Citroen C4 PICASSO DAG 2010.5 1.G Owner's Guide

Page 21 of 355

24
F A M I L I A R I S A T I O N
Ring B Ring D: rear screen wipe Stop.
Intermittent.
Timed wash and wipe. Fixed centred controls steering
wheel
Lighting stalk
Ring A

 94 Stalk C: windscreen wipe

 99
D R I V I N G

1. Off

2. Automatic illumination of headlamps

3. Sidelamps

4. Dipped/main beam headlamps
Front foglamps
Rear foglamp Wiper stalk

1. Optional function controls

2. Cruise control/speed limiter and
parking space sensor

3. Audio system controls

4. Multifunction screen controls

 157

5. Horn

 123

6. Warning lamps for direction indica-
tors and vehicle lamps

 32

 93 Switching on "AUTO" mode

 Press the stalk down and release.
Switching off "AUTO" mode

 Press the stalk up and return it to
position "0" .
The automatic rain sensitive wipers
must be reactivated each time the ve-
hicle is started.
Under certain climatic conditions
(low temperature, humid), the pres-
ence of condensation on the inner
surfaces of the headlamps and rear
lamps is not an indication of a fault;
this disappears a few minutes after
switching on the lamps.

Page 22 of 355

25
F A M I L I A R I S A T I O N

 163
Electric parking brake
Before leaving the vehicle, check that
the electric parking brake warning
lamp P (red) is on fi xed (not fl ashing).
If you leave the vehicle with the en-
gine running, apply the parking brake
manually.
Never leave a child alone inside the
vehicle with the ignition on, as they
could release the parking brake. Parking space sensor
You can activate this function by press-
ing button
A .
Once the space has been measured, the
system displays the following messages:
< 12 mph (20 km/h)

Parking possible

Parking diffi cult

Parking not advised
This device combines:
- automatic functions: Automatic ap-
plication when the engine stops and
automatic release on use of the ac-
celerator (automatic operation by
default);
- manual use: Manual application/ release of parking brake is possible
by operating control lever A .
When in automatic mode, it remains
possible to apply or release the parking
brake at any time:

 To apply it, pull on the lever A .


To release it, pull then release lever A .
Hill start assist
To aid starting on a gradient, your vehicle
is equipped with a system which keeps
it immobilised for about 2 seconds, the
approximate time it takes to move your
foot from the brake pedal to the accel-
erator pedal.

 143
D R I V I N G

 136
Do not drive if the parking brake
warning lamp and the P indicator on
the lever A are on.

Page 23 of 355

26
F A M I L I A R I S A T I O N
6-speed electronic gearbox
system

R Reverse

N Neutral

A Automatic mode

M Manual mode
Using control paddles 1 "+" and 2 "-" :
- gear changing in manual mode,
- temporary manual operation in au- tomatic mode.
P Park

R Reverse

N Neutral

D Automatic mode

M Sequential mode
Using control paddles 1 "+" and 2 "-" :
- gear changing in sequential mode,
- temporary manual operation in auto- matic mode.
Starting

 Check that the lever 3 is in neutral
(position N ).

 Press fi rmly on the brake pedal and
turn the ignition key.

 146 Starting

 Check that the lever 3 is in position

P or N and turn the ignition key.
To exit position P , press on the brake
pedal before moving the selector.

 153
D R I V I N G
Automatic gearbox

Page 24 of 355

27
F A M I L I A R I S A T I O N
D R I V I N G
Stop & Start
Engine going into STOP mode The "ECO" warning lamp comes
on in the instrument panel and
the engine goes into stand-by:
- with the 6-speed electronic gear-
box system ; at speeds below
4 mph (6 km/h), press the brake
pedal or put the gear lever into neu-
tral (position N) .
In certain circumstances the STOP
mode may not be available; the "ECO"
warning lamp fl ashes for a few seconds
then goes off.

 150 The
"ECO" warning lamp goes
off and the engine restarts:
- with the gear lever in position A or M ,
release the brake pedal,
- or with the gear lever in position N and
the brake pedal released, change to
position A or M ,
- or select reverse gear.
In certain condition, START mode may
be invoked automatically; the "ECO"
warning lamp fl ashes then goes off.

 151 Deactivation/Reactivation
You can deactivate the system at any
time by pressing the
"ECO OFF" button;
the button's warning lamp comes on.
The system is reactivated automati-
cally every time you start the engine
with the key. Before refuelling or doing any-
thing under the bonnet, you
must switch off the ignition
with the key.

 151
Going into engine START mode

Page 25 of 355

28
F A M I L I A R I S A T I O N
D R I V I N G
Ignition switch


Page 26 of 355

I
30M O N I T O R I N G
MONOCHROME INSTRUMENT PANEL (WITH MULTIFUNCTION SCR
EEN A)

1. Rev counter

2. Gear shift indicator for a manual
gearbox or gear selector lever and
gear for the electronic gearbox
system or automatic gearbox
3. "Foot on brake" warning lamp for
the electronic gearbox system or
automatic gearbox/Electric parking
brake

4. Speedometer

5. Cruise control or speed limiter
setting
A. Lighting rheostat (available day
and night)

B. Trip mileage recorder reset
Central screen Controls
TWO-TONE INSTRUMENT PANEL (WITH MULTIFUNCTION SCRE
EN C)

6. Fuel gauge

7. Trip mileage recorder

8. Multifunction screen A/C

9. Total mileage recorder
In this zone, the following infor- mation appears in succession
when the ignition is switched on:
- service indicator,
- engine oil level indicator,
- total mileage recorder.

