Peugeot 406 2002.5 Repair Manual

29-07-2002
Adjusting the bassWhen "BASS" is displayed, press button Hor Ito vary the setting.
"BASS –9" for a minimum bass setting,
"BASS 0" for a normal setting,
"BASS +9" for a maximum bass setting.
Adjusting the treble
When " TREB" is displayed, press button Hor Ito vary the setting.
"TREB –9" for a minimum treble setting,
"TREB 0" for a normal setting,
"TREB +9" for a maximum treble setting.
Adjusting the loudness
This function automatically emphasises bass and treble tones whe n the volume is low.
Press button Hor Ito switch the function on or off.
Adjusting the front/rear sound distribution (Fader)
When "FAD" is displayed, press button Hor Ito vary the setting.
Button Hincreases the volume in the front.
Button Iincreases the volume in the rear.
Adjusting the right/left sound distribution (Balance)
When "BAL" is displayed, press button Hor Ito vary the setting.
Button Hincreases the volume on the righthand side.
Button Iincreases the volume on the lefthand side.
Automatic volume correction "CAV"
This function enables the volume to be automatically adapte d depending on the level of noise produced by the speed of the vehicle.
Press buttons Hor I to switch the function on or off.
YOUR 406 IN DETAIL 87

29-07-2002
RADIO
Notes on radio reception
Car radio receivers are subject to phenomena which do not affect domestic radio sets. Both MW/LW and FM reception are
subject to various forms of interference. This is no reflection on the quality of the equipment, but is due to the nature of the
signals and the way in which they are transmitted.
On MW/LW, interference may be noticed when passing under high voltage power lines or bridges, or in tunnels.
On FM, interference may be the result of increasing distance from the transmitter, deflection of the signals by obstacles
(mountains, hills, buildings etc), or of being in an area wh ich is not covered by a transmitter.
Selecting radio mode Press button B.
Selecting a waveband Briefly press button Bto select the FM1, FM2, FMast and AM wavebands.
Automatic station search Briefly press button Kor Lto search for the station immediately above or below.
By continuing to press the button in the direction selected, you will obtain contin
uous scrolling of the frequency.
The scrolling stops at the first station found as soon as the button is released.
If the TA traffic programme is selected, only stations broadcasting this type of programme are selected.
Searching for a station occurs first in " LO" sensitivity (selection of the most powerful transmitters) during scan ning of the
waveband, then in " DX" sensitivity (selection of the weakest and most distant transmitte rs).
To make a direct search in " DX" sensitivity, press button Kor Ltwice.
YOUR 406 IN DETAIL
88

29-07-2002
Manual station searchPress the "MAN"button.
Briefly press button Kor Lto increase or decrease the frequency displayed.
By continuing to press the button in the direction selected, you will obtain continuous scrolling of the frequency.
The scrolling stops at the first station found as soon as the button is released.
Pressing the "MAN"button again returns you to automatic station search.
Manual storing of stations in the memory Select the station required.
Press one of the buttons "1"to "6" for more than two seconds.
The sound stops then becomes audible again, confirming that the station has been stored in the memory.
Automatic storing of FM stations in the memory (autostore) Press buttonBfor more than two seconds, to automatically store the 6 station s with the strongest signal in
FM. These stations are stored in the FM3 waveband.
If it is not possible to find 6 stations, the remaining me mories are empty.
Recalling stations stored in the memory
For each waveband, briefly press buttons "1"to "6" to recall the corresponding station.
YOUR 406 IN DETAIL 89

RDS
Using the RDS (Radio Data System) function on FMRadio Data System allows you to continue listening to the sa me station, whatever frequency it is using for
the region you are going through.
Briefly press the " RDS" button to switch the function on or off; the display wil l show:
"RDS" if the function is selected.
"(RDS)" if the function is selected but not available.
RDS station following
The display indicates the name of the station selected. The radio is continually searching for the station which has the best
reception and which is transmitting the same programme.
Traffic information programme
Press the "TA"button to switch the function on or off.
The display will show: "TA" if the function is selected,
" (TA) " if the function is selected but not available.
Any traffic information flash will be given priority, whatever source you are listening to (radio, CD or CD changer).
If you wish to interrupt a message, press the "TA"button; this switches the function off.
Note: the volume of traffic information announcements is inde pendent of the volume of normal radio listening. You
can adjust it using the volume button. The setting will be stored and will be used when the next messages are broad
cast.
Regional following mode
When they are part of a network, certain stations broadcast regi onal programmes in the various areas they
serve.
With regional following mode you can keep listening to th e same programme.
Press the " RDS" button for more than two seconds to switch the function on or off.
YOUR 406 IN DETAIL
90
29-07-2002

