ISUZU TF SERIES 2004 Workshop Manual
Page 801 of 4264
ELECTRICAL-BODY AND CHASSIS 8A-143
RTW48ASH000401
Inspection
Check to see if there is any continuity between the terminals of
the front fog light switch.
Replace the switch when the result of inspection is found
abnormal.
Removal
Preparation:
Disconnect the battery ground cable.
1. Ventilation grille
2. Harness connector
3. Front fog light & Rear fog light switch
To remove the switch, push the lock from the back side of
the cluster assembly.
4. Remove the bulb.
RTW48ASH000301
Installation
To install, follow the removal steps in the reverse noting the
following point.
1. Push in the switch with your fingers until it locks securely.
Page 802 of 4264
8A-144 ELECTRICAL-BODY AND CHASSIS
REAR FOG LIGHT
PARTS LOCATION (RHD)
RTW48AXF015401 & RTW48AXF015501
Page 803 of 4264
ELECTRICAL-BODY AND CHASSIS 8A-145
PARTS LOCATION (LHD)
RTW48AXF015601 & RTW48AXF015701
Page 804 of 4264
8A-146 ELECTRICAL-BODY AND CHASSIS
CIRCUIT DIAGRAM (RHD)
RTW48AXF008201
Page 805 of 4264
ELECTRICAL-BODY AND CHASSIS 8A-147
CIRCUIT DIAGRAM (LHD)
RTW48AXF008101
Page 806 of 4264
8A-148 ELECTRICAL-BODY AND CHASSIS
RTW48ASH000701
REAR FOG LIGHT
Removal
1. Remove the screws 1.
2. Remove the lens cover
2.
3. Rear fog push turn the bulb
3 counterclockwise to
disconnect it from the light housing.
Installation
Follow the removal procedure in the reverse order to install the
rear fog light.
Pay close attention to the important points mentioned in the
following paragraphs.
Bulb
Be absolutely sure that the license plate light bulb is correctly
installed.
This will prevent a poor contact and open circuit.
RTU4Z0SH000601
FRONT FOG & RR FOG SWITCH
RTW48ASH000401
Inspection
Check to see if there is any continuity between the terminals of
the leveling switch.
Replace the switch when the result of inspection is found
abnormal.
Removal
Preparation:
Disconnect the battery ground cable.
1. Ventilation grille
2. Harness connector
3. Front fog light & Rear fog light switch
To remove the switch, push the lock from the back side of
the cluster assembly.
4. Remove the bulb.
Page 807 of 4264
ELECTRICAL-BODY AND CHASSIS 8A-149
HEADLIGHT LEVELING
PARTS LOCATION (RHD)
RTW48AXF015801 & RTW48AXF015901
Page 808 of 4264
8A-150 ELECTRICAL-BODY AND CHASSIS
PARTS LOCATION (RHD)
RTW48AXF015801 & RTW48AXF015901
Page 809 of 4264
ELECTRICAL-BODY AND CHASSIS 8A-151
CIRCUIT DIAGRAM (RHD)
RTW48AXF014001
Page 810 of 4264
8A-152 ELECTRICAL-BODY AND CHASSIS
CIRCUIT DIAGRAM (LHD)
RTW48XF014101