Hyundai Creta 2016 Owner's Manual

3-77
Convenient features of your vehicle
Battery saver function
The purpose of this feature is to pre
vent the battery from being dis
charged. The system automatically
turns off the parking lights when the
driver removes the ignition key or
turns the engine off (for smart key)
and opens the driverside door.
With this feature, the parking lights
will turn off automatically if the driver
parks on the side of road at night.
If necessary, to keep the lights on
when the ignition key is removed or
the engine is turned off (for smart
key), perform the following:
1) Open the driverside door.
2) Turn the parking lights OFF andON again using the light switch on
the steering column.
Headlamp delay function
(if equipped)
If the key is removed from the ignition
switch or placed in the ACC or
LOCK/OFF position with the head
lights ON, the headlights (and/or
parking lights) remain on for about 5
minutes. However, with the engine off
if the driver’s door is opened and
closed, the headlights (and/or parking
lights) are turned off after 15 seconds.
The headlights (and/or parking
lights) can be turned off by pressing
the lock button on the remote key (or
smart key) twice or turning the light
switch to the OFF or AUTO position.
However, if you turn the light switch
to the AUTO position when it is dark
outside, the headlights will not be
turned off.If the driver gets out of the vehicle
through other doors (except driver's
door), the battery saver function
does not operate and the headlamp
delay function does not turn off auto
matically. Therefore, It causes the
battery to be discharged. In this
case, make sure to turn off the lamp
before getting out of the vehicle.
NOTICE

3-78
Convenient features of your vehicle
3
Daytime running light (DRL)
(if equipped)
The Daytime Running Lights (DRL)
can make it easier for others to see
the front of your vehicle during the
day, especially after dawn and beforesunset.
The DRL system will turn the dedi
cated lamp OFF when:
1. The headlights or front fog lightsare in the ON position.
2. The engine is turned off.
Headlamp leveling device
To adjust the headlamp beam level
according to the number of the pas
sengers and loading weight in the
luggage area, turn the beam leveling
switch. The higher the number of the switch
position, the lower the headlamp
beam level. Always keep the head
lamp beam at the proper leveling
position, or headlights may dazzle
other road users.
Listed below are the examples of
proper switch settings. For loading
conditions other than those listed
below, adjust the switch position so
that the beam level may be the near
est as the condition obtained accord
ing to the list.
OGS045064L
Loading conditionSwitch position
Driver only 0
Driver + Front passenger 0
Full passengers
(including driver) 1
Full passengers (including
driver) + Maximum permis
sible loading 2
Driver + Maximum permis
sible loading 3

3-79
Convenient features of your vehicle
Interior lights
Do not use the interior lights for
extended periods when the engine is
turned off or the battery will dis
charge.
Interior lamp AUTO cut
The interior lamps will automatically
go off approximately 20 minutes after
the engine is turned off and the
doors closed. If a door is opened, the
lamp will go off 40 minutes after the
engine is turned off. If the doors are
locked by the remote key or smart
key and the vehicle enters the armed
stage of the theft alarm system, the
lamps will go off five seconds later.
Front lamps
(1) Front Map Lamp
(2) Front Room Lamp
Front Map Lamp:
Press either the right or left lens to
turn the map lamp on or off. This light
produces a spot beam for convenient
use as a map lamp at night or as a
personal lamp for the driver and the
front passenger.
Front Room Lamp:
The Front Room Lamp Switch acti
vates the front and rear room lamps
when the switch is pressed in either of
the three positions indicated below:
: The front or rear room lampscome on when the front or rear
doors are opened if the engine
is running or not. When doors
are unlocked by the remote
key or smart key, the front and
rear lamps come on for
approximately 15 seconds as
long as any door is not
opened. The front and rear
room lamps go out gradually
after approximately 15 sec
onds if the door is closed.
However, if the ignition switch
is in the ON position or all
doors are locked, the front and
rear lamps will turn off immedi
ately. If a door is opened with
the ignition switch in the ACC
position or the LOCK/OFF
position, the front and rear
lamps stay on for about 20
minutes. However, if a door is
opened with the ignition switch
in the ON position, the lamps
stays on continuously.
NOTICE
OIB044015/Q
Do not use the interior lights when
driving in the dark. The interior
lights may obscure your view and
cause an accident.
WARNING

