BMW MOTORRAD K 1200 GT 2002 Rider's Manual (in English)

22
39
Safety check
2
Brake system - with BMW Integral ABS
Brake fluid level, rear
brake
 Warning lights 1 and 2
(
b 79) in the array of telltale
and warning lights flash alter-
nately if the fluid in the reser-
voir drops below the minimum
permissible level
*n depending on national-market
specification
L Note:
The brake fluid level in the
brake fluid reservoir remains
constant despite wear of the
brake pads.
1*2
10k41bkg2.book Seite 39 Donnerstag, 24. Juli 2003 9:17 09

40
Safety check
2
Coolant level
Checking coolant level
e Attention:
Always keep the level above the
minimum mark. Check coolant
level only when the engine is
cold.  Place motorcycle on main
(centre) stand
– Make sure the ground is
level and firm.
 Remove the seat if necessary
(
b 20)
 Check coolant in expansion
tank:
MAX Maximum level
MIN Minimum level
10k41bkg2.book Seite 40 Donnerstag, 24. Juli 2003 9:17 09

22
41
Safety check
2
e Attention:
The coolant level must be be-
tween the MIN and MAX
marks.
Never overfill the expansion
tank.
•Top up the coolant if neces-
sary (
b Maintenance Instruc-
tions, Chapter 3)
L Note:
If the expansion tank is full and
coolant temperature is high (as
indicated by red warning light

j b 8) or coolant consumption
is excessive, consult a special-
ist workshop, preferably an au-
thorised BMW motorcycle
dealer.
Coolant level
MAX
MIN
10k41bkg2.book Seite 41 Donnerstag, 24. Juli 2003 9:17 09

42
Safety check
2
Checking fluid level in the
clutch fitting
e Attention:
If the fluid level drops, assume
there is a defect in the clutch sys-
tem. Have the clutch system
checked immediately by a spe-
cialist workshop, preferably an
authorised BMW motorcycle
dealer.
d Warning:
Never permit the fluid level to
drop below the minimum level
(MIN mark).
L Note:
The fluid level in the reservoir
rises as the clutch wears.
 Place motorcycle on main (centre) stand
– Make sure the ground is level and firm.
 Turn the handlebars all the way to the right
 Check fluid level in sight glass MIN Minimum level
(top of marking ring)
Clutch
MIN
10k41bkg2.book Seite 42 Donnerstag, 24. Juli 2003 9:17 09

22
43
Safety check
2
d Warning:
Before the journey starts, ad-
just spring preload to suit the
gross weight.
For safety reasons, never at-
tempt to alter spring preload
while the motorcycle is being
ridden.
Always bring the motorcycle to
a standstill before adjusting.
Adjusting spring preload Place motorcycle on main
(centre) stand
 Adjust spring preload by turning
knob 1 Basic setting, one-up:
Turn knob 1
as far as it will go
counter-clockwise in the
direction indicated by the
“ LOW ” arrow
Turn knob 1 one mark clock-
wise in the direction indicated
by the “ HIGH” arrow
Setting for two-up and
luggage:
Turn knob 1 as far as it will go
clockwise in the direction
indicated by the “ HIGH” arrow
1 Spring preload
10k41bkg2.book Seite 43 Donnerstag, 24. Juli 2003 9:17 09

44
Safety check
2
d Warning:
Before the journey starts, ad-
just the rear shock absorber to
suit the gross weight and load
on the motorcycle.
If spring preload is changed,
it is essential to adjust the
shock-absorber setting
accordingly.
 Place motorcycle on main stand (
b 60)
 Adjust the rear shock absorber by turning adjuster 1
as follows: Basic setting
(one-up):
 Turn the adjuster all the way clockwise as indicated by the
H arrow
 Then turn the adjuster one full
turn counter-clockwise in the
direction indicated by the S
arrow
Hard setting “H”:
 Turn the adjuster all the way clockwise as indicated by the
H arrow
Soft setting “S”:
 Turn the adjuster all the way counter-clockwise as indi-
cated by the S arrow
Shock-absorber adjustment
1
10k41bkg2.book Seite 44 Donnerstag, 24. Juli 2003 9:17 09

