ESP Lancia Musa 2007 Owner handbook (in English)

72
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
REAR SEATS
Adjustments from inside the car
Moving the seat backwards or forwards
Lift lever A or lever B respectively to adjust the required seat section,
then push the seat backwards or forwards.
Back rest angle adjustment
Push lever C, set back rest to required position, then release the lever.
To prevent malfunctions: always press lever C down.
L0D0047m
L0D0252m

RECIRCULATION
Set knob E to ….
This function is particularly useful when the outside
air is heavily polluted (in a traffic jam, tunnel, etc.).
However, it is better not to use it for long periods,
especially if there are several people in the car to
prevent window steaming up.
IMPORTANT The inside air recirculation system
makes it possible to reach the required “heating” or
“cooling” conditions faster. Do not use the air
recirculation function on rainy/cold days as it would
considerably increase the possibility of the windows
misting inside.
85
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
QUICK HEATING
Proceed as follows:
❒close all dashboard vents;
❒turn knob B to the red sector;
❒turn knob A to 4 -;
❒turn knob E to ≈.

91
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
CONTROLS
Air temperature
adjustment knobs H-N
Turning the knobs
clockwise or
counterclockwise,
highers or lowers the temperature of the air
required respectively in the left zone (knob N) or
right zone (knob H) of the passenger compartment.
It is possible to personalise required temperatures
(driver and passenger) with a maximum difference
of 7 °C.
The temperatures set are shown on the displays
near the relevant knobs.
Pressing button A (MONO) automatically aligns the
temperature on the front passenger’s side with that
on the driver’s side. It is therefore possible to set the
same temperature between the two zones simply
turning the knob on the driver’s side N.
This function is provided to simplify temperature
adjustment of the whole passenger compartment
when only the driver is on board.
Separate operation of the set temperatures is
automatically restored by turning knobs H or
pressing button A (MONO) again when the button
led is on.Turning the knobs clockwise or counterclockwise
until they reach the extreme selections HI or LO,
the maximum heating or cooling functions are
respectively engaged:
❒HI function (highest heating power):
this is activated by turning the temperature knob
clockwise above the max. value (32 °C). It can be
activated independently from the driver’s or
passenger’s side or both (also selecting the MONO
function).
This function can be engaged when requiring to
heat the passenger compartment as quickly as
possible, exploiting the maximum potential of the
system. This function uses the maximum
temperature of the coolant fluid, while air
distribution and fan speed are controlled according
to the system settings.
More particularly, max. fan speed will not be
immediately engaged if coolant is not hot enough;
this to prevent admitting air that is not warm
enough to the passenger compartment.
All manual settings are however possible with this
function on.

93
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
Set air flow distribution is indicated by the
corresponding button led switching on.
With a combined function set, pressing a button will
turn on the main function of the button pressed,
together with the functions set yet. Pressing the
button of the active function will turn the function
off (led off).
To restore automatic air distribution control after a
manual selection, press button AUTO.
When the driver selects air distribution towards the
windscreen, also the air distribution on passenger’s
side will automatically be directed to the
windscreen. The passenger can however select a
different air distribution by pressing the relevant
buttons.Fan speed adjustment buttons L
Pressing the ends of button p
increases or decreases the fan speed
and therefore the amount of air
admitted to the passenger
compartment, although keeping the required
temperature.
The fan speed is shown by the lit bars on the
display
❒max fan speed = all bars lit
❒min fan speed = one bar lit.
The fan can be cut off only if the climate control
compressor has been switched off pressing button B.
IMPORTANT To restore automatic fan speed
control after a manual adjustment, press button
AUTO.

95
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
These operating conditions are obtained pressing in
sequence the air recirculation button C.
After a preset time, the climate control system will
turn air recirculation off automatically for safety
reasons, thus enabling outside air inlet.IMPORTANT The air recirculation system
makes it possible to reach the required heating or
cooling conditions faster.
It is however inadvisable to use it on rainy/cold
days as it would considerably increase the
possibility of the windows misting inside, especially
if the climate control system is off.
When the outside temperature is below 5-7°C, air
recirculation is switched off (air is taken from the
outside) to prevent misting.
WARNINGIt is inadvisable to use the air recirculation feature with low outside temperature
as the windows might mist over quickly.

