high beam BMW MOTORRAD K 1200 RS 2004 Rider's Manual (in English)

37
Maintenance and care
2
Information on changing bulbs
Your motorcycle is equipped
with Digital Motor Electronic
(MOTRONIC) engine manage-
ment and a high-output ignition
system.
d Warning:
Only carry out work on the
electrical system when the
circuit has been interrupted
(switch off ignition). For
greater safety, disconnect
and insulate the negative bat-
tery lead.
When the engine is running or
the ignition is switched on, do
not touch any electrically live
components, terminals or
wiring.
–Risk of fatal accident!
e Important:
Your vehicle has a high-beam/
low-beam bulb, a brake-light
bulb/rear-light bulb, a parking-
light bulb, a bulb for the
number-plate light, and four
bulbs for the turn indicators.
If any of these bulbs fail, you
may have problems in seeing
and being seen.
You should therefore always
carry spare bulbs on the motor-
cycle.
L Note:
Do not touch the glass of new
bulbs with the fingers.
Use a clean, dry cloth to hold
the bulbs when inserting them.
Dirt deposits, in particular oil
and grease, interfere with heat
radiation from the bulb. This
leads to overheating and short-
ens the bulb’s operating life.
20k41bkg3.book Seite 37 Mittwoch, 26. Mai 2004 3:33 15

46
Maintenance and care
21
2
5
43
High-beam headlight
e Important:
Switch off the ignition before
changing a bulb.
L Note:
Do not touch the glass of new
bulbs with the fingers. Use a
clean, dry cloth to hold the
bulbs when inserting them.  Place the motorcycle on its
main stand
 Turn the handlebars all the way to the left
 Disengage retaining clip 1 on
one side first, then the other,
press down and disengage
from cover 2
 Remove the cover 2
 Disengage connector 3
 Press earth (ground) clip 5
down and disengage it
 Pull the bulb socket out of the
headlight housing using tab 4
Changing bulbs
20k41bkg3.book Seite 46 Mittwoch, 26. Mai 2004 3:33 15

49
Maintenance and care
2
Fuse assignment
Fuse box 1
1 Engine electronics ........ 10 A
2 Fuel pump, injection valves,
oxygen sensor,
diagnosis plug,
tank breather valve ........ 10 A
3 Horn, alarm system
OE... 10 A
4 Low beam headlight,
instrument lighting,
number-plate light ......... 7,5 A
5 High (main) beam
headlight ...................... 7,5 A
6 Parking light, tail light ..... 4 A
7 Instrument cluster ........... 4 A 8
Instrument cluster, control
unit fuel warning lamp,
fan relay .......................... 4 A
Fuse box 2
1 Fan relay,
fan left and right ........... 10 A
2 Cruise control ............... 10 A
3 Not used
4 Not used
5 Power socket I ............ 7,5 A
6 Optional accessories
plug ............................... 4 A
7 Heated
handlebar grip
OE ............ 4 A
8 Not used
OEOptional extra
Fuses
12
20k41bkg3.book Seite 49 Mittwoch, 26. Mai 2004 3:33 15

73
i
A – E
AAccessories, genuine BMW parts, 18
Annual Service, notes, 3
BBattery charging, 50
Removal, 52, 53, 54
Safety instructions, 50
Technical Data, 70
Warranty, 50
BMW Integral ABS, 63
Bore/stroke, 61
Brake caliper, installing Front wheel, 27
Brake caliper, removing Front wheel, 22
Rear wheel, 29
Brakes Brake fluid, 69
Minimum brake pad thickness, 34
Technical Data, 63
Wear indicator, 34
Bulbs
ChangingFront turn indicators, 40
Headlight, 44
High-beam headlight, 46
Number-plate light, 39
Parking light, 43
Rear turn indicators, 42
Tail/brake light, 38
Note, 37
Technical Data, 70
CCapacity Engine, 67
Gearbox, 68
Castor, 65
Cleaning/Care General notes, 55, 57
Paintwork damage, 58
Road salt, 57
Washing, 56
Cleaning/care Chrome, 58
Clutch, 62
Compression ratio, 61
Confirmation of odometer
change, 14
Confirmation of service work, 10, 11, 12, 13
Coolant, 69
DDimensions, 71
Displacement, 61
EElasticity, 72
Electrical system, 70
Engine Troubleshooting chart, 19, 20
Type, 61
Engine oil
Capacity, 67
Consumption, 61
Technical Data, 67
Viscosity, 67
Index
20k41bkg3.book Seite 73 Mittwoch, 26. Mai 2004 3:33 15