JAGUAR XFR 2010 1.G Workshop Manual
Page 2661 of 3039
Torque: 20 Nm
Page 2662 of 3039
Torque: 20 Nm
Page 2663 of 3039
Page 2664 of 3039
1. To install, reverse the removal procedure. www.JagDocs.com
Page 2665 of 3039
Published: 11-May-2011
Supplemental Restraint System - Restraints Control Module (RCM)
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Make the air bag supplemental restraint system (SRS) safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
2. WARNING: To avoid accidental deployment and possible personal injury,
the backup power supply must be depleted before repairing or replacing
any air bag supplementary restraints system (SRS) components. To
deplete the backup power supply energy, disconnect the battery ground
cable and wait for one minute. Failure to follow this instruction may
result in personal injury.
Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
3.
4.
Page 2666 of 3039
5.
6. Torque: 6 Nm 7.
8. NOTES:
If the SRS component is to be replaced, the bar code
of the new unit must be recorded.
The RCM will record and store impact data. The
module must be replaced when three records are noted.
Torque: 10 Nm
Page 2667 of 3039
Installation
1. To install, reverse the removal procedure.
2. If a new component has been installed, configure using Jaguar approved
diagnostic equipment.
Page 2668 of 3039
Supplemental Restraint System - Side Air Bag Module
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details. Published: 07-Sep-2011
1. Make the air bag supplemental restraint system (SRS) safe.
For additional information, refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
2. Disconnect the battery ground cable.
For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
3. Remove the front seat.
For additional information, refer to: Front Seat (501-10 Seating, Removal and Installation).
4. Remove the front seat backrest lower rear cover.
Page 2669 of 3039
www.JagDocs.com