ISUZU KB P190 2007 Workshop Owner's Guide
Page 31 of 6020
MAINTENANCE AND LUBRICATION 0B-13
RECOMMENDED FLUIDS AND LUBRICANTS (For EUROPE)
In order to obtain maximum performance and longest service life from your ISUZU vehicles, it is very important to
select and use correctly the best lubricants and diesel fuels.
W hen lubricating, be sure to use ISUZU genuine lubricants or recommended lubricants listed below, according to
the maintenance schedule for each vehicle model.
LUBRICATION/FLUID GRADE
API ACEA OTHER
Diesel engine crankcase B2/B3
E2/E3
Manual transmission
Transfer case B2/B3
E2/E3
Differential
Shift on the fly system
(GL-5 only)
GL-5
BESCO GEAR OIL SH (80W-90, 90, 140) (ISUZU GENUINE)
BESCO SHIFT ON THE FLY (75W-90) (ISUZU GENUINE)
THURBAN GL-5 EP (80W-90, 85W-140) (CALTEX)
SPIRAX A (140) (SHELL)
TRANSELF TYPE B (80W-90, 85W-140) (ELF)
TRANSMISSION TM (80W-90, 85W-140) (TOTAL)
EPX90 (90)(CASTROL)
DYNA DRIVE (80W-90) (CASTROL)
ENERGEAR HYPO (90) (BP)
ENERGEAR EP (80W-90) (BP)
Differential
(Limited Slip Differential)
(GL-5 only) GL-5
BESCO GEAR OIL LSD (140) (ISUZU GENUINE)
GEAR OIL LSD (90) (CALTEX)
SPIRAX A LS 90 (90) (SHELL)
TRANSELF TYPE BLS (90) (ELF)
TRANSMISSION DA (85W-90) (TOTAL)
HYPOY LSX (90) (CASTROL)
ENERGEAR LS-M (90) (BP)
Automatic transmission MOBIL ATF 3309
Power steering
DEXRON III
Propeller shaft sliding yoke
Universal joint
(General purpose grease in
Molybdenum) NLGI #2 or #3
multi purpose type grease
containing molybdenum disulfide
Engine cooling system Good quality ethylene glycol antifreeze or GM spec.
6033-M or equivalent
NOTE:
* If GL-5 Limited Slip Differential Lubricant is not available, use GL-5 Lubricant mixed with 1 bottle (118ml) of Limited
Slip Differential Lubricant additive (Parts No. 8-01052-358-0) or equivalent.
FLUID TYPE
Clutch and brake fluid reservoir Besco brake fluid (For light duty)
Hydraulic brake fluid SAE J1703
FMVSS 116 DOT.3 grade
DIESEL FUEL/APPLICABLE STANDARD
JIS (JAPANESE INDUSTRIAL STANDARD)
DIN (DEUTSCHE INDUSTRIE NORMEN)
SAE (SOCIETY OF AUTOMOTIVE ENGINEERS)
BS (BRITISH STANDARD) Based on K2204 GAS OIL
Based on EN590: 1997L
Based on SAE J-313C
Based on BS EN590: 1997
NOTE:
Use the applicable standard or equivalent for diesel fuels.
BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007
Page 32 of 6020
0B-14 MAINTENANCE AND LUBRICATION
OIL VISCOSITY CHART
Lubricants should be carefully selected according to the lubrication chart. It is also important to select the viscosity
of lubricants according to the ambient temperature by referring to the following table.