3-80
Convenient features of your vehicle
3
: With the Front Room Lamp in
this position, the front and
rear room lamps remain on
at all times.
: With the Front Room Lamp in this position the front and
rear room lamps remain off
at all times.
Information
When the map lamp (1) is turned ON
by pressing the lens, the map lamp
will not turn off even if the front room
lamp switch is in the OFF position.
Room lamp
Rear Door Lamp Switch:
Press this switch to turn the room
lamp on and off.
Do not leave the lamp switches on for
an extended period of time when the
engine is turned off.
Luggage room lamp
The luggage room lamp comes on
when the tailgate is opened.
The luggage room lamp comes on
as long as the tailgate is open. To
prevent unnecessary charging sys
tem drain, close the tailgate securely
after using the luggage room.
i
NOTICE
NOTICE
OIB044016OGC044055

3-81
Convenient features of your vehicle
WiPERS AND WAShERS

Front (for Lefthand drive)
Rear (for Lefthand drive)
A : Wiper speed control (front)• / MIST – Single wipe
• O / OFF – Off
• / INT – Intermittent wipe
• AUTO* – Auto control wipe
• 1 / LO– Low wiper speed
• 2 / HI – High wiper speed
B : Intermittent control wipe time adjustment
C : Wash with brief wipes (front)
D : Rear wiper control* • 2 / HI – High wiper speed
• 1 / LO – Low wiper speed
• O / OFF – Off
E : Wash with brief wipes (rear)
* : if equipped
OGS045065L/OGS045066L/OGS045067/OGS045068L/OGS045069L/OGS045070
• Type B
• Type A
• Type B
• Type A

Front (for Righthand drive)
Rear (for Righthand drive)

3-82
Convenient features of your vehicle
3
Windshield wipers
Operates as follows when the igni
tion switch is in the ON position.
MIST : For a single wiping cycle,move the lever to or MIST
position and release. The
wipers will operate continu
ously if the lever is held in thisposition.
OFF : Wiper is not in operation.
INT : Wiper operates intermittently at the same wiping intervals. To
vary the speed setting, move
the speed control lever.
Information
If there is heavy accumulation of snow
or ice on the windshield, defrost the
windshield for about 10 minutes, or
until the snow and/or ice is removed
before using the windshield wipers to
ensure proper operation.
If you do not remove the snow and/or
ice before using the wiper and washer,
it may damage the Wiper and washersystem.
Windshield washers
(if equipped)
In the OFF position, pull the lever
gently toward you to spray washer
fluid on the windshield and to run the
wipers 13 cycles. Use this function
when the windshield is dirty. The
spray and wiper operation will contin
ue until you release the lever. If the washer does not work, check
the washer fluid level. If the fluid level
is not sufficient, you will need to add
appropriate nonabrasive windshield
washer fluid to the washer reservoir.
The reservoir filler neck is located in
the front of the engine compartment
on the passenger side.
i
When the outside temperature is
below freezing, ALWAYS warm the
windshield using the defroster to
prevent the washer fluid from freez
ing on the windshield and obscur
ing your vision which could result in
an accident and serious injury or
death.
WARNING
OGS045071L
OGS045072L


Type A

Type B

3-83
Convenient features of your vehicle
•To prevent possible damage to the
washer pump, do not operate the
washer when the fluid reservoir is
empty.
•To prevent possible damage to the
wipers or windshield, do not oper
ate the wipers when the windshield
is dry.
•To prevent damage to the wiper
arms and other components, do
not attempt to move the wipers
manually.
•To prevent possible damage to the
wipers and washer system, use anti
freezing washer fluids in the winter
season or cold weather.
Rear window wiper and washer
switch (if equipped)
The rear window wiper and washer
switch is located at the end of the
wiper and washer switch lever. Turn
the switch to the desired position to
operate the rear wiper and washer.
HI – High wiper speed
LO – Low wiper speed
OFF – OffPush the lever away from you to
spray rear washer fluid and to run the
rear wipers 1~3 cycles. The spray
and wiper operation will continue until
you release the lever. (if equipped)
NOTICE
OGS045073L
OGS045074L


