Wi dow CITROEN C4 2018 Workshop Manual

195
C4-cactus_en_Chap08_En-cas-de-panne_ed01-2016
Fitting a wheel
Fitting the spare wheel
If your vehicle is fitted with alloy wheels,
when  tightening   the   bolts   on   fitting,   it   is  
n

ormal  
t
o  
n
otice  
t
hat  
t
he  
w
ashers  
d
o  
n
ot  
c

ome   into   contact   with   the   spare   wheel.  
T

he wheel is secured by the conical
sur face
  of   each   bolt.
After changing a wheel
Have the tightening of the bolts and the pressure   of   the   spare   wheel   checked  
b

y   a   CITROËN   dealer   or   a   qualified  
w

orkshop   without   delay.
Have the punctured wheel repaired
and refitted to the vehicle as soon as
possible.
F
 
R

emove
 
the
 
bolts
 
and
 
store
 
them
 
in
 
a
 
clean
 
p

lace.
F
 R
emove
 
the
 
wheel.
8
In the event of a breakdown

196
C4-cactus_en_Chap08_En-cas-de-panne_ed01-2016
List of operations
F Put  the   wheel   in   place   on   the   hub.
F  S crew   in   the   bolts   fully   by   hand.
F
 
P
re-tighten   the   bolts   using   the  
w

heelbrace

1  
o
n l y. F
 L ower   the   vehicle   fully.
F  F old   the   jack   2   and   detach   it.F
 T ighten   the   bolts   using   the  w
heelbrace 1 o n l y.
F
 
R
efit   the   wheel   bolt   cover(s)   (depending   on  
v

e r s i o n).
In the event of a breakdown

197
C4-cactus_en_Chap08_En-cas-de-panne_ed01-2016
Changing a bulb
Front lamps
1. Daytime  running   lamps   /   Sidelamps  (LE
Ds).
2.
 D

ipped   beam   headlamps   (H7).
3.
 M

ain   beam   headlamps   (H1).
4.
 D

irection   indicators   (PY21W).
5.
 F

ront   foglamps   (PS24W). In
  some   weather   conditions   (e.g.   low  
t

emperature   or   humidity),   the   presence  
o

f   misting   on   the   internal   sur face   of   the  
g

lass   of   the   headlamps   and   rear   lamps  
i

s   normal;   it   disappears   after   the   lamps  
h

ave   been   on   for   a   few   minutes.
The   headlamps   are   fitted   with  
p

olycarbonate   glass   with   a   protective  
c

oating:
F
d
o not clean them using a dr y
or abrasive cloth, nor with a
detergent or solvent product,
F  
u
se   a   sponge   and   soapy   water   or   a  
p

H neutral product,
F  
w
hen   using   a   high   pressure   washer  
o

n   persistent   marks,   do   not   keep  
t

he lance directed towards the
lamps   or   their   edges   for   too   long,  s
o   as   not   to   damage   their   protective  c
oating a nd sea ls.
Changing
  a   bulb   should   only   be   done  
a

fter   the   headlamp   has   been   switched  
o

ff   for   several   minutes   (risk   of   serious  
b

urns).
F

D
o not touch the bulb directly with
your
  fingers,   use   a   lint-free   cloth.
It
  is   imperative   to   use   only   anti-
ultraviolet (UV) type bulbs to avoid
damaging
 t

he
 h
eadlamp.
Always replace a failed bulb with a
new
  bulb   with   the   same   type   and  
s

pecification.
8
In the event of a breakdown

198
C4-cactus_en_Chap08_En-cas-de-panne_ed01-2016
Daytime running lamps /
S idelamps (LEDs)
For the replacement of the light-emitting d
iodes (LEDs), contact a CITROËN dealer or a
qualified
 w

orkshop. F
 D isconnect   the   bulb   connector.
F
 
R
emove   the   bulb   and   change   it.
Dipped beam headlamps
F Remove  the   protective   cover   by   pulling   the  t
ab.
F
 
T
ake   the   connector   and   bulb   holder,   then  
l

ift   the   assembly   upwards   to   unclip   it.
F
 
R
emove   the   assembly   of   connector   and  
b

ulb   holder. To
  reassemble,   carry   out   these   operations   in  
r

everse order, positioning the alignment lug
at the top .
In the event of a breakdown

199
C4-cactus_en_Chap08_En-cas-de-panne_ed01-2016
Main beam headlamps
F Remove  the   protective   cover   by   pulling   the  t
ab.
F

D
isconnect the bulb connector (do not
remove
 t

he
 e
arth
 c
onnector
 lo
cated
 belo
w).
F
 
P
ush   on   the   spring,   then   move   it   towards  
t

he   middle   of   the   vehicle   to   release  
t

he bulb.
F
 
R
emove   the   bulb   and   change   it.
Direction indicators
Amber coloured bulbs, such as the direction   indicators,   must   be   replaced  
w

ith bulbs of identical specifications
and
  colour.
Rapid
 
flashing
 
of
 
the
 
direction
 
indicator
 w
arning
 
lamp
 
(right
 
or
 
left)
 
indicates
 
the
 
f

ailure
 
of
 
a
 
bulb
 
on
 
that
 
side.
F
 
T

urn
 
the
 
bulb
 
holder
 
an
 
eighth
 
of
 
a
 
turn
 
a

nti-clockwise
 
and
 
extract
 
it.
F
 
R

emove
 
the
 
bulb
 
and
 
change
 
it.
To
 
reassemble,
 
carry
 
out
 
these
 
operations
 
in
 
r

everse
 o

rder. To
 
reassemble,
 
carry
 
out
 
these
 
operations
 
in
 
r

everse
 o

rder.
8
In the event of a breakdown

200
C4-cactus_en_Chap08_En-cas-de-panne_ed01-2016
Front foglamps
You can also contact a CITROËN
dealer  or   a   qualified   workshop   for   the  
r

