NISSAN ALMERA N16 2003 Electronic Repair Manual
Page 2181 of 3189
Torsion Beam, Lateral Link and Control Rod
DISASSEMBLYNJSU0036Remove torsion beam assembly. Refer to “Removal and
Installation”, “REAR SUSPENSION”, SU-21.
Remove lateral link and control rod from torsion beam.
ARA072
INSPECTIONNJSU0037Check for cracks, distortion or other damage. Replace if nec-
essary.
Standard length:
A 207 - 208 mm (8.15 - 8.19 in)
B 394 - 395 mm (15.51 - 15.55 in)
C 601 - 603 mm (23.66 - 23.74 in)
D 106 - 108 mm (4.17 - 4.25 in)
Check all rubber parts for wear, cracks or deformation.
Replace if necessary.
SRA793A
ASSEMBLYNJSU00381. Temporarily assemble lateral link and control rod.
When installing the control rod, connect the bush with the
smaller inner diameter to the lateral link.
SRA701A
2. Temporarily install lateral link and control rod on torsion beam.
When installing, place lateral link with the arrow topside.
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
BR
ST
RS
BT
HA
SC
EL
IDX
REAR SUSPENSION
Torsion Beam, Lateral Link and Control Rod
SU-23
Page 2182 of 3189
SRA702A
3. Place lateral link and control rod horizontally against torsion
beam, and tighten to the specified torque.
4. Install torsion beam assembly. Refer to “Removal and
Installation”, “REAR SUSPENSION”, SU-21.
REAR SUSPENSION
Torsion Beam, Lateral Link and Control Rod (Cont’d)
SU-24
Page 2183 of 3189
Service Data and Specifications (SDS)
GENERAL SPECIFICATIONS (REAR)=NJSU0039
Suspension type Multi-link beam suspension
Shock absorber type Double-acting hydraulic
REAR WHEEL ALIGNMENT (UNLADEN*)NJSU0040
Camber
Degree minute (Decimal degree)Minimum −2°15′(−2.25°)
Nominal −1°03′(−1.05°)
Maximum −0°45′(−0.75°)
Total toe-in Distance (A − B)
mm (in)Minimum −2 (−0.08)
Nominal 2 (0.08)
Maximum 6 (0.24)
Angle (left plus right)
Degree minute (Decimal degree)Minimum −0°12′(−0.20°)
Nominal 0°12′(0.20°)
Maximum 0°36′(0.60°)
*: Fuel, radiator coolant and engine oil full. Spare tire, jack, hand toolsand mats in designated positions.
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
BR
ST
RS
BT
HA
SC
EL
IDX
REAR SUSPENSION
Service Data and Specifications (SDS)
SU-25
Page 2184 of 3189
NOTES
Page 2185 of 3189
BRAKE SYSTEM
SECTION
BR
CONTENTS
PRECAUTIONS<0011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100
11001100110011001100110011001100110011001100110011[3
Supplemental Restraint System (SRS)″AIR
BAG″and″SEAT BELT PRE-TENSIONER″...............3
Precautions for Brake System .....................................3
Precautions When Working On ABS ...........................4
Wiring Diagrams and Trouble Diagnosis .....................4
PREPARATION<0011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100
11001100110011001100110011001100110011001100110011[5
Commercial Service Tools ...........................................5
NOISE, VIBRATION AND HARSHNESS (NVH)
TROUBLESHOOTING<0011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100110011001100
1100110011>