fog CITROEN C-ELYSÉE 2017 Handbook (in English)

4
Exterior
1
Key with remote control
3
6 -38
-
ope

ning / closing
-
A

nti-theft protection
-


starting
-


battery
5
Boot
4
3-44
-
ope

ning / closing
-
em

ergency control
Tyre repair kit

1
49 -153
6
Rear parking sensors
1
25-126
Towing a trailer

1
39
7
Changing bulbs
1
65-166
-

r
ear lights
-
3
rd brake light
-
l
icence plate lights
-

f

og light
8
Tank, misfuel prevention
1
29, 130
Running out of fuel (diesel)

1
48
9
CDS / ASR
7
7-79
Tyre pressure

1
83
Spare wheel

1
54-160
-
tools
-

r
emoving / refitting
Snow chains

1
36
Under-inflation detection

7
4-76
10
Doors
4

1- 42,
4
4
-
ope

ning / closing
-

C
entral locking
-
em

ergency control
Alarm

3
9- 40
Window controls

4
5
2
Lighting control stalk
6
4- 66
Daytime running lamps

6
6
Headlamp adjustment

6
7
Changing bulbs

1
61-164
-

f
ront lights
-

f
ront fog lights
-
si

de repeaters
To w i n g

17
7-178
Very cold climate screen(s)

1
39
3
Door mirrors
5
0 -51
4
Windscreen wipers
6
8
Changing a wiper blade

1
38
Over view

9
As a passenger, if you avoid connecting your
multimedia devices (film, music, video game
etc.), you will contribute towards limiting the
consumption of electrical energy, and so of
fuel.
Disconnect your portable devices before
leaving the vehicle.
Eco-driving
Eco-driving is a range of everyday practices that allow the motorist to optimise their fuel consumption and CO2 emissions.
Optimise the use of
your gearbox
With a manual gearbox, move off gently,
change up without waiting and drive by
changing up quite soon.
With an automatic or electronic gearbox, stay
in Drive D or Auto A, according to the type
of gearbox, without pressing the accelerator
pedal heavily or suddenly.
The gear efficiency indicator invites you to
engage the most suitable gear: as soon as the
indication is displayed in the instrument panel,
follow it straight away.
For vehicles fitted with an electronic or
automatic gearbox, this indicator appears only
in manual mode.
Drive smoothly
Maintain a safe distance between vehicles,
use engine braking rather than the
brake pedal, and press the accelerator
progressively. These practices contribute
towards a reduction in fuel consumption and
CO
2 emissions and also help to reduce the
background traffic noise.
If your vehicle has cruise control, make use of
the system at speeds above 25 mph (40 km/h)
when the traffic is flowing well.
Control the use of your
electrical equipment
Before moving off, if the passenger
compartment is too warm, ventilate it by
opening the windows and air vents before
using the air conditioning.
Above 30 mph (50 km/h), close the windows
and open the air vents.
Remember to make use of equipment that can
help keep the temperature in the passenger
compartment down (window blinds, etc.). Switch off the headlamps and fog lamp when
the level of light does not require their use.
Avoid running the engine before moving off,
particularly in winter; your vehicle will warm up
much faster while driving. Switch off the air conditioning as soon as the
desired temperature is attained.
Switch off the demisting and defrosting
controls, if not automatic.
Switch off the heated seat as soon as
possible.
.
Eco-driving

22
orService
Temporarily on. A minor fault has occurred
for which there is no specific
warning light. Identify the fault by reading the message shown in
the screen, such as, for example:
-
s aturation of the particle emissions filter (Diesel).
- t he power steering,
-

a m
inor electrical fault.
For any other faults, contact a
CITROËN dealer or a
qualified workshop.
Continuous. A major fault has occurred
for which there is no specific
warning light. Identify the fault by reading the message shown in
the screen and then contact a
CITROËN dealer or
qualified workshop.
Warning / indicator lamp
StateCause Action / Observations
Rear foglamp Fixed. The rear fog lamp has been
switched on using the ring on the
lighting control lever. Turn the ring on the lighting control lever to the rear to
switch off the rear fog lamp.
Stop & Star t Continuous. When the vehicle stopped (red
lights, traffic jams,...) the Stop &
Start system has put the engine
into STOP mode. The warning light goes off and the engine restarts
automatically in START mode, as soon as you want
to move off.
Flashes for a few
seconds, then goes
of f. STOP mode is temporarily
unavailable.
or
START mode is invoked
automatically. For more information on Stop & Star t
, refer to the
corresponding section.
Instruments