98
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
Button for demisting/defrosting
the heated rear window and door
mirrors G
Press this button to switch on the
heated rear window
demisting/defrosting function. The led on the
button will come on.
This function will be automatically switched off
after the preset time, or pressing the button again or
when stopping the engine. It will not start up
automatically when the engine is started again.
IMPORTANT Do not apply stickers on the inside of
the rear window over the heating filaments to avoid
damage that might cause it to stop working
properly.❒climate control system compressor off;
❒fan off.
The heated rear window can be switched on and off
normally when the system is off by pressing button
G.
IMPORTANT The climate control system electronic
unit stores the system settings made before the
system was switched off and restores them as soon
as a button is pressed (with the exception of the
heated rear window button). The function which
the button corresponds to will be switched on, if it
was off when the system was switched off. It will be
kept if, on the other hand, it was on when the
system was switched off.
Press the AUTO button to switch the climate control
system back on.
OFF button E (system off)
To switch the climate control system
off, press button E, also the display
will go off.
The climate control system
conditions when the system is off are the following:
❒Every led off;
❒set temperatures not displayed;
❒air recirculation on, thus isolating the passenger
compartment;

TO MEMORISE SPEED
Proceed as follows:
❒turn the knurled ring A to ON and press the
accelerator pedal to the required speed;
❒move the stalk upwards (+) for at least three
seconds, then release it. The car speed is
memorised and it is therefore possible to release
the accelerator pedal.
In the case of need (when overtaking for instance)
acceleration is possible simply pressing the
accelerator pedal: releasing the accelerator pedal,
the car will return to the speed memorised
previously.
TO RESET THE MEMORISED SPEED
If the device has been disengaged for example
pressing the brake or clutch pedal, the memorised
speed can be reset as follows:
❒accelerate gradually until reaching a speed
approaching the one memorised;
❒engage the gear selected at the time of speed
memorising (4th or 5th gear);
❒press the RES button B.TO INCREASE THE MEMORISED SPEED
The speed memorised can be increased in two ways:
❒pressing the accelerator and then memorising the
new speed reached;
or
❒moving the stalk upwards (+).
Each operation of the stalk will correspond to a
slight increase in speed (about 1 km/h), while
keeping the stalk upwards continuously will
correspond to a continuous speed increase.
110
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS

TO REDUCE MEMORISED SPEED
The speed memorised can be increased in two ways:
❒disengaging the device and then memorising the
new speed;
or
❒moving the stalk downwards (–) until reaching
the new speed which will be memorised
automatically.
Each operation of the stalk will correspond to a
slight reduction in speed (about 1 km/h), while
keeping the stalk downwards continuously will
correspond to a continuous speed reduction.DEVICE DISENGAGEMENT
Turn the ring A to OFF or the ignition key to STOP.
The device is automatically deactivated also in one
of the following cases:
❒pressing the brake or clutch pedal.
111
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
WARNING
WARNING
In the event of device malfunction or failure, turn the knurled ring A to OFF and
contact a Lancia Dealership after checking the protective fuse integrity. When travelling with the device on, do not put the gearbox lever in neutral.

113
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
Ceiling light timing
Two timing strategies are available in order to
facilitate getting in and out of the car, especially at
night in dark areas:
T
IMING FOR GETTING INTO THE CAR
The ceiling lights will come on as follows:
❒for about 10 seconds when a door is unlocked;
❒for about 3 minutes when a door is opened;
❒for about 10 seconds when a door is closed
(within the 3 minutes).
Timing will be stopped when the ignition key is
turned to MAR.T
IMING FOR GETTING OUT OF THE CAR
The ceiling lights will come on as follows when the
key is removed from the ignition switch:
❒for about 10 seconds within 2 minutes after
stopping the engine;
❒for about 3 minutes when a door is opened;
❒for about 10 seconds when a door is closed
(within the three minutes).
The timeout will automatically end when the doors
are locked.

114
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
REAR CEILING LIGHT
The light turns on/off pressing the transparent to the right or left as
illustrated in the figures.
If there is a console placed longitudinally to the roof, the ceiling light
is integrated in the console.
If the car is fitted with sunroof, there are two 5W ceiling lights on the
rear roof.
Ceiling light timing (where provided)
Two timing strategies are available in order to facilitate getting in and
out of the car, especially at night in dark areas:
T
IMING FOR GETTING INTO THE CAR
The ceiling lights will come on as follows:
❒for about 10 seconds when a door is unlocked;
❒for about 3 minutes when a door is opened;
❒for about 10 seconds when a door is closed (within the 3 minutes).
Timing will be stopped when the ignition key is turned to MAR.
T
IMING FOR GETTING OUT OF THE CAR
The ceiling lights will come on as follows when the key is removed
from the ignition switch:
❒for about 10 seconds within 2 minutes after stopping the engine;
❒for about 3 minutes when a door is opened;
❒for about 10 seconds when a door is closed (within the three
minutes).
The timeout will automatically end when the doors are locked.
L0D0078m
L0D0254m