headlamp CHEVROLET CAMARO 1967 1.G Chassis Owner's Manual

RADIATOR AND GRILLE 13-5

Fig.
4 - Radiator and Shroud - Corvette

attaching top of grille to left and GRILLE ASSEMBLY—CORVETTE (Fig. 10)

10.
Remove screws

right supports.

Remove rivets securing bottom of grille to filler

panel, support assemblies, and reinforcements and

remove grille from vehicle.

If necessary, remove rivets, screws, and retainers

securing reinforcements and name plate to grille and

replace reinforcements and name plate.

Remove screws attaching left and right supports and

remove supports.

Remove attaching hardware securing filler panel and

remove filler panel from vehicle.

Repair

If any components removed are undamaged, they may

be Used for the new grille installation. Where rivets

were removed, make new attachments using screws and

nuts,
patent clips, or rivets.

Installation

Install grille and related components following the re-

moval procedure in reverse order. Refer to torque spec-

ifications in rear of manual for correct torque values.
Removal

1.
Raise front of vehicle.

2.
Remove front bumper (Section 14).

3.
Remove grille retaining screws.

4.
Remove grille from vehicle.

Installation

Install grille and related components following the re-

moval procedure in reverse order. Refer to torque spec-

ifications in rear of manual for correct torque values.

GRILLE ASSEMBLY-CAMARO (Fig. 11)

NOTE:
If necessary to remove retractable

headlamp cover only, refer to Section 12.

Removal

1.
Raise hood and disconnect battery leads and remove

battery.

2.
Remove bumper (Section 14).

3.
Remove screws securing hood catch assembly to

CHEVROLET CHASSIS SERVICE MANUAL

RADIATOR AND GRILLE 13-6

VIEW A
VIEW B

V-8 ENGINE
RADIATOR

FAN GUARD

(L-6 ENGINE)

VIEW

Fig.
5 - Radiator and Shroud - Camaro

grille header panel, catch support bracket, and radi-

ator support and remove hood catch.

Remove screws from each headlamp bezel and re-

move bezels from vehicle. Remove headlamps.

Remove hardware attaching hood catch support to

radiator support, valance panel, and lower grille

and remove catch support from vehicle.

Disconnect parking lamps. Remove rivets securing

center grille to upper and lower grilles and remove

center grille from vehicle. If necessary, replace

name plate.

Remove screws and rivets securing grille header

panel to fenders and upper grille and remove header

panel.

Remove hardware attaching upper and lower grilles

to vehicle and remove upper and lower grilles.

Remove screws attaching valance panel to fenders,

and fender extensions and retractable headlamp door
assemblies if so equipped, and remove valance panel

from vehicle.

10.
If vehicle is equipped with retractable headlamp cov-

ers,
disconnect electrical plugs. Remove screws at-

taching headlamp bracket assemblies to radiator

support and remove assemblies from vehicle.

Repairs

If any components removed are undamaged, they may

be used for the new grille installation. Where rivets were

removed, make new attachments using screws and nuts,

patent clips, or rivets.

Installation

Install grille and related components following the re-

moval procedure in reverse order. Refer to torque spec-

ifications in rear of manual for correct torque values.

CHEVROLET CHASSIS SERVICE MANUAL

SPECIFICATIONS 25

BODY AND CHASSIS ELECTRICAL

SECTION
12

LAMP USAGE
CANDLE

POWER
BULB

NUMBER

Headlamp Unit

Chevrolet, Chevelle & Corvette

Outer - High Beam

Outer - Low Beam

Inner -• High Beam only

Chevy H

High Beam . .

Low Beam

Parking Lamp and Directional Signal

All Exc. Camaro

Camaro

Tail, Stop and Directional Signal (Exc. Bel Air)

Backing Lamp ••...,

Instrument Illumination Lamps

Chevrolet & Camaro ,

Chevelle and Chevy n

Corvette

Temperature Indicator

Chevrolet & Camaro

Chevelle and Chevy II .............

Oil Pressure Indicator

Chevrolet & Camaro .............