Type A

Type B
OGS045075L
OGS045076L

Type A

Type B

3-84
Convenient features of your vehicle
3
Rear view camera (if equipped)
The Rear View Camera will activate
when the engine is running and the
shift lever is in the R (Reverse) position.Whenever the vehicle ignition is
cycled off and on, the rear view cam
era will turn on when the shift lever is
put into R (Reverse).
Always keep the camera lens clean.
The camera may not work normally if
the lens is covered with dirt or snow.
NOTICE
DRiVER ASSiSt SYStEM
•Never rely solely on the Rear
View Camera when backing up.
•ALWAYS look around your vehi
cle to make sure there are no
objects or obstacles before mov
ing the vehicle in any direction to
prevent a collision.
•Always pay close attention when
the vehicle is driven close to
objects, particularly pedestrians,
and especially children.
WARNING
OGS055009L
OGC044058

3-85
Convenient features of your vehicle
Rear parking assist system
(if equipped)
The Rear Parking Assist System
aids the driver during reverse move
ment of the vehicle by chiming if any
object is sensed within the distance
of about 120 cm (47 in.) behind the
vehicle. This is a supplemental system that
senses objects within the range and
location of the sensors, it cannot
detect objects in other areas where
sensors are not installed.
Operation of the rear parking
assist system
Operation condition
• This system will activate when
backing up with the engine running.
• Sensing distance when backing up is approximately 120 cm (47 in.)
when you are driving less than 10
km/h (6 mph).
• When more than two objects are sensed at the same time, the clos
est one will be recognized first.
•ALWAYS look around your vehi
cle to make sure there are no
objects or obstacles before mov
ing the vehicle in any direction to
prevent a collision.
•Always pay close attention when
the vehicle is driven close to
objects, particularly pedestrians,
and especially children.
•Be aware that some objects
may not be detected by the sen
sors, due to the objects dis
tance, size or material, all of
which can limit the effectiveness
of the sensor.
WARNING
OGC044059Sensors

3-86
Convenient features of your vehicle
3
Types of warning indicator and sound
•If an object is in between sensors
or close to a sensor, the displayed
indicator may differ from the above
illustration.
•Do not wash the vehicle's sensor
with high pressure water.
•When you shift into the R
(Reverse) position and one or
more of the below situation occurs,
this may indicate a malfunction
with the parking assist system.
•You don't hear an audible warning
sound or the buzzer sounds inter
mittently.
If this occurs, we recommend that
the system be checked by an
authorized HYUNDAI dealer.
Nonoperational conditions of rear
parking assist system
The rear parking assist system may
not operate normally when:
• Moisture is frozen to the sensor.
• The sensor is covered with dirt or debris such as snow or ice, or the
sensor cover is blocked.
There is a possibility of a parking
assist system malfunction when:
• Driving on uneven road surfaces such as unpaved roads, gravel,
bumps, or gradient.
• Objects generating excessive noise such as vehicle horns, loud motor
cycle engines, or truck air brakes
can interfere with the sensor.
• Heavy rain or water spray is present.
• Wireless transmitters or mobile phones are present near the sensor.
• The sensor is covered with snow.
• Any nonfactory equipment or acces sories have been installed, or if the
vehicle bumper height or sensor
installation has been modified.
NOTICE
Distance fromobjectWarningindicatorWarning sound
120cm ~ 61cm
(47 in. ~ 24 in.)Buzzer beepsintermittently.
60cm ~ 31cm
(24 in. ~ 12 in.)Buzzer beeps
more frequently.
Less than
30 cm (12 in.)Buzzer beeps continuously.
(blinks)
•is displayed. (if equipped)