DACIA LODGY 2012 1.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine cigar lighter ........................................... (up to the end of the DU)
ashtrays ................................................ (up to the end of the DU)
accessories socket ............................... (up to the end of the DU)
3.16
ENG_UD24445_1
Cendriers, Allume-cigares, Prise d’accessoires (X92 - Renault)
ENG_NU_975-3_X92_Dacia_3
Ashtrays, Cigarette lighter, Accessories socket
ASHTRAY/CIGARETTE LIGHTER/ACCESSORIES SOCKET
Cigarette lighter or
accessories socket 3
With the ignition on, push in the ciga -
rette lighter 3. It will spring back with a
click when it is ready. Pull it out to use.
After use, replace it without pushing it
all the way in.
1
2
3
6
Ashtray 1
This may be in location 2, 4 or 6.
Lift the cover to open.
To empty, pull the ashtray towards you
and it will be released from its housing.
4
If your vehicle is not fitted with a
cigar lighter and an ashtray, these
can be obtained from an approved
Dealer.
Accessories socket 5
It is provided for connecting acces -
sories approved by our Technical
Department with a maximum power of
120 Watts (12V).
C o n n e c t a c c e s s o r i e s
with a maximum power of
120 Watts only.
Fire hazard.
5

Downloaded from www.Manualslib.com manuals search engine headrest................................................ (up to the end of the DU)
adjusting your driving position .............. (up to the end of the DU)
3.17
ENG_UD28017_3
Appuis-tête arrière (X92 - Renault)
ENG_NU_975-3_X92_Dacia_3
Rear headrests
REAR HEADRESTS (1/2)
Position for using headrest A
Lift the headrest to maximum height,
then lower it until it locks.
To raise the headrest A
Raise the headrest as far as it will go,
then press tab(s) 1 and remove the
headrest.
The headrest is a safety
component. Ensure that it is
fitted and in the correct po-
sition: the top of your head
should be in line with the top of the
headrest.
11
To put the headrest back in
place A
Insert the rods into the holes, press the
tab(s) 1 and lower the headrest.
Headrest A storage
position B
Press tab 1 and lower the headrest fully.
When the headrest is set at the
lowest position , Bthis is for storage
only: it should not be in this position
when a seat is occupied.
AAA
BBB
AA

Downloaded from www.Manualslib.com manuals search engine 3.18
ENG_UD28017_3
Appuis-tête arrière (X92 - Renault)
ENG_NU_975-3_X92_Dacia_3
To adjust the height of the
headrest C
(depending on vehicle)
Press lock tab 2 and simultaneously
slide the headrest to the required po -
sition.
To raise the headrest C
Press lock tab 2 and remove the head -
rest.
To put the headrest back in
place C
Insert the rods into the holes, press lock
tab 2 and lower the headrest.
The headrest is a safety
component. Ensure that it is
fitted and in the correct po-
sition: the top of your head
should be in line with the top of the
headrest.
REAR HEADRESTS (2/2)
C
2

Downloaded from www.Manualslib.com manuals search engine rear bench seat..................................... (up to the end of the DU)
rear seats functions ......................................... (up to the end of the DU)
3.19
ENG_UD26885_2
Sièges arrière de deuxième rangée: fonctionnalité (X92 -\
Renault)
ENG_NU_975-3_X92_Dacia_3
Rear seats:
second row
REAR SEAT FUNCTIONS: second row (1/3)
Fixed rear bench seat
To fold down the seatback
– Bring the front seats forward;
– insert the rear seatbelt buckle in
housing 1;
– Lower door handle 2;
– lower the seatback onto the seat
base;
– adjust the front seats. To reposition the seatback
–
Raise the seatbacks;
– make sure you lock the seat back in
place.
When moving the rear
seats, check that the an -
choring points are clean
(they must be free from grit,
cloths, toys, etc.)
Check that the rear seat
belts are positioned and
operating correctly each
time the rear bench seat is
moved.
For safety reasons, carry
out any adjustments when
the vehicle is not being
driven.
2
1

Downloaded from www.Manualslib.com manuals search engine 3.20
ENG_UD26885_2
Sièges arrière de deuxième rangée: fonctionnalité (X92 -\
Renault)
ENG_NU_975-3_X92_Dacia_3
Jaune NoirNoir texte
Rear bench seat with folding
seat back and seat cushion
To fold down the seat A or bench
seat B
– Bring the front seats forward;
– insert the rear seatbelt buckle in
housing 1;
– lower the headrests (refer to the in-
formation on the “Rear headrests” in
Section 3);
– lower handle 2;
– lower the seatback onto the seat
base;
– raise the seat until vertical;
– adjust the front seats, making sure
they are properly locked in place. To reposition the seat
A or bench
seat B
– Lower the bench seat until it locks in
position;
– Fold the seatbacks up again;
– make sure that the seat bases and
seatbacks lock into position cor -
rectly.When moving the rear
seats, check that the an -
choring points are clean
(they must be free from grit,
cloths, toys, etc.)
Check that the rear seat
belts are positioned and
operating correctly each
time the rear bench seat is
moved.
For safety reasons, carry
out any adjustments when
the vehicle is not being
driven.
2
A
B
REAR SEAT FUNCTIONS: second row (2/3)
A
B
1

