TOYOTA AVALON 2001 Service Repair Manual
Page 221 of 1897
BE0IF-03
I12533
Ignition Switch
Driver Side Junction Block
Defogger Relay
DEF Fuse
MIR HTR Fuse
Defogger Wire
Mirror Defogger
Heater Control Assembly
Defogger Switch
BE-66
- BODY ELECTRICALDEFOGGER SYSTEM
1670 Author: Date:
2001 AVALON (RM808U)
DEFOGGER SYSTEM
LOCATION
Page 222 of 1897
I12835
21
BE1ED-01
BE-120
- BODY ELECTRICALELECTRO CHROMIC MIRROR SYSTEM
1724 Author: Date:
2001 AVALON (RM808U)
INSPECTION
INSPECT ELECTRO CHROMIC INNER MIRROR OPERA-
TION
(a) Connect the positive (+) lead the battery to terminal 1 and
the negative (-) lead to terminal2.
(b) Shine an electric light on the mirror, and check that there
is battery positive voltage and mirror surface becomes
ºbrightº to ºdarkº.
If operation is not as specified, replace the inner mirror.
Page 223 of 1897
BE1EE-01
I12839
Driver Side Junction Block
ECU-IG No.1,2 FuseIgnition Switch
Electro Chromic Inner Mirror
- BODY ELECTRICALELECTRO CHROMIC MIRROR SYSTEM
BE-1 19
1723 Author: Date:
2001 AVALON (RM808U)
ELECTRO CHROMIC MIRROR SYSTEM
LOCATION
Page 224 of 1897
I03099
BE0B4-04
- BODY ELECTRICALENGINE IMMOBILISER SYSTEM
BE-181
1785 Author: Date:
2001 AVALON (RM808U)
INSPECTION
INSPECTION TRANSPONDER KEY COIL CONTINUITY
Check that continuity exists between terminal 1 and 2.
If continuity is not as specified, replace the coil.
Page 225 of 1897
BE0B3-1 1
I12540
Driver Side Junction Block
IGN Relay
Ignition Switch Assembly
Transponder Key Amplifier
Transponder Key Coil
Key Unlock Warning SwitchEngine Room Junction Block
EFI No. 2 Fuse
ECM
BE-180
- BODY ELECTRICALENGINE IMMOBILISER SYSTEM
1784 Author: Date:
2001 AVALON (RM808U)
LOCATION
Page 226 of 1897
BE0B2-14
START
Insert the key in the key cylinder.
Under registration
Registration completion
Remove the key.
Will you register the
next key?
NoSecurity indicator blinks until the first
key is inserted. The indicator lights up
after the key registration.
Security Indicator ON
Security Indicator
OFF
END Ye s
Security Indicator ON
(After the last key (sub-key)
has been registered, the indi-
cator goes off.)
BE-172
- BODY ELECTRICALENGINE IMMOBILISER SYSTEM
1776 Author: Date:
2001 AVALON (RM808U)
ENGINE IMMOBILISER SYSTEM
REGISTRATION PROCEDURE
1. KEY REGISTRATION IN AUTOMATIC REGISTRATION MODE
(a) Registration of a new transponder key.
HINT:
This must be done when you have installed a new ECM.
The new ECM is in the automatic key code registration mode. The already fixed number of key codes
for this ECM can be registered.
On this type of vehicle, up to 4 key codes can be registered.
In the automatic registration mode, the last key registered becomes sub-key.
Page 227 of 1897
1.8 Sec.
0.2 Sec.
0.25 Sec. 0.5 Sec.0.25 Sec.
1 Sec. Blinks Code 2-1 Code2-2
0.25 Sec.
0.25 Sec.0.5 Sec. 1 Sec.
- BODY ELECTRICALENGINE IMMOBILISER SYSTEM
BE-173
1777 Author: Date:
2001 AVALON (RM808U)
HINT:
When a key is not inserted in the key cylinder in the automatic registration mode, the security indicator
always lights on.
