SSANGYONG KORANDO 2013 Service Manual

1. EXTERIOR LAMP
1) Overview
Exterior lamps can be divided into front, rear and side lamps as follows.
Front lamp: headlamp and fog lamp
Rear lamp: combination lamp, license lamp, high mounted stop lamp and reflex reflector lamp
Side lamp: outside turn signal lamp and puddle (approach) lamp -
-
-
2) Layout
Front side
Outside turn signal lamp and
puddle lamp
HeadlampFog lamp
Turn signal lamp
Headlamp
(high beam)Headlamp
(low beam)
Puddle lamp
Outside turn
signal lamp
Fog lamp
Tail lamp,
DRL (EU)*

8310-00
Rear combination lamp
Rear side
License plate lampReflex reflector lamp
High mounted stop lamp
Vehicle with spoilerVehicle without spoiler
Tail lamp
Stop lamp,
Rear fog
light (EU)Turn signal
lamp
Backup lamp
Stop lamp

3) Operating Process
(1) Headlamp (high/low beam) operation process
The headlamp is usually operated by the multifunction switch or by the REKES or smart key through the
BCM.
The BCM controls the headlamp and tail lamp according to the signal from the AUTO light sensor
through LIN communication when the multifunction switch is in "AUTO" position.
Headlamp - low beam
Headlamp - high beam
DRL (Day Time Running Light)
DRL is the function to turn on the high beam and tail lamp without any intervention from the light
switch. DRL turns off the lamps when turning off the light switch. This is an additional safety device to
prevent the accident.

8310-00
(2) Tail lamp
Front
Rear
Tail lamp
Tail lamp
The tail lamp is operated by the BCM when the BCM receives a signal from the multifunction switch.
Tail lamp warning
The buzzer sounds for 10 seconds with the interval of 0.02 s ON and 1.38 s OFF when opening the
driver door with the key removed (without SKM)/with IGN OFF or ACC (with SKM) and tail lamp ON.
The buzzer stops its operation when turning off the tail lamp or closing the driver door during buzzer
operation. The buzzer stays ON when turning the tail lamp on again after turning it off during buzzer
operation. 1.
2.
Tail lamp auto turn-off
When opening and closing the driver door after turning off the ignition with the tail lamp ON, the tail
lamps go off automatically.
The tail lamps come on again when inserting the ignition key (without SKM) and turning on the ignition
(with SKM) after tail lamp auto OFF.
The tail lamp should not go off when turning on the tail lamp switch with the ignition key removed
(without SKM) and with power off or ACC ON (with SKM). -
-
-

(3) Auto light (LIN)
The auto light sensor unit is installed to the back side of the ECM mirror located upper center of the
windshield, and detects the illuminance change. The BCM communicates with the auto light sensor
when the ignition is turned on, and turns on or off the tail lamp and headlamp automatically according to
the signals from the sensor when the multifunction switch is set to AUTO light.
The BCM communicates with the rain sensor even if the multifunction switch is in tail lamp.
Auto light switch Automatic light sensor unit

8310-00
Control by BCM
The rain sensor & AUTO light module communicates with BCM with IGN ON. When the AUTO light
switch is in the AUTO position, the BCM controls the tail lamp and headlamp according to the LIN
communication data.

(4) License lamp operation process
When the corresponding lamp comes on and
goes off by operating the tail lamp, AUTO light,
high beam and low beam on the multifunction
switch, the license lamp also does.

Headlamp

8310-00