display Peugeot 307 CC 2003 Service Manual

22-09-2003
YOUR 307 CC IN DETAIL
82
2. Automatic comfort programme
Press the AUTObutton. The sys-
tem automatically regulates the temperature level of the passen-ger compartment in line with the
temperature that you have selected. Toobtain the correct ambiance, it controls the
temperature, the air flow, the distribution andintake of air as well as the air conditioning. Note: for your comfort, the settings are
retained between two start-ups of your vehicle if the temperature in the passenger compart-ment has not changed significantly; other-wise, operation resumes in automatic mode.
3. Automatic visibility programme
In certain cases, the auto-matic comfort programmemay prove inadequate todemist or de-ice the win-
dows (because of humidity, numer-ous passengers, ice, etc.). Selectthis programme to rapidly clear thewindows.
To exit this programme and return to the automatic comfort programme,press the AUTObutton.Automatic operation
1. Temperature setting
The required temperature is displayed. Press the up and
down arrows to change it. Asetting of approximately 21allows a comfortable settingto be obtained.
AUTOMATIC AIR CONDITIONING Note:
in the cabriolet version, the effectiveness of the system may be reduced.

22-09-2003
YOUR 307 CC IN DETAIL83
5. Air distribution
Successive presses of this button allow the air flow tobe directed alternately to:
Ð the windscreen (demisting or de-icing),
Ð the windscreen and the footwells,
Ð the footwells,
Ð the central and side vents and the footwells,
Ð the central and side vents.
7. Air intake
Press this button to recycle
the interior air. Recirculation,
shown on the display, pre-ventsthe entry of unpleasant
odours and fumes from the outside.
Avoid prolonged recirculation of the
interior air. To do this, press again toreturn the system to automatic pro-cessing of the air intake. Note: To prevent condensation on
the inside of the vehicle in cold or
wet weather, you are advised toavoid using this mode.
4. Air conditioning
Press this button to stop
cooling of the air. The"ECO"symbol lights up.
Press again to return to
automatic operation of the air condi-tioning. The "A/C"symbol is dis-
played. 8. Switching the system off
The
OFF button enables the
entire system to be switched off.
Temperature-related com-fort is no longer guaranteed
but a minimal flow of air is main-tained to prevent misting and to
renew the air. Pressing the OFF, AUTO or "visibility"
button again reactivates the system with the values set before it was
switched off.
Note: if you wish to cut off the flow of air
completely, press the air intake button 7.
9. De-icing the rear window and
the mirrors
Press this button to de-icethe rear screen and the mir-
rors. The de-icing system
switches off automatically.
It is possible to stop the de-icing
before it switches off automaticallyby pressing the button again. Note: this function is disarmed when
the roof is stored in the boot. Important precaution Operate the air conditioning system for 5 to 10 minutes, once or twice amonth, to keep it in perfect working
order. If the system does not produce cold
air, do not use it and contact your
PEUGEOT dealer.
Manual operation
If you wish you can make a different
choice from the one offered by the
system, by changing a setting. Theother functions will still be managed
automatically. Press the
AUTObut-
ton to return to completely automaticoperation.
6. Air flowThe air flow may beincreased or reducedby pressing the buttons+or Ðrespectively.
Notes The condensation created by the air conditioning causes a normal flow ofwater under the vehicle when sta-
tionary.
To prevent condensation on the inside of the vehicle in cold or wet
weather, you are advised to avoidusing the "ECO"mode.

22-09-2003
YOUR 307 CC IN DETAIL93
Confidential card The confidential card contains the identification code necessary for anywork carried out by a PEUGEOTdealer on the electronic immobiliser
system. This code is hidden by afilm, which should be removed only
if necessary. Keep your card in a safe place, never inside the vehicle. Key in ignition
A buzzer sounds on opening the dri-
ver's door, if the key has been left inthe ignition. Changing the battery of the remote control
Warning that the battery is flat is given by an audible signal accompa-nied by the message
''Remote con-
trol battery low'' on the multifunc-
tion display.
To replace the battery, remove the screw then unclip the casing using acoin at the ring (CR 2016/3 volt bat-tery). If the remote control does not work after the battery has been changed,reprogramme the remote control. Programming the remote control  Switch off the ignition.
 Switch the ignition on again.
 Press button Aimmediately.
 Switch off the ignition and remove the remote control key
from the ignition lock. The remotecontrol is now working again.
ELECTRONIC ENGINE IMMOBILISER This locks the engine control system as soon as the ignition has been
switched off and therefore preventsstarting of the vehicle by anyone
who does not have the key. The ignition key has an electronic chip which has a special code.When the ignition is switched on, thecode must be recognised for startingto be possible. If the system does not function correctly , the central locking button
indicator light, situated in the centreof the fascia, flashes rapidly whenthe ignition is switched on (2ndnotch), accompanied by an audiblesignal and the message ''Anti-theft
device faulty'' on the multi-function
display. In this case your vehicle will not start.
Contact a PEUGEOT dealer as soon as possible.