Chevelle and Chevy II

Generator Indicator

Chevrolet & Camaro .

Chevelle and Chevy n ,

Hi-Beam Indicator

Chevrolet & Camaro <

Chevelle and Chevy II

Corvette , . • . ,

Directional Indicator

Chevrolet & Camaro

Chevelle & Chevy II . .

Corvette . .

Cigarette Lighter Lamp

Corvette .

Ignition Lock Lamp

Chevrolet . . .

Corvette . . .

Heater or A/C Control Panel

Chevrolet, Chevelle, Chevy n & Camaro . . .

Corvette . . .

Glove Box Lamps

Chevrolet, Chevelle, Chevy n & Camaro . . .

Corvette . . . . .

Dome and Courtesy Lamps

Cartridge Type (AU)

Bayonet Type (Exc. Corvette) . . .

Corvette ,

Convertible . .
37 1/2 Watts

55 Watts

37 1/2 Watts

55 Watts

45 Watts

4-32

4-32

4-32

Special Fiber

1

2

3

2

3

12

6

6

6
Optic
4002

4002

4001

6012

1157

1034-A

1157

1156

194

1895
.

1816

194

1895

194

1895

194

1895

194

1895

1445

194

1895

1816

1445

Wiring

1445

1895

1893

1895

1893

211

89,
212

90

631

CHEVROLET CHASSIS SERVICE MANUAL

SPECIFICATIONS 26

LAMP USAGE (Cont'd.)
CANDLE

POWER

1

6

4

2

3

2

2

3

2

3

15

15
BULB

NUMBER

1445

212

67

1893

1816

194

1895

1816

257

1816

1003

93
Seat Separator-Compartment Lamp . . . . .

-Courtesy Lamp •

License Plate Lamp . .

Radio Dial Lamp

Chevrolet, Chevelle, Chevy n & Camaro

Corvette

Brake Alarm Lamp

. Chevrolet & Camaro . . .... . .

Chevelle & Chevy n . . . . .'. ;v . . . .

Corvette . . . . . . . .

Headlamp Mqtor Warning Lamp (Flashing) .

Clock Lamp (Corvette) .''> ....

Luggage Compartment Lamp. . ... . . . •

Underhood

FUSES AND CIRCUIT BREAKER

A circuit breaker in the light control switch protects

the headlamp circuit, thus eliminating one fuse. A

separate circuit breaker protects the power window,

seat and top circuits. On Corvettes the headlamp motor
circuit is also protected by a separate circuit breaker.

Where current load is too heavy, the circuit breaker

rapidly opens and closes, protecting the circuit until

the cause is found and eliminated.

louses located in the Fuse Panel under the instrument panel are:

Wiper (Chevrolet, Chevelle, and "F" Car) 3AF/AGC 20 Amp.

Back-up Lamp and Gauges. . . 3AG/AGC 10 Amp.

Heater - Air Conditioning 3AG/AGC 25 Amp.

Radio 3AG/AGC 10 Amp.

Radio - Wiper (Chevy II and Corvette) 3AG/AGC 20 Amp.

Instrument Lamps 3AG/AGC . 4 Amp.

Stop and Tail Lamps ........ t 3AG/AGC 20 Amp.

Clock, Lighter, Courtesy Lamps, and Hazard Warning 3AG/AGC 20 Amp.

In-Line Fuses:

Air Conditioning High Blower Speed Fuse located in wire running

from horn relay to A/C Relay

Comforton and Four Season SAE 30 Amp.

Universal & All Weather (Chevy H) SAE 20 Amp.

Fusible Links: ,

Pigtail lead at battery positive cable (except Corvette) 14 gage brown wire

Molded splice at Solenoid "Bat" terminal (Corvette only) 14 gage brown wire

Molded Splice Located at the horn relay 16 gage black wire

Molded splice in Voltage Regulator #3 terminal wire 20 gage orange wire

Molded splice in Ammeter circuit (Both sides of meter) 20 gage orange wire

CHEVROLET CHASSIS SERVICE MANUAL