display LINCOLN AVIATOR 2023 Owner's Guide

When you are decelerating with either your
foot off the accelerator pedal or on the brake
pedal, you will see a green or white solid bar
indicating the power being used to slow
down the vehicle. You may also see a green
rectangular box which shows the amount of
power that can be recaptured by the
regenerative braking system and returned
to the high voltage battery.
• When the power level is completely
within the box, the color of the bar will
be all green. This means that the
regenerative braking system is being
used to efficiently slow the vehicle down
and return the maximum percentage of
energy to the high voltage battery.
• When the power level is outside of the
green box, then the bar will be white. This
means that both the regenerative braking
system and conventional braking system
are in use.Electric Efficiency
This screen shows your average driving
distance per kWh of electricity used on your
hybrid vehicle. The value is calculated only
when your available electric range is being
used and the gasoline engine is off.
Distance per full charge is also shown. This
is an estimate of the electric range you would
have if you plugged in and fully charged your
vehicle right now. The higher your electric
efficiency, the higher your distance per full
charge.
Your electric efficiency is affected by your
driving style and route, climate control use,
outside temperature and other factors. Best
efficiency is achieved in mild ambient
temperatures with mild to moderate
acceleration and braking, moderate speeds
and low climate control usage.INFORMATION MESSAGES
EE2812812818181818111182202222022022220222022220
E265041
Move the selector switch to the
right to acknowledge and remove
some messages from the
information display. The system removes
other messages after a short time.
You need to confirm certain messages
before you can access the menus.
Active Park
Action Message
The system requires service. Have the system checked as soon as possible. Active Park Fault
142
Information Displays

Adaptive Cruise Control
Action Message
A radar concern is preventing the adaptive cruise from engaging. See How Does Adaptive
Cruise Control With Stop and Go Work (page 305). Adaptive Cruise Malfunction
Front Sensor Not Aligned
Conditions exist such that the adaptive cruise cannot function properly. See How Does
Adaptive Cruise Control With Stop and Go Work (page 305). Adaptive Cruise Not Available
Inclement weather, ice, mud, or water is blocking the radar, causing the system to become
unavailable. You can typically clean the sensor to resolve. See How Does Adaptive Cruise
Control With Stop and Go Work (page 305). Adaptive Cruise Not Available Sensor Blocked
See Manual
Displays when the system disables automatic braking. Normal Cruise Active Adaptive Braking Off
Displays when the system reinstates adaptive cruise control to you. Adaptive Cruise - Driver Resume Control
Displays when the vehicle speed is too slow to activate the adaptive cruise. Adaptive Cruise Speed Too Low to Activate
Adaptive Headlamps
Action Message
Displays when the system detects a concern. Have the system checked as soon as possible. Check Headlamp System See Manual
143
Information Displays

AdvanceTrac™ and Traction Control
Action Message
The system detects a condition that requires service. Have the system checked as soon as
possible. Service AdvanceTrac
The status of the system after you switch it off. AdvanceTrac Off
The status of the system after you switch it on. AdvanceTrac On
The status of the system after you switch it on. AdvanceTrac SPORT MODE
The status of the system after you switch it off. Traction Control Off
The status of the system after you switch it on. Traction Control On
Alarm
Action Message
Alarm triggered due to unauthorized entry. See Anti-Theft Alarm (page 100). Vehicle Alarm To Stop Alarm, Start Vehicle.
144
Information Displays

AWD
Action Message
The all-wheel drive system temporarily turns off to protect itself from overheating. AWD Temporarily Disabled
The all-wheel drive system is locking the torque transfer clutch to reduce clutch temperature. AWD Temporarily Locked
The all-wheel drive system temporarily turns off to protect itself from overheating or if you
are using the temporary spare tire. AWD OFF
The all-wheel drive system resumes normal function and clears this message after driving a
short distance with the road tire re-installed or after the system cools. AWD Restored
The all-wheel drive system is not operating properly. If the warning stays on or continues to
come on, have the system checked as soon as possible. AWD Fault Service Required
Displays when the transfer case fluid requires service. Change AWD Power Transfer Unit Lube
Displays when the transfer case fluid has been changed and reset to new. AWD Power Transfer Unit Lube Set to New
145
Information Displays

Battery and Charging System (12 volt)
Action Message
The charging system needs servicing. If the warning stays on or continues to come on, have
the system checked as soon as possible. Check Charging System
The charging system needs servicing. If the warning stays on or continues to come on have
the system checked as soon as possible. Charging System Service Soon
The charging system needs servicing. Have the system checked as soon as possible. Charging System Service Now
The battery management system determines that the 12V battery is at a low state of charge.
Start the engine to charge the battery or charge the battery using an aftermarket battery
charger. This message clears once you restart your vehicle and the battery state of charge
has recovered. Battery State of Charge Low
The battery management system determines that the battery is at a low state of charge. Turn
the ignition off as soon as possible to protect the battery. This message clears once the
vehicle has been started and the battery state of charge has recovered. Turning off unneces-
sary electrical loads allows faster battery state-of-charge recovery. Turn Power Off To Save Battery
Displays when the battery management system detects an extended low-voltage condition.
The system disables various vehicle features to help preserve the battery. Turn off as many
of the electrical loads as soon as possible to improve system voltage. When the system
voltage recovers, the disabled features operate again as normal. Low Battery Features Temporarily Turned Off
146
Information Displays