22-09-2003
YOUR 307 CC IN DETAIL93
Confidential card The confidential card contains the identification code necessary for anywork carried out by a PEUGEOTdealer on the electronic immobiliser
system. This code is hidden by afilm, which should be removed only
if necessary. Keep your card in a safe place, never inside the vehicle. Key in ignition
A buzzer sounds on opening the dri-
ver's door, if the key has been left inthe ignition. Changing the battery of the remote control
Warning that the battery is flat is given by an audible signal accompa-nied by the message
''Remote con-
trol battery low'' on the multifunc-
tion display.
To replace the battery, remove the screw then unclip the casing using acoin at the ring (CR 2016/3 volt bat-tery). If the remote control does not work after the battery has been changed,reprogramme the remote control. Programming the remote control  Switch off the ignition.
 Switch the ignition on again.
 Press button Aimmediately.
 Switch off the ignition and remove the remote control key
from the ignition lock. The remotecontrol is now working again.
ELECTRONIC ENGINE IMMOBILISER This locks the engine control system as soon as the ignition has been
switched off and therefore preventsstarting of the vehicle by anyone
who does not have the key. The ignition key has an electronic chip which has a special code.When the ignition is switched on, thecode must be recognised for startingto be possible. If the system does not function correctly , the central locking button
indicator light, situated in the centreof the fascia, flashes rapidly whenthe ignition is switched on (2ndnotch), accompanied by an audiblesignal and the message ''Anti-theft
device faulty'' on the multi-function
display. In this case your vehicle will not start.
Contact a PEUGEOT dealer as soon as possible.

22-09-2003
YOUR 307 CC IN DETAIL97
BOOT Opening the boot 
Press and hold button Bon the
remote control to partially open the boot, or press button Con the
boot.Locking/Unlocking from the inside Pressing button Apermits:
Ð locking of the vehicle,
Ð unlocking of the vehicle (and in particular the boot) if you place the key in the switch.
"Door open" or "boot open" warnings When the engine is running, if a door
or the boot is not closed correctly,you are warned by an audible signaland a diagram on the multifunctiondisplay for a few seconds. In addition, when the vehicle is mov- ing, the courtesy lights flash.To protect the boot against theft, but- ton Ccan be disarmed. Turn the lock
D a quarter of a turn to the right using
the key. The boot can only be opened using the remote control. The boot locks automatically when the vehicle is being driven at 6 mph(10 km/h). It unlocks when one of thedoors is opened, if the speed is
below 6 mph (10 km/h) and the keyis in the ignition. Closing the boot  Use the interior grab handles to close the boot.
 Press the centre of the boot withboth hands until it locks.

22-09-2003
YOUR 307 CC IN DETAIL97
BOOT Opening the boot 
Press and hold button Bon the
remote control to partially open the boot, or press button Con the
boot.Locking/Unlocking from the inside Pressing button Apermits:
Ð locking of the vehicle,
Ð unlocking of the vehicle (and in particular the boot) if you place the key in the switch.
"Door open" or "boot open" warnings When the engine is running, if a door
or the boot is not closed correctly,you are warned by an audible signaland a diagram on the multifunctiondisplay for a few seconds. In addition, when the vehicle is mov- ing, the courtesy lights flash.To protect the boot against theft, but- ton Ccan be disarmed. Turn the lock
D a quarter of a turn to the right using
the key. The boot can only be opened using the remote control. The boot locks automatically when the vehicle is being driven at 6 mph(10 km/h). It unlocks when one of thedoors is opened, if the speed is
below 6 mph (10 km/h) and the keyis in the ignition. Closing the boot  Use the interior grab handles to close the boot.
 Press the centre of the boot withboth hands until it locks.

