fuel cap MAZDA MODEL 6 2014 Smart Start Guide (in English)

10
DASHBOAR D ILLU MINATION /
D IMMER1/TRIP METER2
1 • Rotate the knob to adjust the brightness of the
instrument cluster and other dashboard illuminations.
2 • Push to toggle between trip meter (A & B).
• When a trip meter is selected, push and hold to reset to zero.
www.MazdaUSA.com

B
rak e Warning Light Parking brake on/low brake
fuid/malfunction

Master Warning Light

Low Fuel Level
T YPE B INS TRUMENT CL USTER
WARN ING LIG HTS ONL Y.
These warnings are displayed as text in the Type
A Information display.
Low E
ngine Oil Pressure

Pow
er Steering Malfunction

Aut
omatic Transaxle
Warning Light

Char
ging System
Malfunction

D
oo r/Trunk Ajar

Low W
asher Fluid Level
Warning Light

KEY W
arning Light RE D

KEY I
ndicator Light GREEN
Check Fuel Cap


Per
form Maintenance F
UEL
GAUG E
ODOMET
ER/
TRIP METER
E NGINE COOL ANT TEMP LIGH TS Since this vehicle does not use an
engine coolant temperature gauge, red
and blue engine coolant temperature
lights are used to indicate high
and low coolant temperature.
Red Coolant Temp Light
Flashing: Engine is starting
to run hot. Drive slowly to
reduce engine load.
On: Engine is overheating. Safely pull
over to the side of the road and turn
the engine off. Refer to the Owner’s
Manual for more information.
B lue Coolant Temp Light
On: Engine coolant is cold
and no warm air is available
for heater/defroster.
Off: Engine coolant is warm and
warm air is available for heater/
defroster. The light may stay on for a
few minutes after start-up when the
engine is cold, but the vehicle can
be driven with the light on or off.
INFORMATION DISP L AY
See page 6 or the
Owner’s Manual for
further information.
TYPE B CLUSTER
INFORM AT I O N
D ISP L AY

23
i-ELOOP
i-ELOOP (if eq uipped)
The Mazda-unique regenerative braking system (i-ELOOP) generates and
stores electrical energy in a capacitor during deceleration. Through efcient
energy regeneration, storage, and usage, fuel economy is improved.
i-ELOOP Pre-Charge Mode
If the capacitor is discharged because of vehicle storage (the vehicle \
is parked
for long periods of time), the Multi-Information Display will display t\
he following
i-ELOOP warning message after engine startup:
Multi-Information
Display
Regenerative
braking power
Capacitor power
storage
Capacitor
charge Capacitor
discharge
In Pre-charge mode Driving in Pre-charge mode
i-ELOOP
warning alarm sound
When the warning message is displayed, do not drive the vehicle. Allow the
engine to idle until the warning message is no longer displayed. This time is
needed for normal generator operation.
NOTE:
• If the vehicle is jump started, leave the jumper cables connected
until the warning message is no longer displayed.
•
If the vehicle is driven while the warning is displayed, a warning
sound will be heard and power steering assist will be limited.