yamaha dealer or
for reference in case the vehicle is sto-
len.
KEY IDENTIFICATION NUMBER:
VEHICLE IDENTIFICATION NUMBER:
MODEL LABEL INFORMATION: Identification numbers
Key identification number
Vehicle identification number
EAU26381
Key identification numberZAUM00**
1
1. Key identification numberThe key identification number is
stamped into the key tag.
Record this number in the space pro-
vided and use it for reference when or-
dering a new key.
EAU26342
CONSUMER INFORMATION
EAU26410
Vehicle identification numberZAUM00**
1
1. Vehicle identification numberThe vehicle identification number is
stamped into the frame.NOTE:
The vehicle identification number is
used to identify your motorcycle and
may be used to register your motorcycle
with the licensing authority in your area.
15P-F8199-E0_ch9ind.pmd2007/06/16, 16:02 1
Page 67 of 72

INDEX
AAcceleration and deceleration ................. 5-2
Air filter element, replacing .................... 6-12BBattery.................................................... 6-20
Brake lever free play, adjusting .............. 6-15
Brake lever, front ...................................... 3-6
Brake lever, rear ....................................... 3-6
Brake levers, lubricating......................... 6-17
Brake shoes, checking ........................... 6-16
Braking..................................................... 5-2CCare .......................................................... 7-1
Catalytic converter ................................... 3-8
Centerstand, checking and lubricating .. 6-18
Coolant................................................... 6-10
Coolant temperature warning light ........... 3-3DDimmer switch.......................................... 3-5EEngine break-in........................................ 5-3
Engine oil................................................. 6-7
Engine trouble warning light .................... 3-3FFinal transmission oil............................... 6-9
Front fork, checking............................... 6-18
Fuel .......................................................... 3-7
Fuel gauge............................................... 3-4
Fuel tank cap........................................... 3-6
Fuse, replacing ...................................... 6-21HHandlebar switches .................................. 3-5
Headlight bulb, replacing....................... 6-22
Helmet holder........................................... 3-9High beam indicator light ......................... 3-3
Horn switch .............................................. 3-5
IIdentification numbers.............................. 9-1
Indicator and warning lights ..................... 3-2KKey identification number ......................... 9-1
Keyhole cover ........................................... 3-2
Kickstarter ................................................ 3-8LLuggage hook.......................................... 3-9MMain switch/steering lock ......................... 3-1
Maintenance, periodic .............................. 6-1
Model label............................................... 9-2PPanels, removing and installing............... 6-5
Parking..................................................... 5-3
Part locations........................................... 2-1
Periodic maintenance and lubrication
chart ....................................................... 6-2
Pre-operation check list ........................... 4-2RRear brake lever free play, adjusting ..... 6-16SSafe-riding points ..................................... 1-4
Safety information .................................... 1-1
Seat.......................................................... 3-9
Spark plug, checking ............................... 6-6
Specifications........................................... 8-1
Speedometer unit..................................... 3-4
Start switch .............................................. 3-5
Starting off ................................................ 5-2
Starting the engine ................................... 5-1Steering, checking ................................. 6-19
Storage ..................................................... 7-3
Storage compartment ............................ 3-10
TTail/brake light bulb, replacing................ 6-23
Throttle cable free play, checking .......... 6-12
Throttle grip and cable, checking and
lubricating............................................ 6-17
Tires ....................................................... 6-13
Troubleshooting...................................... 6-24
Troubleshooting charts ........................... 6-25
Turn signal indicator light......................... 3-3
Turn signal light bulb, replacing............. 6-24
Turn signal switch ..................................... 3-5VValve clearance ...................................... 6-12
Vehicle identification number ................... 9-1WWheel bearings, checking ...................... 6-19
Wheels................................................... 6-15
15P-F8199-E0_ch9ind.pmd2007/06/16, 16:02 3