Page 27 of 355

I
31
M O N I T O R I N G
INSTRUMENT PANEL WITH MYWAY OR NAVIDRIVE MULTIFUNCTION SCREEN

1. Cruise control or speed limiter
setting

2. Speedometer

3. MyWay or NaviDrive multifunc-
tion screen
4. Rev counter

5. "Foot on brake" warning lamp for
the electronic gearbox system or
automatic gearbox/Electric park-
ing brake

6. Fuel gauge
A. Lighting rheostat (available day
and night)

B. Trip mileage recorder reset
Central screen Controls

7. Gear shift indicator for a manual
gearbox or selector lever posi-
tion and gear for the electronic
gearbox system or automatic
gearbox

8. Trip mileage recorder

9. Total mileage recorder
In this zone, the following infor- mation appears in succession
when the ignition is switched on:
- service indicator,
- engine oil level indicator,
- total mileage recorder.

10. Warning lamp zone.

Page 28 of 355

I
32M O N I T O R I N G
Indicator and warning lamps
Visual indicators informing the driver that a system is in
operation (operation or deactivation indicator lamps) or of
the occurrence of a fault (warning lamp).
When the ignition is switched on
Certain warning lamps come on for a few seconds when
the vehicle's ignition is switched on.
When the engine is started, these same warning lamps
should switch off.
If they remain on, before moving off, refer to the informa-
tion on the warning lamp concerned.
Associated warnings
The switching on of certain warning lamps may be a
ccompanied
by an audible signal and a message on the multifunc tion screen.
Operation indicator lamps
If one of the following indicator lamps comes on, this confi rms
that the corresponding system has come into operati on.
The warning lamps may come on continuously (fi xed) or fl ash.
Certain warning lamps may come on in two different modes.
Only by relating the type of lighting to the operat ing status of the
vehicle can it be ascertained whether the situation is normal or
whether a fault has occurred.

Warning lamp is on Cause Action/Observations

Left-hand
direction
indicato
r fl ashing with
buzzer. The lighting stalk is pushed down.


Right-hand
direction
indicator fl ashing with
buzzer. The lighting stalk is pushed up.


Sidelamps fi xed. The lighting stalk is in the
"Sidelamps" position.


Dipped beam
headlamps fi xed. The lighting stalk is in the "Dipped
beam headlamps" position.


Main beam
headlamps fi xed. The lighting stalk is pulled towards
you. Pull the stalk to return to dipped
beam headlamps.

Hazard
warning lamps fl ashing with
audible signal. The hazard warning lamps switch,
located on the dashboard, has been
operated. The left-hand and right-hand direction
indicators and their associated indicator
lamps fl ash simultaneously.

Page 29 of 355

I
33
M O N I T O R I N G

Warning lamp is on Cause Action/Observations

Front
foglamps fi xed. The front foglamps are
switched on. Turn the ring on the stalk rearwards twice
to switch off the front foglamps.

Rear
foglamps fi xed. The rear foglamps are
switched on. Turn the ring on the stalk rearwards to
switch off the rear foglamps.

Diesel engine
pre-heating fi xed. The ignition switch is at the
2nd position (ignition on). Wait until the warning lamp has switched off befor
e starting.
The duration for which the warning lamp is on is d etermined
by the climatic conditions.

Parking brake fi xed.
The parking brake is applied
or not properly released. Release the parking brake to switch off the
warning lamp, keeping your foot on the
brake pedal.
Observe the safety recommendations.
For further information on the parking
brake, refer to the "Driving" section.
fl ashing.
The parking brake is not fully
applied or is released.

Parking
space
sensors fi xed.
The parking space sensors
function is active. Press the corresponding button to
deactivate it.
fl ashing. The system is measuring the
space. Once the measurement has been done,
the warning lamp comes on fi xed again.

Electric child
lock temporarily. The electric child lock is
activated. Displayed for a few seconds after activating
the function and every time the ignition is
switched on.
For more information, refer to the "Child
safety" section.

Page 30 of 355

I
34M O N I T O R I N G

Warning lamp is on Cause Action/Observations

Stop & Start fi xed.
The Stop & Start system has
put the engine in STOP mode
at a vehicle stop (traffi c lights,
traffi c jam, or other...). The warning lamp goes off and the engine
restarts automatically in START mode, as
soon as you want to move off.
fl ashes for a few seconds, then goes off. STOP mode is temporarily
unavailable.
or
START mode is invoked
automatically. Refer to "Driving - § Stop & Start" for
special cases with STOP mode and
START mode.

Passenger's
airbag
system fi xed. The control switch, located in
the glove box, is in the "
ON "
position.
The passenger's front airbag
is activated.
In this case, do not install a
rear-facing child seat. Turn the control switch to the "
OFF "
position to deactivate the front passenger's
airbag.
In this case you can install a rear-facing
child seat.
The passenger's airbag system is
automatically put into service on starting
the vehicle (" ON " position).

Page:   < prev 1-10 11-20 21-30 31-40 41-50 51-60 61-70 ... 360 next >