PTY functionThis allows you to listen to stations broadcasting a specific t ype of programme (news, culture, sport, rock etc.)
With FM selected, press the "TA"button for two seconds to switch this function on or off.
To search for a PTYprogramme:
select the PTYfunction,
briefly press button Kor Lto scroll down the list of the various types of pro
grammes offered.
when the programme of your choice is displayed, keep button Kor Lpressed for two seconds to carry out an automatic
search (after an automatic search the PTYfunction is switched off).
In PTY mode the different types of programmes can be stored in the
memory. To do this, press the preselection buttons " 1" to " 6" for more
than two seconds. To recall the type of programme stored in the
memory, briefly press the corresponding button.
EON system
This connects stations which are part of the same network. It en ables the broadcast of traffic information by a station, which
is part of the same network as the station to which you are li stening.
This service is available when you have selected the TA traffic i nformation programme or the PTYfunction.
YOUR 406 IN DETAIL 91
29-07-2002

29-07-2002
COMPACT DISC
Selecting CD player modeAfter inserting a disc, with the printed surface upwards, the p layer starts automatically.
If a disc is already inserted, press button C.
Ejecting a disc Press button E to eject the disc from the player.
Selecting a track Press button K to select the next track.
Press button Lto return to the start of the current track or to select the previ ous
track.
Accelerated play
Press the "MAN"button.
Press and hold button K or Lfor forwards or backwards accelerated play.
Accelerated play stops as soon as the button is released.
Buttons K or Lresume the "track selection" function when the "MAN"button is pressed again.
Shuffle (RDM) When the CD player is selected, keep button C pressed for two seconds. The tracks will be played in ran
dom sequence. Pressing button Cagain for two seconds returns you to normal play.
YOUR 406 IN DETAIL
92
The use of copied compact discs may cause malfunctions.

29-07-2002
CD CHANGER
Selecting CD changer modePress button D.
Selecting a disc Press buttons "1"to "6" to select the corresponding disc.
Selecting a track Press button Kto select the next track.
Press button Lto return to the start of the current track or to select the previ ous
track.
Accelerated play
Press the "MAN"button.
Press and hold button K or Lfor forwards or backwards accelerated play.
Accelerated play stops as soon as the button is released.
Buttons K or Lresume the "track selection" function when the "MAN"button is pressed again.
Shuffle (RDM) When the CD changer is selected, keep button D pressed for two seconds. The tracks will be played in ran
dom sequence. Pressing button D again for two seconds returns you to normal play.
YOUR 406 IN DETAIL 93

29-07-2002
YOUR 406 IN DETAIL
94
This is located inside the boot on the left hand side. I t holds up to 6 discs.
To insert a disc into the changer:
open sliding panel A,
press button Bto eject the cartridge C,
open one of the six compartments of the cartridge by pulling tab D,
insert the disc with the printed face upwards and close th e compartment,
insert the cartridge into the changer,
close the sliding panel A.
CD CHANGER
The use of copied compact discs can cause malfunctions.

29-07-2002
THE SATELLITE NAVIGATION
SYSTEM
Introduction
The satellite navigation system guides
you to the destination of your choice
by means of vocal and visual instruc
tions.
The heart of the system lies in the use
of a map database and GPS (Global
Positioning System). This enables
your position to be located by means
of several satellites.
The satellite navigation system con
sists of the following components:
the remote control,
the display,
the control unit,
the last voice message recall control,
the CD ROM.
Some functions or services
described in this guide may vary depending on the CD ROM version or the country.The remote control
There is a storage compartment for the remote control in front of the ashtray.
Pointing the remote control at the screen enables the informat ion contained in
the various menus to be selected.
Direction arrows:
These enable you to move around the screen and
thus select a function.
On the welcome screen only, the Up and Down
buttons enable the brightness of the screen to be
adjusted.
menu : this button allows access to the main menu. It can
be used at any time.
esc : escape button
"Short press": cancels the current operation and
returns to the previous screen.
"Press for more than 2 seconds": returns to the
welcome screen.
This button can be used in any menu. It is inactive
during guidance.
mod : mode button
"Short press": changes between date, navigation
and radio.
val : Confirmation button
Confirms the function selected.
YOUR 406 IN DETAIL 95

29-07-2002
The display
When the menus are used, the functions which appear at
the bottom of the screen are presented in various ways:
1.Function selected.
2. Function inaccessible in this situation.
3. Function accessible.
Note: The "List" function can hold a maximum of
80 addresses. During guidance the screen displays different information
depending on the manoeuvres to be carried out:
1.
Distance to next manoeuvre.
2. Next manoeuvre to be carried out.
3. Next road to take.
4. Time.
5. Exterior temperature.
6. Current road.
7. Distance to final destination.
8. Manoeuvre to be carried out.
YOUR 406 IN DETAIL
96
12
875
3
12364