LEXUS RX400H 2008 Owners Manual

5
When trouble arises
409
5-2. Steps to take in an emergency
RX400h_U
Taking out the jack and toolsPull up the front deck board.
Hold the front deck board with the
supporting rod.
When closing the board, return the
supporting rod to its stored posi-
tion.
Unhook
Loosen
Tighten
STEP1
STEP2
STEP3

410
5-2. Steps to take in an emergency
RX400h_U
Taking out the spare tireRemove the inside spare tire cover.
Open the right side auxiliary box.
Remove the cover.
To protect the auxiliary box, place a
rag between the screwdriver and
the auxiliary box, as shown in the
illustration.
Attach the adapter socket (for
removing a spare tire).
STEP1
STEP2
STEP3
STEP4

5
When trouble arises
411
5-2. Steps to take in an emergency
RX400h_UConnect the jack handle and the
adapter socket. Turn the jack han-
dle.
The tire will lower completely to
the ground.
Pull out the spare tire and stand it
up against the bumper.
Remove the holding bracket.
STEP5
STEP6
STEP7

412
5-2. Steps to take in an emergency
RX400h_U
Replacing a flat tireChock the tires.
Slightly loosen the wheel nuts (one
turn).
Turn the tire jack portion “A” by
hand until the notch of the jack is in
contact with the jack point.
STEP1
Flat tireWheel chock positions
Front
Left-hand
sideBehind the
rear right-
hand side tire
Right-
hand sideBehind the
rear left-
hand side tire
Rear
Left-hand
sideIn front of the
front right-
hand side tire
Right-
hand sideIn front of the
front left-
hand side tire
STEP2
STEP3

5
When trouble arises
413
5-2. Steps to take in an emergency
RX400h_URaise the vehicle until the tire is
slightly raised off the ground.
Remove all the wheel nuts and the
tire.
When resting the tire on the
ground, place the tire so that the
wheel design faces up to avoid
scratching the wheel surface.
STEP4
STEP5

414
5-2. Steps to take in an emergency
RX400h_U
Installing the spare tireRemove any dirt or foreign matter
from the wheel contact surface.
If foreign matter is on the wheel
contact surface, the wheel nuts
may loosen while the vehicle is in
motion, and the tire may come off
the vehicle.
Install the spare tire and loosely
tighten each nut by hand to
approximately the same amount.
Tighten the wheel nuts until the
tapered portion comes into loose
contact with the disc wheel sheet.
Lower the vehicle.
Firmly tighten each nut two or
three times in the order shown in
the illustration.
Tightening torque:
76 ft•lbf (103 N•m, 10.5 kgf•m)
STEP1
STEP2
Wheel nut
Wa s h e r
Disc wheel
STEP3
STEP4

5
When trouble arises
415
5-2. Steps to take in an emergency
RX400h_U
Stowing the flat tire, jack and all toolsInstall the inside spare tire cover on the outer side of the spare tire
cover. Put the flat tire in the spare tire
cover with the outer side facing up
and install the holding bracket.
Turn the spare tire clamp bolt clockwise with a jack handle and
adapter socket until you hear a click.
Stow all the tools and jack securely.
STEP1
STEP2
■After completing the tire change
The tire pressure warning system must be reset. ( →P. 3 3 2 )
STEP3
STEP4

416
5-2. Steps to take in an emergency
RX400h_U
CAUTION
■Using the tire jack
Improper use of the tire jack may lead to death or injuries due to the vehicle sud-
denly falling off the jack.
●Do not use the tire jack for any purpose other than replacing tires or installing and
removing tire chains.
●Only use the tire jack that comes with this vehicle for replacing a flat tire.
Do not use it on other vehicles, and do not use other tire jacks for replacing tires
on this vehicle.
●Always check that the tire jack is securely set to the jack point.
●Do not put any part of your body under the vehicle supported by a jack.
●Do not start or run the engine while your vehicle is supported by the jack.
●Do not raise the vehicle while someone is in it.
●When raising the vehicle, do not put an object on or under the jack.
●Do not raise the vehicle to a height greater than that required to replace the tire.
●Use a jack stand if it is necessary to get under the vehicle.
Take particular care when lowering the vehicle to ensure that no one working on or
near the vehicle may be injured.
■Replacing a flat tire
Observe the following precautions to reduce the risk of death or serious injury:
●Never use oil or grease on the wheel bolts or wheel nuts.
The oil or grease can cause the wheel nuts to loosen, causing a serious accident.
Remove any oil or grease on the wheel bolts or wheel nuts.
●Have the wheel nuts tightened with a torque wrench to 76 ft•lbf (103 N•m, 10.5
kgf•m) as soon as possible after changing wheels.
Failure to follow these precautions could cause the nuts to loosen and the wheels
may fall off, which could lead to an accident causing death or serious injury.

5
When trouble arises
417
5-2. Steps to take in an emergency
RX400h_U
NOTICE
■Do not drive the vehicle with a flat tire.
Do not continue driving with a flat tire.
Driving even a short distance with a flat tire can damage the tire and the wheel
beyond repair.
■When replacing the tires
When removing or fitting the wheels, tires or the tire pressure warning valve and
transmitter, contact your Lexus dealer as the tire pressure warning valve and trans-
mitter may be damaged if not handled correctly.
■To avoid damaging the tire pressure warning valves and transmitters
Do not use liquid sealants on flat tires.
■When stowing the flat tire
●Ensure that there is no object caught between the tire and the vehicle underbody.
●Tighten the spare tire clamp bolt to hold the spare wheel carrier by the hook
securely.

418
5-2. Steps to take in an emergency
RX400h_U
If the hybrid system will not start
If the hybrid system will not start, even though correct starting procedures
are being followed (
→P. 131), consider each of the following points.
■The hybrid system will not start even when the starter motor oper-
ates normally.
One of the following may be the cause of the problem.
● There may not be sufficient fuel in the vehicle’s tank.
Refuel your vehicle.
● The hybrid system may be flooded.
Try to restart the hybrid system once more following correct
starting procedures. ( →P. 131)
● There may be a malfunction in the hybrid vehicle immobilizer sys-
tem. (→ P. 8 3 )
■ The interior lights and headlights are dim, or the horn does not
sound or sounds at a low volume.
One of the following may be the cause of the problem.
● The 12-volt battery may be discharged. ( →P. 4 2 1 )
● The 12-volt battery terminal connections may be loose or cor-
roded.
■ The interior lights and headlights do not turn on, or the horn does
not sound.
One of the following may be the cause of the problem.
● One or both of the 12-volt battery terminals may be discon-
nected.
● The 12-volt battery may be discharged. ( →P. 4 2 1 )
Contact your Lexus dealer if the problem cannot be repaired, or if
repair procedures are unknown.