OIL VISCOSITY CHART FOR DIESEL ENGINE
APPLY DIESEL ENGINE OIL
RTA7Z0SF000101
BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007
Page 33 of 6020
MAINTENANCE AND LUBRICATION 0B-15
OIL VISCOSITY CHART FOR GASOLINE ENGINE APPLY GASOLINE ENGINE OIL
C24SE
(Multi grade)
HFV6
BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007
Page 34 of 6020
0B-16 MAINTENANCE AND LUBRICATION
OIL VISCOSITY CHART FOR TRANSMISSION CASE
OIL VISCOSITY CHART FOR FRONT AXLE AND REAR AXLE
BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007
Page 35 of 6020
HEATER AND AIR CONDITIONING 1-1
SECTION 1
HEATER AND AIR CONDITIONING
TABLE OF CONTENTS
PAGE
General Description ........................................................................................................ 1- 3
Main Data and Specifications ......................................................................................... 1- 21
Special Parts Fixing Nuts and Bolts .............................................................................. 1- 23
On-Vehicle Service .......................................................................................................... 1- 30
Precautions For Replacement or repair of air conditioning parts .......................... 1- 30
Condenser...................................................................................................................... .. 1- 40
Removal and Installation (4JH1-TC, 4JJ1-TC Standard Output)............................. 1- 40
Removal and Installation (4JJ1-TC High Output, 4JK1-TC High Output, 4JA1-T) ........................................ 1- 41
Removal and Installation (C24SE) ............................................................................. 1- 42
Condenser Fan Motor ..................................................................................................... 1- 43 Removal and Installation............................................................................................ 1- 43
Receiver/drier ................................................................................................................. . 1- 44
Removal and Installation............................................................................................ 1- 44
Compressor ..................................................................................................................... 1- 45
Removal and Installation (4JA1-T, 4JH1-TC) ............................................................ 1- 45
Removal and Installation (4JJ1-TC Standard Output, 4JJ1-TC High Output, 4JK1-TC High Output) ......... 1- 47
Removal and Installation (C24SE) ............................................................................. 1- 49
Disassembly ................................................................................................................ 1- 55
Reassembly ................................................................................................................. 1- 57
Heater Unit .................................................................................................................... ... 1- 59
Removal and Installation............................................................................................ 1- 59
Disassembly and Reassembly................................................................................... 1- 61
Vent Unit (Without Heater) ............................................................................................. 1- 62 Removal and Installation............................................................................................ 1- 62
Disassembly and Reassembly................................................................................... 1- 64
TO MODEL INDEX
BACK TO MAIN INDEX
ISUZU KB P190 2007
Page 36 of 6020
1-2 HEATER AND AIR CONDITIONING
PAGE
Evaporator (With A/C) ..................................................................................................... 1- 6 5
Removal and Installation............................................................................................ 1- 65
Disassembly and Reassembly................................................................................... 1- 66
Duct (Without A/C) ........................................................................................................... 1 - 68
Removal and Installation............................................................................................ 1- 68
Disassembly and Reassembly................................................................................... 1- 69
Blower Unit Assembly..................................................................................................... 1- 70
Removal and Installation............................................................................................ 1- 70
Disassembly and Reassembly................................................................................... 1- 72
Defroster Nozzle and Vent Duct ..................................................................................... 1- 73 Removal and Installation............................................................................................ 1- 73
Rear Heater Duct ............................................................................................................. 1 - 74
Removal and Installation............................................................................................ 1- 74
Control Lever Assembly ................................................................................................. 1- 75 Removal and Installation............................................................................................ 1- 75
Control Panel Illumination Bulb ..................................................................................... 1- 79 Removal and Installation............................................................................................ 1- 79
Inspection and Repair ................................................................................................ 1- 81
Troubleshooting .............................................................................................................. 1 - 85
Special Service Tool........................................................................................................ 1- 119
BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007
Page 37 of 6020
HEATER AND AIR CONDITIONING 1-3
GENERAL DESCRIPTION
COOLING SYSTEM
1.
Compressor 8.
Evaporator core
2.
Magnetic clutch 9.
Blower motor
3.
Receiver/Drier 10.
Heater unit
4.
Triple pressure switch 11.
Mode (DEF/FOOT) control door
5.
Condenser 12.
Mode (VENT) control door
6.
Evaporator assembly 13.
Electronic thermostat
7.
Expansion valve 14.
Heater core
RTW 610LF000101
BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007
Page 38 of 6020
1-4 HEATER AND AIR CONDITIONING
COMPONENTS (CHASSIS SIDE)
(4JA1-T RHD MODEL)
RTW 710LF001901
BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007
Page 39 of 6020
HEATER AND AIR CONDITIONING 1-5
(4JJ1-TC Standard Output, 4JJ1-TC High Output, 4JK1-TC High Output RHD MODEL)
RTW 710LF002001
BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007
Page 40 of 6020
1-6 HEATER AND AIR CONDITIONING
(C24SE RHD MODEL)
RTW 710LF002101
BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007