ECU BMW MOTORRAD K 1200 RS 2004 Rider's Manual (in English)

22
Maintenance and care
2
Removing brake calipers
e Important:
When removing, avoid damage
to brake pipes, brake discs,
brake pads and the wheel rim
(apply masking tape if neces-
sary).
Do not scratch the rim when
forcing back the brake pads or
removing the calipers (apply
masking tape if necessary).
Do not damage the ABS sensor
cable, toothed ring or sensor.
 Remove the securing screws 1 for the left and right brake
calipers  Push the brake pads back a
little by lightly rocking the
brake calipers
 Carefully take off the left and right brake calipers 2
e Important:
To prevent damage to the brake
caliper and possible difficulty
when assembling: never apply
the brake lever when the brake
calipers have been removed.
L Note:
Check the brake pads
(
b 34) and have them replaced if
necessary.
Removing the front wheel
21
20k41bkg3.book Seite 22 Mittwoch, 26. Mai 2004 3:33 15

27
Maintenance and care
2
Installing brake calipers Carefully push brake calipers 2 over the brake
discs at left and right
Using 2screws 1 per caliper,
secure the brake calipers on
each side and tighten the
screws to the specified
torque
e Important:
Always have the tightening tor-
ques checked by a specialist
workshop, preferably an au-
thorised BMW Motorrad dealer.
X Tightening torque:
Brake caliper
securing screws ........... 30 Nm
Installing the front wheel
21
20k41bkg3.book Seite 27 Mittwoch, 26. Mai 2004 3:33 15

33
Maintenance and care
2
d Warning:
Motorcycle not equipped with
BMW Integral ABS
OE: when
assembly work has been
completed, depress the brake
pedal firmly several times to
check that the rear brake is
operating correctly.
BMW Integral ABS: once as-
sembly work on the brake cal-
ipers has been completed,
the brake lever has to be op-
erated after the ignition has
been switched on and self-di-
agnosis completed, in order
to ensure full operability.
e Important:
Always have the security of the
fasteners checked by a special-
ist workshop, preferably an au-
thorised BMW Motorrad dealer.
X Tightening torque:
Preload torque
wheel studs .................. 50 Nm
Tightening torque
wheel studs ................ 105 Nm
Central screw .............. 105 Nm
Fitted screw .................. 40 Nm
Brake-caliper screw ...... 40 Nm
OEOptional extra
Installing the rear wheel
576
20k41bkg3.book Seite 33 Mittwoch, 26. Mai 2004 3:33 15