Peugeot 406 2002.5 Service Manual

29-07-2002
YOUR 406 IN DETAIL
66
RADIO
Notes on radio reception
Car radio receivers are subject to phenomena which do not affect domestic radio sets. Both MW/LW and FM reception are
subject to various forms of interference. This is no reflection on the quality of the equipment, but is due to the nature of the
signals and the way in which they are transmitted.
On MW/LW, interference may be noticed when passing under high voltage power lines or bridges, or in tunnels.
On FM, interference may be the result of increasing distance from the transmitter, deflection of the signals by obstacles
(mountains, hills, buildings etc), or of being in an area wh ich is not covered by a transmitter.
Selecting radio mode Press the "SRC" button until the radio is selected.
Selecting a waveband Briefly press the " BAND/AST" button to select the FM1, FM2, FMast and AM wavebands.
Automatic station search Briefly press button Jor Kto search for the station immediately above or below.
By continuing to press the button in the direction selected, you will obtain contin
uous scrolling of the frequency.
The scrolling stops at the first station found as soon as the button is released.
If the TAtraffic programme is selected, only stations broadcasting this type of pro
gramme are selected.
Searching for a station occurs first in "LO"sensitivity (selection of the most powerful transmitters) during scann ing of the
waveband, then in "DX"sensitivity (selection of the weakest and most distant transmitters).

29-07-2002
YOUR 406 IN DETAIL67
Manual station search Press the "MAN" button.
Briefly press button Jor Kto increase or decrease the frequency displayed.
By continuing to press the button in the direction selected, you will obtain contin
uous scrolling of the frequency.
The scrolling stops at the first station found as soon as the button is released.
Pressing the " MAN" button again returns you to automatic station search.
Manual storing of stations in the memory Select the station required.
Press one of the buttons "1" to " 6" for more than two seconds.
The sound stops then becomes audible again, confirming that the station has been stored in the memory.
Automatic storing of FM stations in the memory (autostore) Press button "BND/AST" for more than two seconds, to automatically store the 6 statio ns with the strongest
signal in FM. These stations are stored in the FMast waveband.
If it is not possible to find 6 stations, the remaining me mories are empty.
Recalling stations stored in the memory
For each waveband, briefly press buttons " 1" to " 6" to recall the corresponding station.

29-07-2002
YOUR 406 IN DETAIL
68
RDS
Using the RDS (Radio Data System) function on FM Radio Data System allows you to continue listening to the sa me station, whatever frequency it is using for the
region you are going through.
Briefly press the " RDS" button to switch the function on or off.
RDS station following
The display indicates the name of the station selected. The radio is continually searching for the station which has the best
reception and which is transmitting the same programme.
Traffic information programme
Press the "TA" button to switch the function on or off.
Any traffic information flash will be given priority, whatever source you are listening to (radio, cassette or CD
changer).
If you wish to interrupt a message, press the " TA" button; this switches the function off.
Note: the volume of traffic information announcements is inde pendent of the volume of normal radio listening. You
can adjust it using the volume button. The setting will be stored and will be used when the next messages are
broadcast.
Regional following mode
When they are part of a network, certain stations broadcast regi onal programmes in the various areas they serve. With
regional following mode, you can keep listening to the same programme.
Press the " RDS" button for more than two seconds to switch the function on or off.

29-07-2002
YOUR 406 IN DETAIL69
CASSETTE
Selecting cassette mode When a cassette is inserted, the cassette player will start auto matically.
If a cassette is already inserted, press the " SRC" button until cassette mode is selected.
Ejecting the cassette
Fully press buttons Dand Eto eject the cassette from the player.
Direction of play The player will play sides 1 and 2 of the cassette alternate ly, by automatically reversing the direction of play
at the end of a side.
To manually reverse the direction of play, press buttons Dand Ehalfway.
Fast forward/rewind
Fully press button Dor Eto fast forward or rewind the cassette. At the end of the fa st forward/rewind, the set plays the cur
rent side.
Recommendations regarding the use of cassettes
Use good quality cassettes.
Do not use cassettes which play for more than 90 minutes.
Never expose the cassettes to heat or direct sunlight.
Retension the tape if necessary before inserting the cassette in the player.
Regularly clean the playing heads with a humid type cleani ng cassette.

29-07-2002
YOUR 406 IN DETAIL
70
CD CHANGER
Selecting CD changer mode Press the "SRC"button until CD changer mode is selected.
Selecting a disc Press buttons "1" to " 6" to select the corresponding disc.
Selecting a track Press button Jto select the next track.
Press button Kto return to the start of the current track or to select the previ ous
track.
Accelerated play
Press the " MAN" button.
Press and hold button Jor Kfor forwards or backwards accelerated play.
Accelerated play stops as soon as the button is released.
Buttons Jand Kresume the "track selection" function when the " MAN" button is pressed again.
Shuffle When the CD changer is selected, keep the " SRC" button pressed for two seconds. The tracks will be played
in random sequence. Pressing the " SRC" button again for two seconds returns you to normal play.

