Hyundai Elantra 2006 Owner's Manual

7EMISSION CONTROL SYSTEMS
4EGR SYSTEM
H020C01S-GAT ; For a diesel engine This system helps control oxides of nitrogen by recirculating a part of the exhaust gas into the engine.

Vehicle Identification Number (VIN) ............................ 8-2
Engine Number ............................................................ 8-2
Recommended Inflation Pressures ............................. 8-3
Snow Tires ................................................................... 8-4
Tire Chains ................................................................... 8-4
Tire Rotation ................................................................ 8-5
Tire Balancing .............................................................. 8-5
Tire Traction ................................................................. 8-5
When to Replace Tires ................................................ 8-5
Spare Tire and Tools ................................................... 8-6
8
CONSUMER INFORMATION
8

8CONSUMER INFORMATION
2VEHICLE IDENTIFICATION NUMBER (VIN)
I010B01A-GAT Engine Number
I010A02A-GAT The vehicle identification number (VIN) is the number used in register- ing your car and in all legal matterspertaining to its ownership, etc.It can be found on the identificationplate attached to the engine side of the firewall between the engine and driver compartment. The engine number is stamped on
the engine block as shown in the drawing.
HXDFL010-1
SSA8010B I010B02E
Gasoline engine
(1.6 DOHC)
Gasoline engine (1.8/2.0 DOHC)
I010B01B
Diesel engine

8
CONSUMER INFORMATION
3TIRE
I020A01A-AAT
TIRE INFORMATION
The tires supplied on your new
Hyundai are chosen to provide the best performance for normal driving.
I030A03E-GAT RECOMMENDED INFLATION PRESSURES
The tire label located on the driver's
side center pillar outer panel gives the tire pressures recommended for your vehicle. 5.5Jx15 5.5Jx15
TIRE SIZE
RIM
SIZE PRESSURE, kPa (PSI)
185/65R15195/60R15 REAR
210(30)210(30) FRONT230(33)230(33)
NORMAL LOAD MAXIMUM LOAD
REAR
230(33)230(33)
FRONT
210(30)210(30)
These pressures were chosen to pro- vide the most satisfactory combina-tion of ride comfort, tire wear and stability under normal conditions. Tire pressures should be checked at leastmonthly. Proper tire inflation pres- sures should be maintained for these reasons:
o Lower-than-recommended tire pressures cause uneven tread wear and poor handling.
o Higher-than-recommended tire pressures increase the chance ofdamage from impacts and causeuneven tread wear.
I030A01E

8CONSUMER INFORMATION
4
!
I050A02E-GAT TIRE CHAINS Tire chains, if necessary should be installed on the front wheels. Be sure that the chains are installed in accor- dance with the manufacturer's instruc-tions.To minimize tire and chain wear, donot continue to use tire chains when they are no longer needed.
WARNING:
o When driving on roads covered with snow or ice, drive at less than 30 km/h (20 mph).
o Use the SAE "S" class or wire &
plastic chains.
o If you have noise caused by chains contacting the body, re-tighten the chain to avoid con- tact with the vehicle body.
o To prevent body damage, re- tighten the chains after driving0.5 ~ 1 km.
I040A01S-GAT SNOW TIRES If you equip your car with snow tires, they should be the same size and have the same load capacity as the original tires. Snow tires should beinstalled on all four wheels; other- wise, poor handling may result. Snow tires should carry 28 kPa (4 psi) more air pressure than the pres- sure recommended for the standardtires on the tire label on, or up to the maximum pressure shown on the tire sidewall whichever is less. Do not drive faster than 120 km/h (75 mph) when your car is equipped with snow tires.
CAUTION:
Always observe the following:
o Check pressures when the tires are cold. That is, after the car has been parked for at least three hours and hasn't been drivenmore than 1.6 km or one mile since starting up.
o Check the pressure of your spare tire each time you check the pressure of other tires.
!

8
CONSUMER INFORMATION
5
!
I060A01A-GAT TIRE ROTATION
Tires should be rotated every 10,000
km (6,000 miles). If you notice that tires are wearing unevenly between rotations, have the car checked by aHyundai dealer so the cause may be corrected.
After rotating, adjust the tire pres-
sures and be sure to check wheel nut torque. HA1409
Spare tire
WARNING:
Do not mix bias-ply and radial-ply tires under any circumstances. This may cause dangerous handlingcharacteristics. I070A01A-AAT
TIRE BALANCING
A tire that is out of balance may affect
handling and tire wear. The tires on your Hyundai were balanced before the car was delivered but may needbalancing again during the years you own the car.
Whenever a tire is dismounted for
repair, it should be rebalanced before being reinstalled on the car. I080A01A-AAT TIRE TRACTION Tire traction can be reduced if you drive on worn tires, tires that areimproperly inflated or on slippery road surfaces. Tires should be replaced when tread wear indicators appear.To reduce the possibility of losing control, slow down whenever there is rain, snow or ice on the road.
I090A01HP-GAT WHEN TO REPLACE TIRES
Wear indicator
1.6 mm (0.06 in.)
HXDFL248
The original tires on your car have tread wear indicators. The tread wear indicators appear when the tread depth is 1.6 mm (0.06 in.). The tireshould be replaced when these ap- pear as a solid bar across two or more grooves of the tread. Alwaysreplace your tires with those of the recommended size. If you change wheels, the new wheel's rim widthand offset must meet Hyundai speci- fication.

