JAGUAR XFR 2010 1.G Workshop Manual
Page 681 of 3039
Brake System - General Information, General Procedures).
Page 682 of 3039
Brake booster retaining nuts - all vehicles 25 18 - Exhaust gas recirculation valve coolant pipe - vehicles with 3.0L Diesel 9 - 80 Brake vacuum pump nut - vehicles with 3.0L Diesel 23 17 - Brake vacuum pump threaded stud - vehicles with 3.0L Diesel 13 10 - Brake vacuum pump bolts - vehicles with 3.0L Diesel 23 17 - Brake vacuum pump bolts - vehicles with 5.0L 12 9 -
Page 683 of 3039
Power Brake Actuation - Brake Booster - Component Location
Description and Operation
NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive) installation similar.
Component Location Published: 11-May-2011
Item Description 1 Output pushrod 2 Brake booster 3 Input pushrod 4 Vacuum pipe 5 Non return valve
Page 684 of 3039
Page 685 of 3039
Published: 11-May-2011
www.JagDocs.com
Page 686 of 3039
Page 687 of 3039
5. Remove the brake booster retaining nuts.
6. Remove the brake booster.
Installation
1. NOTE: Replace the brake booster/pedal box gasket.
To install, reverse the removal procedure.
Tighten to 25 Nm.
2. Tighten to 3 Nm.
Page 688 of 3039
Published: 08-Oct-2012
Power Brake Actuation - Brake Vacuum Pump V8 5.0L Petrol/V8 S/C 5.0L
Petrol
Removal and Installation
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Engine Oil Draining and Filling (303-01, General Procedures).
3.
4. CAUTION: Be prepared to collect escaping oil.
Torque: 12 Nm
Page 689 of 3039
Installation 5. NOTE: Remove and discard the O-ring seal.
1. NOTE: Install a new O-ring seal. To
install reverse the removal procedure.
2. Start engine and check the brake booster operation.
Page 690 of 3039
Brake fluid Shell ESL Dot 4 Torque Specifications
Description Nm lb-ft lb-in Brake master cylinder primary pressure transducer 30 22 – Brake tubes to hydraulic control unit (HCU) 17 13 – Rear wheel speed sensor retaining bolt 6 – 53 Yaw rate sensor and accelerometer retaining nuts 7 – 62 Hydraulic control unit (HCU) retaining bolts 8 – 71 Steering wheel rotation sensor retaining screws 4 – 35 Steering column to lower shroud retaining screws 3 – 27 www.JagDocs.com