22
45
Safety check
2
Wheels
d Warning:
Use only wheels and tyres
that BMW Motorrad has ap-
proved for your motorcycle.
For each size of tyre BMW
tests certain makes, and ap-
proves those that it certifies
as roadworthy.
If BMW Motorrad has not ap-
proved the wheels and tyres it
cannot assess their suitability
or provide any guarantee of
road safety.
You can obtain detailed infor-
mation from your authorised
B M W m o t o r c y c l e d e a l e r o r b y
visiting
www.bmw-motorrad.com on
the Internet
Checking wheel rims
d Warning:
Have damaged wheel rims
checked and, if necessary,
replaced by a specialist work-
shop, preferably an author-
ised BMW motorcycle dealer.
Checking tyre tread
d Warning:
Comply with local legal re-
quirements concerning mini-
mum tread depth. Worn tyres
can impair handling.
 Measure tread depth at the centre of the tyre tread
BMW's minimum tread depth
recommendation:
Front ................. 2 mm (0.08 in)
Rear .................. 3 mm (0.12 in)
10k41bkg2.book Seite 45 Donnerstag, 24. Juli 2003 9:17 09

46
Safety check
2
Wheels
Checking tyre pressures
d Warning:
Incorrect tyre pressures have
a considerable influence on
handling and on tyre life.
Adjust tyre pressures to suit
total weight. Never exceed ei-
ther the motorcycle’s gross
weight or the individual wheel
load limits (b 49).
– When tyres are cold:
 Remove valve caps
 Check/correct tyre pressure Tyre pressures:
Front Rear
O n e - u p 2 . 5 b a r 2 . 9 b a r
(36.3 psi) (42 psi)
Two-up 2.5 bar 2.9 bar
(36.3 psi) (42 psi)
Two-up
with luggage 2.5 bar 2.9 bar (36.3 psi) (42 psi)
 Fully tighten valve caps
Fully tighten valve caps
d Warning:
At high road speeds, tyre
valves have a tendency to
open as a result of centrifugal
force.
Use only metal valve caps
with rubber seals.
Valve caps that are screwed
on well prevent air from es-
caping suddenly.
10k41bkg2.book Seite 46 Donnerstag, 24. Juli 2003 9:17 09

22
47
Safety check
2
d Warning:
BMW cannot examine or test
each product of outside origin
on the accessories and tyres
market to ensure that it can be
used on or in connection with
BMW motorcycles without con-
stituting a safety hazard. Even
approval by an official inspec-
tion authority or an official per-
mit (General Operating Permit)
cannot always provide this
guarantee. Tests conducted by
these instances cannot make
provision for all operating condi-
tions experienced by BMW mo-
torcycles and consequently,
they are not sufficient in some
circumstances.
L Note:
BMW accessories and other
products approved by BMW
can be obtained from your
authorised BMW motorcycle
dealer.

\b
\b\f

10k41bkg2.book Seite 47 Donnerstag, 24. Juli 2003 9:17 09

48
Safety check
2
Correct loading
d Warning:
Overloading can impair the
handling of your motorcycle.
 Make sure that the weight is uniformly distributed between
right and left
 Pack heavy items at the bottom and toward the
inboard side
OAOptional accessory
 Max. load in each case (left and right): 10 kg
(approx. 22 lbs)
 Max. load on luggage rack and in tank-top rucksack
OA
5 kg (11 lbs) each
 Check that fasteners are cor-
rectly positioned and tight
d Warning:
With system cases installed, it
is advisable not to exceed
130 km/h (80 mph).
Loading
10k41bkg2.book Seite 48 Donnerstag, 24. Juli 2003 9:17 09