eplacement   of   these   bulbs.
F
 
B

elow
 
the
 
front
 
bumper,
 
unscrew
 
t

he 3 wheel
 
arch
 
liner
 
fixing
 
screws.
F

M

ove the wheel arch liner aside to allow
access
 
to
 
the
 
front
 
foglamp.
F
 
D

isconnect
 
the
 
connector
 
from
 
the
 
bulb
 
h

older
 
by
 
pressing
 
on
 
its
 
tab,
 
located
 

at
 
the
 
top. F
 
R

emove   the   bulb   holder   by   squeezing  
the   two   clips   (top   and   bottom)   with   thumb  
a

nd
 f
inger.
F
 
R

eplace   the   module   (bulb   holder   and   bulb).
To
 
reassemble,   carry   out   these   operations   in  
r

everse
 o
rder.
In the event of a breakdown

201
C4-cactus_en_Chap08_En-cas-de-panne_ed01-2016
Direction indicator side
repeaters
F Insert  a   screwdriver   in   the   edge   of   the  r
epeater.
F
 
L
ever   with   the   screwdriver   to   extract   the  
r

epeater   and   pull   it   out.
F
 
D
isconnect   the   wiring   from   the   repeater.
F
 
R
eplace   the   module.
To
  obtain   a   new   module,   contact   a   CITROËN  
d

ealer   or   a   qualified   workshop. To refit, carry out these operations in reverse
o r d e r.While
  removing   the   module:
-  
t
ake   care   not   to   damage   your  v
ehicle's   paintwork   with   the  sc
rewdriver,
-
 
d
o   not   allow   the   wiring   and  
c

onnector   to   slip   behind   the   wing.
If
  you   experience   any   difficulty   in  
r

eplacing   these   lamps,   you   can   contact  
a

  CITROËN   dealer   or   a   qualified  
w

orkshop.
8
In the event of a breakdown

202
C4-cactus_en_Chap08_En-cas-de-panne_ed01-2016
1. Sidelamps (W5W).
2. B rake   lamps   (P21W).
3.
 D

irection   indicators   (PY21W).
4.
 F

oglamp   or   reversing   lamp   (P21W).
Rear lamps
Changing bulbs
To reassemble, carry out these operations in reverse o rder.
F

S
pread the bulb holder retainers and
remove   the   bulb   holder.
F  
R
eplace   the   failed   bulb:
-  
f
or   the   sidelamp,   pull   the   bulb   (the   upper  
o

n e) o u t ,
-  
f
or   the   other   lamps,   turn   the  
c

orresponding   bulb   (lower)   a   quarter  
t

urn.
These
 
bulbs
 
are
 
changed
 
from
 
inside
 
the
 
boot.
F
 
O

pen
 
the
 
boot.
F
 
R

emove
 
the
 
corresponding
 
access
 
cover
 
in
 
t

he
 
trim
 
panel.
F
 
D

isconnect
 
the
 
lamp
 
unit
 
connector
 
a by
pressing
 
the
 
locking
 
button
 
(located
 
under
 
t

he
 
connector
 
for
 
the
 
right
 
hand
 
lamp
 
a

nd above the connector for the left hand
lamp),
F
 S
lacken
 
and
 
remove
 
the
 
nut
 
b ( take care
not to drop it inside the wing ).
F
 
P

ress
 
down
 
on
 
the
 
retaining
 
clip
 
for
 
lamp
 
u

nit c,
 
then
 
carefully
 
remove
 
it
 
towards
 
the
 
o

utside. Take
  care   to   engage   the   lamp   unit   in   its  
g

uides,   while   keeping   it   in   line   with   the  
v

ehicle.
Tighten
  sufficiently   to   ensure   sealing,  
b

ut   without   damaging   the   lamp.
In the event of a breakdown

203
C4-cactus_en_Chap08_En-cas-de-panne_ed01-2016
Third brake lamp (LEDs)Number plate lamps (W5W)
To refit, press on the lens to clip it in place.
F
I
nsert a thin screwdriver into one of the
cutouts   in   the   the   lens.
F  
P
ush   it   outwards   to   unclip   it.
F  
R
emove   the   lens.
F  
C
hange   the   faulty   bulb.
For
 
the
 
replacement
 
of
 
the
 
light-emitting
 
d

iodes (LEDs), contact a CITROËN dealer or a
qualified
 w

orkshop.
8
In the event of a breakdown

204
C4-cactus_en_Chap08_En-cas-de-panne_ed01-2016
F Using  a   small   flat   blade   screwdriver,   unclip  t
he   console   assembly   surrounding   the  
c

ourtesy   lamp.
F
 
R
emove   the   failed   bulb   and   change   it.
F

R
efit the console around the courtesy
lamp,
  ensuring   that   it   is   clipped   in   correctly.
Courtesy lamp
with bulbs (W5W)
Courtesy lamp
with LEDs
For the replacement of the light-emitting diodes (LEDs), contact a CITROËN dealer or a
qualified
 w

orkshop.
Boot (W5W)
F Unclip  the   lamp   by   pushing   the   body   from  b
ehind.
F
 
R
emove   the   bulb   and   change.
F
 
R
efit   the   lamp.
Interior lighting
In the event of a breakdown