22-09-2003
YOUR 307 CC IN DETAIL99
OPENING THE BONNET From inside:
push the handle on the
left-hand side under the fascia. From outside: lift the catch and
raise the bonnet. Bonnet strut Secure the strut to hold the bonnet open. Before closing the bonnet, replace the strut in its housing.
To close Lower the bonnet and release it at the end of its travel. Check that thebonnet is properly locked. "Bonnet open" warning With the engine running or the vehi- cle moving, flashing of the central
"STOP"
warning light accompanied
by an audible signal and a diagram
on the multi-function display, warnsyou that the bonnet is not properlyclosed. FILLING WITH FUEL Low fuel level
When the minimum fuel level in the tank isreached, this warninglight comes on.
You can still drive approximately30 miles (50 km). Flashing of the warning light indi-cates a malfunction of the fuelgauge.
Contact a PEUGEOT dealer. The engine must be switched off when filling with fuel. 
Open the fuel filler flap.
 Insert the key then turn it to the left.
 Remove the cap and hang it onthe hook located on the inside ofthe flap.
A label affixed to the inside of the fuelfiller flap indicates which type of fuelto use. When you fill your tank, do not con-
tinue after the third cut-off of the
pump. This could cause your vehicleto malfunction. The capacity of the tank is approxi- mately 60 litres.  After filling the tank, lock the cap and close the fuel filler flap.

22-09-2003
YOUR 307 CC IN DETAIL103
AUTOMATIC SWITCHING ON OF LIGHTS The side lights and dipped beam headlamps switch on automatically ifthe light is poor and when the wind-
screen wipers operate continuously.
They switch off when the light becomes bright enough or the wind-
screen wipers are switched off. This function is active when the vehi-
cle is supplied to the customer.
To disarm or activate the function:
Ð Place the key in the accessories
position (1st notch),
Ð Press the end of the lights stalk for more than four seconds.
Note: In foggy weather or in snow,
the brightness sensor can detect suf-
ficient light. As a result, the lights will
not come on automatically.
The brightness sensor, coupled
with the rain sensor, is located inthe centre of the windscreen,
behind the interior mirror. It isused for automatic switching onof the lights. Operating check ActivationActivation of this function is accom- panied by an audible signal and themessage
"Automatic lighting
active" on the multifunction display.
Disarming Disarming of the function is accom- panied by an audible signal. Note: the function is temporarily
disarmed when the driver uses the manual lighting controls. If the brightness sensor does not function correctly , the system acti-
vates the function (the lights come
on). The driver is alerted by an audi-ble signal, accompanied by the mes-sage "Auto lighting fault" on the
multifunction display.
Contact a PEUGEOT dealer to have the system checked.
Direction indicators (flashers)
Left: downwards.
Right: upwards.

22-09-2003
YOUR 307 CC IN DETAIL103
AUTOMATIC SWITCHING ON OF LIGHTS The side lights and dipped beam headlamps switch on automatically ifthe light is poor and when the wind-
screen wipers operate continuously.
They switch off when the light becomes bright enough or the wind-
screen wipers are switched off. This function is active when the vehi-
cle is supplied to the customer.
To disarm or activate the function:
Ð Place the key in the accessories
position (1st notch),
Ð Press the end of the lights stalk for more than four seconds.
Note: In foggy weather or in snow,
the brightness sensor can detect suf-
ficient light. As a result, the lights will
not come on automatically.
The brightness sensor, coupled
with the rain sensor, is located inthe centre of the windscreen,
behind the interior mirror. It isused for automatic switching onof the lights. Operating check ActivationActivation of this function is accom- panied by an audible signal and themessage
"Automatic lighting
active" on the multifunction display.
Disarming Disarming of the function is accom- panied by an audible signal. Note: the function is temporarily
disarmed when the driver uses the manual lighting controls. If the brightness sensor does not function correctly , the system acti-
vates the function (the lights come
on). The driver is alerted by an audi-ble signal, accompanied by the mes-sage "Auto lighting fault" on the
multifunction display.
Contact a PEUGEOT dealer to have the system checked.
Direction indicators (flashers)
Left: downwards.
Right: upwards.

22-09-2003
YOUR 307 CC IN DETAIL105
Automatic windscreen wipers In the
AUTOposition, the wind-
screen wipers operate automatically and adapt their speed to the inten-
sity of the rainfall.
Operating check ActivationWhen the function is activated, the message "Automatic wiping
active" appears on the multi-func-
tion display. Disarming In the event of malfunction , the dri-
ver is informed by an audible signal and the message "Auto wiper fault"
on the multi-function display. In the AUTOposition, the wind-
screen wiper will operate in intermit- tent mode.
Contact a PEUGEOT dealer to have the system checked. Do not cover the rain sen-sor located on the wind-screen behind the interior
mirror.
When using an automatic carwash, switch off the ignition orcheck that the wiper stalk is not inthe automatic position.
In winter, it is advisable to wait for the windscreen to completelyclear of ice before operating theautomatic wipe.