FORD MUSTANG 1996 4.G Owners Manual

277 [SV36174(M )10/95]
NOTE: Brake fluid and power steering fluid
CAN NOT be mixed. Only add brake
fluid to the brake master cylinder
reservoir. Only add power steering
fluid to the power steering reservoir.
[SV36179(M )10/95]
3. Visually verify that the fluid level is above
the MIN line adjacent to the reservoir ªsight
window.º
[SV36183(M )10/95]
4. If the power steering fluid is below the MIN
line, remove the cap and add fluid in small
amounts until the level is between the MIN
and MAX lines.
[SV36186(M )10/95]
5. Reinstall the reservoir cap.
[SV36188(M)02/96]
It is normal for the fluid level to be above the
MAX line after the brake pedal has been pushed
several times with the engine off. (If you want
to double check it; restart the engine and turn
steering wheel to full right turn, the full left turn
and then turn engine off and re-check fluid
level. It should be between the MIN and MAX
line.)
File:15rcsvm.ex
Update:Thu Mar 28 14:48:54 1996

278 [SV36195(M )10/95]
half page art:0011388-AFluid level for power steering
[SV36225(M )03/95]
Use only power steering fluid that meets Ford
Specification MerconHATF XT-2-QDX.
*
[SV36250(MBC )03/95]
NOTE: If the power steering fluid is low, do
not drive your vehicle for a long
period of time before adding fluid.
This can damage the power steering
pump.
% [SV36300(MBC )12/94]Fuses, High Current Fuses and
Circuit Breakers
*
[SV36400( ALL)03/95]
Fuses (conventional and high current) and circuit
breakers protect your vehicle's wiring system
from overloading. If electrical parts in your
vehicle are not working, the system may have
been overloaded and blown a fuse or tripped a
circuit breaker. Before you replace or repair any
electrical parts, check the appropriate fuses
(conventional and high current) or circuit
breakers.
File:15rcsvm.ex
Update:Thu Mar 28 14:48:54 1996

279
*
[SV36600( ALL)03/95]
The following charts tell you which fuses or
circuit breakers protect the wiring for each
electrical part of your vehicle. If a fuse blows or
a circuit breaker opens a circuit,allthe parts of
your vehicle that use that circuit will not work.
*
[SV36610( ALL)01/95]
Once you have determined which fuses or circuit
breakers to check, follow the procedures under
Checking and replacing fusesorChecking and
replacing circuit breakersin this chapter.
[SV36700(M )03/93]
half page art:0011154-A
The instrument panel fuse panel location
File:15rcsvm.ex
Update:Thu Mar 28 14:48:54 1996

280 [SV37200(M )06/93]
half page art:0011172-AThe instrument panel fuse panel
File:15rcsvm.ex
Update:Thu Mar 28 14:48:54 1996

281 %
*
[SV37500( ALL)02/95]
The Instrument Panel Fuses, Circuit
Breakers and Relays
[SV37600(M )06/93]
thirty-four pica chart:0010389-GFile:15rcsvm.ex
Update:Thu Mar 28 14:48:54 1996

282 [SV37700(M )10/95]
twenty-four pica chart:0010492-G
%*
[SV39000( ALL)01/95]
High Current Fuses
*
[SV39200( ALL)01/95]
High current fuses are circuit protectors that are
part of the wiring harness for some electrical
equipment. These, like fuses, open when the
circuit load exceeds their amperage rating. High
current fuses may be purchased from your Ford
or Lincoln-Mercury dealer.
*
[SV39300(MBC )01/95]
The high current fuse panel is located in the
engine compartment on the left-hand fender
apron.
File:15rcsvm.ex
Update:Thu Mar 28 14:48:54 1996

283
*
[SV39600( ALL)05/95]
RWARNING
Always disconnect the battery before
servicing high current fuses.
*
[SV39700( ALL)07/95]
Ford recommends that high current fuses be
replaced by a qualified technician.
[SV39800(M )08/93]
one third page art:0011156-B
The high current fuse panel location
File:15rcsvm.ex
Update:Thu Mar 28 14:48:54 1996

284 % [SV40100( ALL)06/93]The high current fuse panel
[SV40300(M )10/95]
two third page art:0011159-CFile:15rcsvm.ex
Update:Thu Mar 28 14:48:54 1996

285 [SV40600( ALL)06/93]
The high current fuses and relays
[SV40800(M )05/95]
thirty-two pica chart:0011160-BFile:15rcsvm.ex
Update:Thu Mar 28 14:48:54 1996

286 [SV40900(M )10/95]
thirty-six pica chart:0011161-C
File:15rcsvm.ex
Update:Thu Mar 28 14:48:54 1996