Battery and Charging System (High Voltage)
Action Message
Your vehicle needs confirmation it is unplugged before allowing a start. Make sure you unplug
your vehicle and respond to the message prompt before starting your vehicle. Vehicle Plugged In ? Yes No
Your vehicle detects it is still plugged in after you attempt to start it. Unplug Prior to Starting Vehicle
Your vehicle enables the engine due to the climate control defrost setting. This is normal
operation. Engine Enabled Due to Defrost Setting
For full defrost heat, select a drive mode other than Pure EV. The engine may run to provide
more cabin heat. Press EV Button for Full Defrost
Your vehicle enables the engine for system performance. This is normal operation. Engine Enabled for System Performance
You can press OK to enable the engine temporarily for increased performance when in Pure
EV drive mode. Press OK to Enable Engine
147
Information Displays

Blind Spot Information and Cross Traffic Alert System
Action Message
The system may require service. Have the system checked as soon as possible. Blind Spot System Fault
Something is blocking the sensor, causing the system to become unavailable. You can
typically clean the sensor to resolve. See Blind Spot Information System (page 326). Blind Spot Not Available Sensor Blocked See
Manual
The system detects a vehicle and applies the brakes. Cross Traffic Alert Applying Brakes
Something is blocking the sensor, causing the system to become unavailable. In most cases,
you can clean the sensor to resolve. Cross Traffic Not Available Sensor Blocked
See Manual
The system may require service. Have the system checked as soon as possible. Cross Traffic System Fault
The system automatically turns off and displays this message when you connect a trailer to
the vehicle that does not have a trailer blind spot system or when you switch the trailer blind
spot system off through the information display. See Cross Traffic Alert (page 330). Cross Traffic Alert Deactivated Trailer
Attached
The system automatically turns off and displays this message when you connect a trailer to
the vehicle that does not have a trailer blind spot system or when you switch the trailer blind
spot system off through the information display. See Blind Spot Information System (page
326). Blind Spot Alert Deactivated Trailer Attached
148
Information Displays

Doors and Locks
Action Message
The driver door is not completely closed. Driver Door Ajar
The passenger door is not completely closed. Passenger Door Ajar
The rear left-hand door is not completely closed. Rear Left Door Ajar
The rear right-hand door is not completely closed. Rear Right Door Ajar
The liftgate is not completely closed. Liftgate Ajar
The hood is not completely closed. Hood Ajar
The system has disabled the door switches. Switches Inhibited Security Mode
Displays when the door lock is turned on and you attempt to open the door. Doors Locked Unlock Before Opening
Indicates a driver door concern that requires manually opening the door by the override lever.
Have the system checked as soon as possible. Driver Door Fault Use Inside Override Lever
In Map Pocket
Indicates a concern with the electronic door system. Have the system checked as soon as
possible. Door Fault Service Required
Displays when the system requires service. Have the system checked as soon as possible. Child Lock Malfunction Service Required
149
Information Displays

Action Message
Indicates that the rear seat interior door release switches and power windows are switched
off, preventing rear seat occupants from opening the doors or windows. Child Lock ON
Indicates that the rear seat interior door release switches and power windows are switched
on, allowing the rear seat occupants to open the doors and windows. Child Lock OFF
The factory keypad code displays in the information display after the system resets the keypad.
See Passive Anti-Theft System (page 99). Factory Keypad Code {X X X X X}
Driver Alert
Action Message
Stop and rest as soon as it is safe to do so. Driver Alert Warning Rest Now
Take a rest soon. Driver Alert Warning Rest Suggested
Fuel
Action Message
An early reminder of a low fuel condition. Fuel Level Low
The fuel fill inlet valve may not be properly closed. Check Fuel Fill Inlet
Wait for up to 15 seconds while the fuel system depressurizes. Fuel Door Opening
150
Information Displays

Action Message
The fuel system has finished depressurizing and you can begin to refuel. Fuel Door Open
A reminder to close the fuel door. Failure to follow this instruction can cause the check engine
light to illuminate. Close Fuel Door to Avoid ""Check Engine""
Light
There is an error in attempting to refill your vehicle. Refuel Error See Manual
Hill Descent Control
Action Message
Displays when you switch off hill descent control mode. Hill Descent Control OFF
Displays when hill descent speed exceeds 20 mph (32 km/h). For Hill Descent Reduce Speed 20 MPH or
Less
Displays when hill descent speed exceeds 20 mph (32 km/h). For Hill Descent Reduce Speed 32 Km/h or
Less
Displays when hill descent control mode requires you to shift the transmission into gear. For Hill Descent Select Gear
Displays when the hill control mode requires you to resume control. Hill Descent Driver Resume Control
Displays when a hill descent system fault is present. Hill Descent Control Fault
151
Information Displays