MITSUBISHI ENDEAVOR 2004 Service Repair Manual

position.
02
CLOSE
1. Ignition switch: ON
2. Sunroof switch:
CLOSE/TILT-DOWN
The sunroof closes while
the sunroof switch is
pushed to the
CLOSE/TILT-DOWN
position.
03
TILT-UP
1. Ignition switch: ON
2. Sunroof switch: TILT-
UP
The sunroof tilts up fully
and automatically.
04
TILT-DOWN
1. Ignition switch: ON
2. Sunroof switch:
CLOSE/TILT-DOWN
The sunroof closes while
the sunroof switch is
pushed to the
CLOSE/TILT-DOWN
position.
05
AUTOMATIC
OPERATION
INTERRUPTION
(OPEN)
A
1. Ignition switch: ON
2. Sunroof switch:
OPEN or TILT-UP
The sunroof stops the
automatic opening
operation.
B
1. Ignition switch: ON
2. Sunroof switch:
CLOSE/TILT
DOWN (Push the
sunroof switch to the
CLOSE/TILT-
DOWN position
while the sunroof is
automatically
opening and release
the switch within two
seconds)
The sunroof stops the
automatic opening
operation.
1. Ignition switch: ON
2. Sunroof switch:
CLOSE/TILT
DOWN
(Push the
The sunroof stops the
automatic o
penin
g

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Sunroof Assembly - Endeavor

JAM PREVENTING MECHANISM JAM PREVENTING MECHANISM
C
sunroof switch to the
CLOSE/TILT-
DOWN position
more than two
seconds while the
sunroof is
automatically
opening)
operation, and the
sunroof closes while the
sunroof switch is pushed
to the CLOSE/TILT-
DOWN position.
06
AUTOMATIC
OPERATION
INTERRUPTION
(TILT-UP)
1. Ignition switch: ON
2. Sunroof switch: OPEN
or TILT-UP,
CLOSE/TILT DOWN
The sunroof stops the
automatic opening
operation.
NO.
SUNROOF
FUNCTION
REQUIREMENTS FOR
THE SUNROOF TO
FUNCTION
NORMAL
OPERATION
01
CLOSE
1. Ignition switch: ON
2. Sunroof switch:
CLOSE/TILT-DOWN
3. Sunroof initial position:
being closed or opened
4. If there is an object in the
sunroof opening, interrupt
the sunroof operation
before the sunroof is fully
closed.
After the sunroo
f
operation is interrupted, it
opens to the
predetermined distance
and then stops
automatically.
02
TILT-DOWN
1. Ignition switch: ON
2. Sunroof switch:
CLOSE/TILT-DOWN
3. Sunroof initial position:
bein
g tiltin
g down
The sunroof tilts up
automaticall
y after it is

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Sunroof Assembly - Endeavor

SUNROOF TIMER MECHANISM In cases except the following, the basic operation and jam preventing mechanism
will be maintained for thirty seconds after the ignition switch is turned to the LOCK
(OFF) position. (Sunroof timer function)
If you open a door within that period (i.e. a door switch is on), the sunroof
timer function will be cancelled immediately. If you turn the ignition switch to the LOCK (OFF) position while the timer is
working, the sunroof will continue moving until it close fully, regardless of the
time-out period.
SUNROOF ASSEMBLY REMOVAL AND INSTALLATION
4. Interrupt the sunroof
operation before the
sunroof is fully close.
interrupted.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Sunroof Assembly - Endeavor

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Sunroof Assembly - Endeavor

Fig. 6: Removing/Installing Sunroof Assembly

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Required Special Tool:
MB991223: Harness set
REMOVAL SERVICE POINT << A >> FRONT DRAIN PIPE/REAR DRAIN PIPE REMOVAL Tie a cord to the end of the drain pipe, and wind tape around it so that there is no
unevenness. Then pull the drain pipe out to the wheel house side.
Fig. 7: Removing Drain Pipe And Cord

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
INSTALLATION SERVICE POINT
2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Sunroof Assembly - Endeavor

>>A<< FRONT DRAIN PIPE/REAR DRAIN PIPE INSTALLATION1. Tie the cord that was used during removal to the end of the drain pipe, and
wind tape around it so that there is no unevenness.
2. Pull the cord to pass through the drain pipe.
Fig. 8: Pulling Cord Through Drain Pipe

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
3. Install the grommet, and then position the drain pipe so that it protrudes from
the grommet as shown in the illustration.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Sunroof Assembly - Endeavor

Fig. 9: Identifying Groomet

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
INSPECTION SUNROOF SWITCH CONTINUITY CHECK SUNROOF SWITCH CONTINUITY CHECK SWITCH
POSITION
TESTER
CONNECTION
SPECIFIED
CONDITION
Open
4-5
Less than 2 ohms
Off
3-4,3-5,3-6, 4-5,4-6,5-6
Open circuit
Tilt-up
3-4
Less than 2 ohms
Close/Tilt-down
4-6
Less than 2 ohms

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Sunroof Assembly - Endeavor

Fig. 10: Identif
ying Sunroof Switch O
perational Wa
y

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Sunroof Assembly - Endeavor

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA
.
SUNROOF MOTOR CHECK
MOTOR SECTION CHECK (EXCEPT MOTOR ROTATION SENSOR INSPECTION) 1. Connect a battery directly to the motor terminals and check that the motor runs
smoothly.
2. Check that the motor runs in the opposite direction when the battery is
connected with the polarity reversed.
3. If a defect is found, replace the sunroof motor.
SUNROOF MOTOR CHECK TESTER CONNECTION
GEAR SHAFT:
Connect terminal No. 1 and the negative battery
terminal. Connect terminal No. 2 and the positive battery
terminal.
Turns in direction
A.
Connect terminal No. 2 and the negative battery
terminal. Connect terminal No. 1 and the positive battery
terminal.
Turns in direction
B.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Sunroof Assembly - Endeavor

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Sunroof Assembly - Endeavor