When the immobiliser system operations normally and the key is pull out, the security indicator blinks.
When key code registration could not be performed in the automatic registration mode, code 2-1 is
output from the security indicator and when inserting the already registered key, code 2-2 is output.
(b) Automatic registration mode completion
If completing the mode forcibly when more than 1 key code have been registered in the automatic reg-
istration mode, perform the following procedures.
After 1 more key code have been registered with master key, perform step (1) or (2) without pulling
the key out or inserting the already registered key.
(1) Depress and release brake pedal 5 times or more within 15 secs.
(2) With the hand-held tester, require automatic registration mode completion.
Page 228 of 1897
Will you register the
next key?
No Ye s
Insert already registered master key in the key
cylinder
Depress and release the acceleration pedal 5
times.
Depress and release the brake pedal 6 times,
and remove the master key.
Insert key to be registered in key cylinder.
Depress and release the acceleration pedal 1
time. (Security indicator blinks)
The registration mode completes when pulling
out the key within 10 secs. and the brake pedal
is depressed or after indicator is off 10 secs.
pass. Within 10 secs.Within 15 secs.
Within 20 secs.
Within 10 secs.
Within 10 secs.
After 60 secs. additional master key is regis-
tered. (Security indicator is OFF)
BE-174
- BODY ELECTRICALENGINE IMMOBILISER SYSTEM
1778 Author: Date:
2001 AVALON (RM808U)
2. REGISTRATION OF ADDITIONAL MASTER KEY
There are 2 ways for registration of additional master key, one is depressing brake pedal and acceleration
pedal and the other is using hand-held tester.
HINT:
It is possible to register up to 7 master key codes including the already registered key code.
When any operation time described below is over, registration mode completes.
When the next procedure is performed while the timer is working, the timer completes counting time,
then next timer starts.
(1) Depressing brake pedal and acceleration pedal:
Page 229 of 1897
Insert already registered master key in the key cylinder
and turn the ignition switch ON.
Listing hand-held tester select master key registration.
Remove the master key.
Insert key to be registered in key cylinder.
(Security indicator blinks)
After 60 secs., additional master key is registered.
(Security indicator OFF)
The registration mode completes when pulling out the key
within 10 secs. and the brake pedal is depressed or after
indicator is off 10 secs. pass.Within 20 secs.
Within 10 secs.
HINT:
Please follow the screen of the hand-held tester for more detailed procedure.
- BODY ELECTRICALENGINE IMMOBILISER SYSTEM
BE-175
1779 Author: Date:
2001 AVALON (RM808U)
(2) Using hand-held tester:
Page 230 of 1897
Will you register the
next key?
No Ye s
Insert already registered master key in the key
cylinder
Depress and release the acceleration pedal 4
times.
Depress and release the brake pedal 5 times,
and remove the master key.
Insert key to be registered in key cylinder.
Depress and release the acceleration pedal 1
time. (Security indicator blinks)
The registration mode completes when pulling
out the key within 10 secs. and the brake pedal
is depressed or after indicator is off 10 secs.
pass. Within 10 secs.Within 15 secs.
Within 20 secs.
Within 10 secs.
Within 10 secs.
After 60 secs. additional sub-key is registered.
(Security indicator is OFF)
BE-176
- BODY ELECTRICALENGINE IMMOBILISER SYSTEM
1780 Author: Date:
2001 AVALON (RM808U)
3. REGISTRATION OF ADDITIONAL SUB-KEY
There are 2 ways for registration of additional sub-key, one is depressing brake pedal and acceleration ped-
al and the other is using hand-held tester.
HINT:
It is possible top register up to 3 sub-key codes including the already registered key code.
When any operation time described below is over, registration mode completes.
When the next procedure is performed while the timer is working, the timer completes counting time,
then next timer starts.
(1) Depressing brake pedal and acceleration pedal: