clock CADILLAC SRX 2007 1.G Owner's Manual

2. If it is visible, rst try to tighten the cable by
turning the wheel wrench clockwise until you
hear two clicks or feel it skip twice. You
cannot over-tighten the cable.
3. Loosen the cable then by turning the wrench
counterclockwise three or four turns.
4. Tighten the cable all the way and then loosen
it at least two times, if the spare tire has not
lowered.
If the spare tire did lower to the ground,
continue with Step 4 underRemoving the
Spare Tire and Tools on page 426.
If you still cannot lower the spare tire to the
ground, seeSecondary Latch System on
page 436.Removing the Flat Tire and
Installing the Spare Tire
To remove the at tire and install the spare, do
the following:
1. Loosen the wheel nuts, but do not remove
them yet, using the wheel wrench. Turn the
handle about 180 degrees, then ip the handle
back to the starting position. This avoids
taking the wrench off the lug nut for each turn.
429

{CAUTION:
Lifting a vehicle and getting under it to do
maintenance or repairs is dangerous
without the appropriate safety equipment
and training. The jack provided with your
vehicle is designed only for changing a
at tire. If it is used for anything else, you
or others could be badly injured or killed
if the vehicle slips off the jack. Use the
jack provided with your vehicle only for
changing a at tire.
4. Turn the wheel wrench clockwise to raise the
jack lift head until the jack just ts under the
vehicle.5. Raise the jack by turning the wheel wrench
clockwise until the slots in the jack head t
into the metal ange located behind the
triangle on the plastic molding as shown.
Notice:Using a jack to raise the vehicle
without positioning it correctly could damage
your vehicle. When raising your vehicle on
a jack, be sure to position it correctly under the
frame and avoid contact with the plastic
molding.
431

6. Put the compact spare tire near you.
7. Raise the vehicle by turning the wheel wrench
clockwise. Raise the vehicle far enough off
the ground for the compact spare tire to
t under the vehicle.8. Remove all the wheel nuts and take off the
at tire.
9. Remove any rust or
dirt from the wheel
bolts, mounting
surfaces and spare
wheel.
432

13. Lower the vehicle by attaching the wheel
wrench to the jack and turning the wrench
counterclockwise. Lower the jack completely.14. Tighten the wheel
nuts rmly in a
crisscross sequence,
as shown.
Do not try to put a wheel cover on the compact
spare tire. It will not t. Store the wheel cover
securely in the rear of the vehicle until you have the
at tire repaired or replaced.
434

To release the spare tire from the secondary latch,
do the following:
1. If the cable is not visible, start this procedure
at Step 3.
2. If the cable is visible,
place the wrench on
the hoist drive nut
and turn the wrench
counterclockwise
until approximately
6 inches (15 cm) of
cable is exposed.
3. Attach the wheel wrench to the jack and raise
the jack at least 10 turns.
4. Place the jack under the vehicle, ahead of the
rear bumper. Position the center lift point of
the jack under the center of the spare tire.5. Turn the wheel wrench clockwise to raise the
jack until it lifts the secondary latch spring.
6. Keep raising the jack until the spare tire stops
moving upward and is held rmly in place, this
lets you know that the secondary latch has
released.
7. Lower the jack by turning the wheel wrench
counterclockwise. Keep lowering the jack
until the spare tire is resting on the wheel
wrench.
437

8. Grasp the spare tire with both hands and pull
it out from under the vehicle.
9. Reach under the vehicle and remove the
wheel wrench and jack.10. Tilt the retainer and slip it through the wheel
opening when the spare tire has been
completely lowered.
11. Turn the wrench clockwise to raise the cable
back up if the cable is hanging.
Have the hoist assembly inspected as soon as
you can. You will not be able to store a spare tire
using the hoist assembly until it has been
repaired or replaced.
438

To store the spare tire and tools, do the following:
1. Lay the compact spare tire on the ground
at the rear of the vehicle. Position the
compact spare tire so that the valve stem is
pointed down facing the rear of the vehicle.
2. Lower the cable to the ground. SeeRemoving
the Spare Tire and Tools on page 426.3. Tilt the retainer downward and slip it through
the center hole of the spare tire.
Make sure the retainer is fully seated across
the underside of the wheel.
4. Attach the wheel wrench to the hoist shaft.
5. Turn the wheel wrench clockwise to lift
the spare tire.
6. When the tire is almost in the stored position,
turn the tire so that the valve stem is towards
the rear of the vehicle.
This will help when you check and maintain
tire pressure in the spare.
7. Raise the tire fully against the underside of
the vehicle. Continue turning the wheel
wrench until you feel more than two clicks.
This indicates that the compact spare
tire is secure and the cable is tight. The spare
tire hoist cannot be overtightened.
441

J Case Fuses Usage
BLWR Front Blower Motor Assembly
RPDB 2RRPDB (Right Side Rear
Power Distribution Box)
Mini Fuses Usage
FRNT
WASHERFront Washer Pump
SPARE Spare
SPARE Spare
AIRBAGSensing Diagnostic Module (SDM),
Occupant Sensor Display,
Instrument Cluster
ABS IGNAnti-lock Braking System Ignition,
Variable Effort Steering
IGN SW Ignition Switch, Immobilizer Module
ECM/TCM IGNEngine Control Module/Transmission
Control Module Ignition Power
MISC IGN Air Quality Sensor
EMISSION 1Pre 02 Sensors, Cam Phasor (V6),
Canister Purge (V6), Intake Manifold
Tuning Valve (V6)
SPARE Spare
Mini Fuses Usage
DISPLAYInstrument Panel Cluster, Climate
Control Module, Front Blower Relay,
Diagnostic Link Connector
BCM 2LED Instrument Panel Dimming,
Overhead Lamps, Vanity Lamps
EVEN COILSEven Ignition Coils, Even Fuel
Injectors
BCM 6Right Side Rear Stoplamp, Turn
Lamps, Key Capture Solenoid
RADIO Radio
ODD COILSOdd Ignition Coils, Odd Fuel
Injectors
BCM 1 Body Control Module (BCM) Power
LT HI BEAM Left Side High-Beam Headlamp
BCM 7/CLOCK Switch Dimming, Analog Clock
SPARE Spare
EMISSION 2Cooling Fan Relays, Air
Conditioning Clutch Relay, Post O2
Sensors, Mass Airow Sensor,
Canister Purge (V8)
ECM BATT Engine Control Module (ECM)
458

A
Accessories and Modications..................... 347
Accessory Power Outlet(s).......................... 186
Adding Equipment to Your
Airbag-Equipped Vehicle............................ 88
Additives, Fuel............................................ 350
Add-On Electrical Equipment....................... 454
Adjustable Throttle and Brake Pedal............ 120
Air Cleaner/Filter, Engine............................. 365
Air Conditioning........................................... 189
Airbag
Passenger Status Indicator....................... 202
Readiness Light....................................... 201
Airbag Sensing and Diagnostic
Module (SDM).......................................... 498
Airbag System............................................... 70
Adding Equipment to Your
Airbag-Equipped Vehicle......................... 88
How Does an Airbag Restrain?.................. 79
Passenger Sensing System....................... 81
Servicing Your Airbag-Equipped Vehicle..... 87
What Makes an Airbag Inate?.................. 79
What Will You See After an
Airbag Inates?...................................... 80Airbag System (cont.)
When Should an Airbag Inate?................. 77
Where Are the Airbags?............................. 73
All-Wheel Drive........................................... 392
All-Wheel-Drive (AWD) System.................... 284
Analog Clock............................................... 188
Antenna, Diversity Antenna System............. 272
Antenna, XM™ Satellite Radio
Antenna System....................................... 272
Anti-Lock Brake System (ABS).................... 279
Anti-Lock Brake, System Warning Light....... 205
Appearance Care
Aluminum or Chrome-Plated Wheels........ 449
Care of Safety Belts................................ 447
Chemical Paint Spotting........................... 451
Cleaning Exterior Lamps/Lenses.............. 448
Cleaning the Inside of Your Vehicle.......... 443
Fabric/Carpet........................................... 445
Finish Care.............................................. 448
Finish Damage......................................... 451
Instrument Panel, Vinyl, and
Other Plastic Surfaces.......................... 446
Leather.................................................... 446
Sheet Metal Damage............................... 450
Speaker Covers....................................... 447
507

Cleaning (cont.)
Underbody Maintenance........................... 451
Washing Your Vehicle.............................. 447
Weatherstrips........................................... 447
Windshield and Wiper Blades................... 449
Wood Panels........................................... 447
Climate Control System
Air Filter, Passenger Compartment........... 195
Dual......................................................... 189
Outlet Adjustment..................................... 194
Rear Air Conditioning System................... 195
Clock.........................................188, 242, 244
Collision Damage Repair............................. 500
Comfort Guides, Rear Safety Belt................. 39
Compact Spare Tire.................................... 442
Compass..................................................... 134
Control of a Vehicle..................................... 278
Coolant
Engine Temperature Gage........................ 207
Engine Temperature Warning Light........... 206
Heater, Engine......................................... 121
Surge Tank Pressure Cap........................ 371
Cooling System........................................... 374Cruise Control............................................. 174
Cruise Control Light.................................... 212
Cupholder(s)................................................ 154
Customer Assistance Information
Courtesy Transportation........................... 496
Customer Assistance for Text
Telephone (TTY) Users ......................... 491
Customer Assistance Offices.................... 491
Customer Satisfaction Procedure.............. 488
GM Mobility Reimbursement
Program............................................... 492
Reporting Safety Defects to
General Motors..................................... 505
Reporting Safety Defects to the
Canadian Government.......................... 504
Reporting Safety Defects to the
United States Government.................... 504
Roadside Service..................................... 493
Service Publications Ordering
Information........................................... 505
510