29-07-2002
YOUR 406 IN DETAIL
72
Angle your aerial, following
the line of the windscreen. Recommended angle for
the aerial (saloon)
AUDIO RM2
1 –
Press (behind)
2 – Press (behind) Function
Increase volume
Decrease volume
1+2 – Simultaneous
press
3 – Press Cutting off the sound (mute); restoring the sound
by pressing any button
Automatic search of higher frequencies (radio)
Selection of next track (CD and cassette)
4 – Press Automatic search of lower frequencies (radio)
Selection of previous track (CD and cassette)
5 – Press
the end Source selection (radio/cassette/CD changer)
6 – Rotation
(anticlockwise)
Selection of higher frequency station stored in memory (radio)
Selection of next CD Reversal of direction of play (cassette)
7 –Rotation
(anticlockwise) Selection of lower frequency station stored in
memory (radio) Selection of previous
CD Reversal of direction of play (cassette)
Movement

29-07-2002
ButtonFunction
A ON/VOL Radio on/off. Adjustment of volume.
B Radio selection. Selection of FM1, FM2, FMast and AM wavebands.
Press for more than 2 seconds: automatic storing of stations in the memory (autostore).
C Cassette selection. Reversal of the direction of play of the cassette.
Press for more than 2 seconds: noise reduction.
D CD changer selection.
Press for more than 2 seconds: shuffle.
EEjection of the cassette.
FT ATraffic information priority on/off.
Press for more than 2 seconds: PTY function on/off.
G RDS RDS function on/off.
Press for more than 2 seconds: regional following mode on/off.
H Increase bass/treble setting.
I Decrease bass/treble setting.
J AUDIO Adjustment of bass, treble, loudness ,sound distribution and
automatic volume correction.
K Automatic search of higher frequency.
Selection of next track cassette and CD.
L Automatic search of lower frequency.
Selection of previous track cassette and CD.
L MAN Manual/automatic operation of buttons Kand Lin radio mode.
1 to 6 12 34 56 Selection of station stored in the memory.
Press for more than 2 seconds: storing of a station in the memory.
Selection of a CD.
YOUR 406 IN DETAIL 73

29-07-2002
GENERAL FUNCTIONS
On/offWith the ignition key in the ACCESSORIES or IGNITION position , press button Ato switch the set on or off.
The set can operate for 30 minutes without the vehicle ign ition being switched on.
Antitheft system
The audio system is coded in such a way that it can operate on ly on your vehicle. It would not function if fitted to another
vehicle.
The antitheft system is automatic and requires no action on your part.
VOLUME SETTING
Adjusting the volume Turn button Ato increase or decrease the volume.
AUDIO SETTINGS Press the "AUDIO" button several times to access the bass (BASS), treble(TREB), loudness (LOUD), fader
(FAD) , balance (BAL)and automatic volume correction (CAV).
Exit from audio mode is automatic after a few seconds without p ressing any button, or by pressing the
" AUDIO " button after configuration of the automatic volume correction .
Note: bass and treble settings are specific to each source. It is possibl e to set them differently for radio,
cassette or CD changer.
YOUR 406 IN DETAIL
74

Adjusting the bassWhen "BASS" is displayed, press button Hor Ito vary the setting.
"BASS –9" for a minimum bass setting,
"BASS 0" for a normal setting,
"BASS +9" for a maximum bass setting.
Adjusting the treble
When " TREB" is displayed, press button Hor Ito vary the setting.
"TREB –9" for a minimum treble setting,
"TREB 0" for a normal setting,
"TREB +9" for a maximum treble setting.
Adjusting the loudness
This function automatically emphasises bass and treble tones whe n the volume is low.
Press button Hor Ito switch the function on or off.
Adjusting the front/rear sound distribution (Fader)
When " FA D" is displayed, press button H or I.
Button Hincreases the volume in the front.
Button Iincreases the volume in the rear.
Adjusting the right/left sound distribution (Balance)
When "BAL" is displayed, press button Hor I.
Button Hincreases the volume on the righthand side.
Button Iincreases the volume on the lefthand side.
Automatic volume correction "CAV"
This function enables the volume to be automatically adapte d depending on the level of noise produced by the speed of the vehicle.
Press buttons Hor I to switch the function on or off.
YOUR 406 IN DETAIL 75
29-07-2002

29-07-2002
RADIO
Notes on radio reception
Car radio receivers are subject to phenomena which do not affect domestic radio sets. Both MW/LW and FM reception are
subject to various forms of interference. This is no reflection on the quality of the equipment, but is due to the nature of the
signals and the way in which they are transmitted.
On MW/LW, interference may be noticed when passing under high voltage power lines or bridges, or in tunnels.
On FM, interference may be the result of increasing distance from the transmitter, deflection of the signals by obstacles
(mountains, hills, buildings etc), or of being in an area wh ich is not covered by a transmitter.
Selecting radio mode Press button B.
Selecting a waveband Briefly press button Bto select the FM1, FM2, Fmast and AM wavebands.
Automatic station search Briefly press button K or Lto search for the station immediately above or below.
By continuing to press the button in the direction selected, you will obtain contin
uous scrolling of the frequency.
The scrolling stops at the first station found as soon as the button is released.
If the TAtraffic programme is selected, only stations broadcasting this type of programme are selected.
Searching for a station occurs first in " LO" sensitivity (selection of the most powerful transmitters) during scan ning of the
waveband, then in " DX" sensitivity (selection of the weakest and most distant transmitte rs).
To make a direct search in " DX" sensitivity, press button Kor Ltwice.
YOUR 406 IN DETAIL
76