Downloaded from www.Manualslib.com manuals search engine JauneNoirNoir texte
3.21
ENG_UD26885_2
Sièges arrière de deuxième rangée: fonctionnalité (X92 -\
Renault)
ENG_NU_975-3_X92_Dacia_3
REAR SEAT FUNCTIONS: second row (3/3)
Accessing the third row rear
seats
– Lower handle 2;
– lower the seatback onto the seat
base;
– raise the seat until vertical.
To put the seat back into its initial po -
sition, perform the same procedure in
reverse.Restriction of use
If a passenger is occupying one of
the second row seats, do not drive
with the other second row seat
folded down.
Make sure that the seat -
back is correctly locked. If
necessary, remove any ob-
stacles behind the seats.
Repeat the above until the seat is
locked correctly.To avoid all risk of injury,
ensure that nobody is close
to the moving parts.
2
When refitting the seat -
back , make sure it is cor -
rectly locked in place.
If seat covers are fitted ,
make sure these do not prevent the
seatback latch from locking in.
Make sure that the seat belts are
positioned correctly.
Reposition the headrests.

Downloaded from www.Manualslib.com manuals search engine rear bench seat..................................... (up to the end of the DU)
rear seats functions ......................................... (up to the end of the DU)
3.22
ENG_UD26888_2
Sièges arrière de troisième rangée: fonctionnalité (X92 \
- Renault)
ENG_NU_975-3_X92_Dacia_3
Jaune NoirNoir texte
third row
REAR SEAT FUNCTIONS: third row (1/3)
The third row rear seats can be folded
down or removed for transporting bulky
objects.To fold down the seats
– Ensure that the rear seat belts are
correctly positioned on the hooks 1;
– lower the headrests (refer to the in-
formation on the “Rear headrests” in
Section 3);
– unlock controls 2, press on the
middle of the seat backs and lower
the seatbacks onto the base;
– pull strap 3 to release the bench seat
and lift the seat base until it is verti-
cal.
For safety reasons, carry
out any adjustments when
the vehicle is not being
driven.
Check that the rear seat
belts are positioned and
operating correctly each
time the rear bench seat is
moved.
1
Ensure that strap 3 is securely fixed
in its ring 4.
Risk of damage.
3
2
3
4

Downloaded from www.Manualslib.com manuals search engine JauneNoirNoir texte
3.23
ENG_UD26888_2
Sièges arrière de troisième rangée: fonctionnalité (X92 \
- Renault)
ENG_NU_975-3_X92_Dacia_3
REAR SEAT FUNCTIONS: third row (2/3)
To reposition the seats
– Ensure that the rear seat belts are
correctly positioned on the hooks 1;
– Lower the seat base until it locks in
position;
– unlock controls 2 and raise the seat
backs using strap 5;
– Make sure that the seat base and
seatbacks lock into position cor -
rectly.
When moving the rear
seats, check that the an -
choring points are clean
(they must be free from grit,
cloths, toys, etc.)
Check that the rear seat
belts are positioned and op-
erating correctly each time
the rear seat is moved.
2
11
No person or animal should
be on the third row rear
seats if the luggage com -
partment cover is not re -
moved.
Restriction of use
If a passenger is one one of the third
row seats, do not drive with one of
the seat backs or a second row seat
folded down.
5

Downloaded from www.Manualslib.com manuals search engine 3.24
ENG_UD26888_2
Sièges arrière de troisième rangée: fonctionnalité (X92 \
- Renault)
ENG_NU_975-3_X92_Dacia_3
To remove the seats
– Ensure that the rear seat belts are
correctly positioned on the hooks 1;
– lower the headrests (refer to the in-
formation on the “Rear headrests” in
Section 3);
– unlock controls 2, press on the
middle of the seat backs and lower
the seatbacks onto the base;
– pull strap 3 to release and lift the
seat base until it is vertical;
– unlock controls 6;
– lift the seats to either remove them
or to group them together with the
second row.
To install seats
– Ensure that the rear seat belts are
correctly positioned on the hooks 1;
– reposition the seats with the roof
hooks 7;
– Lower the seat base until it locks in
position;
– unlock controls 2 and raise the seat
backs using strap 5;
– Make sure that the seat base and
seatbacks lock into position cor -
rectly.
3
3
Ensure that strap 3 is securely fixed
in its ring 4.
Risk of damage.
4
7
6
When moving the rear
seats, check that the an -
choring points are clean
(they must be free from grit,
cloths, toys, etc.)
2
11
REAR SEAT FUNCTIONS: third row (3/3)
5

Downloaded from www.Manualslib.com manuals search engine 3.25
ENG_UD26647_2
Mise en cinéma des sièges arrière (X92 - Renault)
ENG_NU_975-3_X92_Dacia_3
grouping of seats
REAR SEAT FUNCTIONS: Grouping of seats (1/3)
The two rows of the rear seats can be
grouped together to free up a maximum
load surface area at the rear of the ve-
hicle.
For more information, see the following
pages.
For safety reasons, carry
out any adjustments when
the vehicle is stationary.
The third row bench seat
is quite heavy. For your own safety,
please handle it carefully