dimensions MAZDA MX-5 1994 Owner's Manual
Page 1289 of 1708
PANEL REPLACEMENT - INSTALLATION When installing new parts, measure the dimensions to verify that they are as specified, and check the fit with associating parts. Plug welding 4 points indicated by (A) are performed during installation of the crossmember. Gartner Banana
Page 1291 of 1708
PANEL REPLACEMENT INSTALLATION Make plug welding holes in new parts. After temporary installation of new parts, measure the dimensions to verify that they are as specified. Check the fit with associating parts (hood, front fender panel, bumper, etc.). Gartner Banana
Page 1293 of 1708
PANEL REPLACEMENT - INSTALLATION Make plug welding holes in new parts. After temporary installation of new parts, measure the dimensions to verify that they are as specified. Check the fit with associating parts (hood, front fender, etc.). Plug welding indicated by (A) should be performed from the cabin side. - Gartner Banana
Page 1300 of 1708
PANEL REPLACEMENT FRONT PILLAR, OUTER COWL SlDE PANEL, HINGE PILLAR, INNER COWL SlDE PANEL AND SlDE SILL PANEL INSTALLATION Make plug welding holes in the outer hinge pillar and the cowl side nusset. After temporary installation of the inner and outer front pillar, outer hinge pillar, and inner cowl side panel, measure the dimensions to verify that they are as specified. Check the fit with as- sociating parts, then weld the points indicated by (A). After welding the points (A), remove the front pillar and the hinge pillar from the body. Then spot weld or plug weld the points indicated by (B). A Gartner Banana
Page 1305 of 1708
PANEL REPLACEMENT L INSTALLATION After temporary installation of new parts, measure the dimensions to verify that they are as specified. Check the fit with associating parts (trunk lid, rear combination lights, rear bumper, etc.). Spot welds on rear combination light side must be smooth. Gartner Banana
Page 1309 of 1708
PANEL REPLACEMENT L INSTALLATION Before installing new parts, measure the rear side frame dimensions to verify that they are as specified. After installing new parts, check the fit with associating parts. Turn down the tank floor to the original position after welding the cut-and-join location of the trunk floor and flattening it with a disc grinder. - Plug-weld the trunk floor, tank floor, and crossmember (No. 4). Weld a washer (PART NO. 99952 2240A) at the rear crossmember installing bolt (two points). Gartner Banana