8CONSUMER INFORMATION
6
!
SPARE TIRE AND TOOLS
I100A01FC-GAT Your Hyundai is delivered with the following: Spare tire and wheel Wheel nut wrench, Wrench bar, Span- ner, Screw driver Jack
WARNING:
o Driving on worn-out tires is dan- gerous! Worn-out tires can cause loss of braking effectiveness,steering control and traction. When replacing tires, never mix radial and bias-ply tires on thesame car. If you replace radial tires with bias-ply tires, they must be installed in sets of four.
o Your vehicle is equipped with tires designed to provide for saferide and handling capability.Do not use a size and type of tireand wheel that is different from the one that is originally installed on your vehicle. It can affect thesafety and performance of your vehicle, which could lead to han- dling failure or rollover and seri-ous injury. HXD091-1
When replacing the tires, be sure to equip all four tires with the tireand wheel of the same size, type, tread, brand and load-carrying ca- pacity. If you nevertheless decideto equip your vehicle with any tire/wheel combination not rec- ommended by Hyundai for off-road driving, you should not use these tires for highway driving.

Measurement................................................................ 9-2
Engine ........................................................................... 9-3
Lubrication Chart .......................................................... 9-4
9
VEHICLE SPECIFICATIONS
9

9 VEHICLE SPECIFICATIONS
2
J010A02E-GAT MEASUREMENT
1425 (56.1)
2610 (102.8)
1485 (58.5) 1475 (58.1)
Overall lengthOverall width Overall height (unladen)Wheel base Wheel tread
Front
Rear
Type Wheel free playRack stroke Oil pump type Rack and pinion0 ~ 30 mm (0 ~ 1.18 in.) 144 mm (5.67 in.)Vane type
J060A01S-GAT FUEL SYSTEM
J020A01E-GATPOWER STEERING J030A02E-GATTIRE
Size
185/65 R15 195/60 R15
Tire Standard Option
J050A01E-AAT BRAKE Dual hydraulic with brake booster Ventilated disc Solid disc (With ABS) Drum (Without ABS)Cable
TypeFront brake type Rear brake type Parking brake
Item Battery Generator
J040A03E-GAT ELECTRICAL
GASOLINE
MF45AH, MF60AH(12V) 90A (13.5V)
mm (in.)
Fuel tank capacityLiter
55 US.gal
14.5 Imp.gal
12
DIESEL
CMF 80 AH 120A (12V)
4 Door
4525 (178.1)
1725 (67.9) 5 Door
4520 (177.9)
1720 (67.7)Pressure210 (30) 210 (30)
Kpa(psi)

9
VEHICLE SPECIFICATIONS
3ENGINE
J070A06E-GAT
NGK CHAMPION NGKCHAMPION
Unleaded Leaded Unleaded Leaded For adjusting For checking
Engine Type Idle Speed (RPM) Spark Plug Spark Plug Gap Valve Clearance (Cold engine : 20±5°C) Ignition Timing Firing Order
ITEMS
A/CON OFF A/CON ON
DIESEL
2.0 4Cylinder in-line SOHC 750 ± 100800 ± 100
--- - --
AUTO LASH
(1.6 DOHC / Diesel) AUTO LASH
(1.6 DOHC / Diesel) -
GASOLINE
1.6/1.8/2.0 4Cylinder in-line DOHC
700 ± 100 (1.6L), 700 ± 100 (1.8/2.0 L) 750 ± 100 (1.6L), 750 ± 100 (1.8/2.0 L) BKR5ES-11
RC10YC4BKR5ES
RC10YC
1.0 ~ 1.1 mm (0.039 ~ 0.043 in.)0.7 ~ 0.8 mm (0.028 ~ 0.032 in.)
0.17 ~ 0.23 mm (0.0067 ~ 0.0091 in.) (1.8/2.0 DOHC)0.25 ~ 0.31 mm (0.0098 ~ 0.0122 in.) (1.8/2.0 DOHC)
0.12 ~ 0.28 mm (0.0047 ~ 0.011 in.) (1.8/2.0 DOHC)0.20 ~ 0.38 mm (0.0079 ~ 0.015 in.) (1.8/2.0 DOHC)
BTDC 9° ± 5° (1.6L), BTDC 6° ± 5° (1.8L), BTDC 8° ± 5° (2.0L) 1 - 3 - 4 - 2
IntakeExhaustIntake Exhaust