23
Warning / indicator lampStateCause Action / Observations
Front fog lights Continuous. The front fog lights are switched
on using the ring on the lighting
control lever. Turn the ring on the lighting control lever rear ward
once to switch off the front fog lights.
Left-hand
direction
indicator Flashing with buzzer.
The lighting stalk has been
pushed down.
Right-hand
direction
indicator Flashing with buzzer.
The lighting stalk has been
pushed up.
Dipped beam
headlights Continuous.
The lighting lever is in the
"Dipped beam headlights"
position.
Main beam
headlights Continuous.
The lighting lever has been
pulled towards you. Pull the lever to return to dipped beam headlights.
Foot on the
clutch Continuous.
In STOP mode of the Stop &
Start, the transition to START
mode has been rejected
because the clutch pedal is not
fully pressed down. With a manual gearbox, you must declutch fully to
allow the change to engine START mode.
1
Instruments

64
Lighting control
In some climate conditions (low
temperature, humidity), the presence
of mist on the internal sur face of the
headlamp and rear lamp glass is normal;
this disappears a few minutes after the
lights are switched on.
Selection ring for main lighting
mode
Lighting off (ignition off) / Daytime
running lights (engine running).
Turn the ring to align the desired symbol with
the marking.
Side lights only.
Dipped or main beam headlights.
Dipping the headlights
Pull the lever to switch the lighting
between dipped and main beam
headlights.
Display
Illumination of the corresponding indicator
light in the instrument panel confirms that the
lighting selected is on.
Fog light selection ring
The fog lights operate with the dipped and main
beam headlights.
Rear fog light only
F To switch it on, turn the ring for wards.
F T o switch it off, turn the ring backwards.
In the lighting off and side lights modes, the
driver can switch on the main beam headlights
temporarily ("headlight flash") by keeping the
lever pulled.
Lighting and visibility

65
Front fog lights and rear fog light
Move the ring by rotating it:
F A 1st time for ward to switch the front fog
lights on.
F

A 2nd time for ward to switch the rear fog
light on.
F

1
st time backward to switch the rear fog
light of f.
F

2
nd time backward to switch the front fog
lights of f. The fog lights and side lights remain on if the
dipped beams are switched off manually.
F

T
urn the ring towards the rear to switch
off the fog lights, the side lights will then
switch off.
In good or rainy weather, both day and
night, using the front fog lights and the
rear fog light is prohibited. In these
situations, the power of their beams may
dazzle other drivers. They should only be
used in fog or falling snow.
In these weather conditions, it is your
responsibility to switch on the fog lights
and dipped headlights manually as the
sunshine sensor may detect sufficient
light.
Do not forget to turn of the front fog lights
and the rear fog light as soon as they are
no longer necessary. Switching off the lights when the
ignition is switched off
On switching off the ignition, all of the
lights turn off immediately, except for
dipped beam if automatic guide-me-home
lighting is activated.
Switching on the lighting when
switching on the ignition
To reactivate the lighting control, rotate
the ring to the "0" position - lights off, then
to the desired position.
When the driver's door is opened, a
temporary audible signal warns you that
the vehicle's lighting is on.
The lighting, with the exception of the
side lights, switch off automatically after
a maximum duration of thirty minutes to
prevent discharging of the battery.
4
Lighting and visibility

161
Changing a bulb
The headlamps have polycarbonate
lenses with a protective coating:
F
d
o not clean them using a dr y or
abrasive cloth, nor with a detergent
or solvent product,
F

u
se a sponge and soapy water or a
pH neutral product,
F

w
hen using a high pressure washer
on persistent marks, do not keep the
lance directed towards the lamps or
their edges for too long, so as not to
damage their protective coating and
seals.
Changing a bulb should only be done after
the headlamp has been switched off for
several minutes (risk of serious burns).
F

D
o not touch the bulb directly with
your fingers, use a lint-free cloth.
It is essential only to use anti-ultraviolet
(UV) type bulbs, so as not to damage the
headlamp.
Always replace a failed bulb with a new
bulb with the same type and specification. In some climate conditions (low
temperature, humidity), the presence
of mist on the internal sur face of the
headlamp and rear lamp glass is normal;
this disappears a few minutes after the
lights are switched on.Front lamps
Halogen headlamps
1
Direction indicators (PY21W).
2 Main beam headlamps (H1).
3 Dipped beam headlamps (H7LL).
4 Side lamps (W5W).
Halogen lamps with daytime
running lamps and fog lamps
1 Direction indicators (PY21W).
2 Main beam headlamps (H1).
3 Dipped beam headlamps (H7LL).
4 Daytime running lamps / Sidelamps (LEDs).
5 Fog lamps (H11).
Light-emitting diodes (LEDs)
For the replacement of this type of lamp,
go to a
CITROËN dealer or a qualified
workshop.
8
In the event of a breakdown

163
Dipped beam headlamps
F Remove the protective cover by pulling the tab.
F

P
ush the entire module relative to the
support to unclip one of the two tabs.
F

O
nce the first tab is unclipped, release the
second tab.
F

R
emove the bulb connector.
F

R
emove the bulb and replace it.
To reassemble it, position the unit in the
housing and push until the two tabs "clip".
Make sure to replace the protective cover with
the tab facing upward.
Sidelamps
F Remove the protective cover by pulling on the tab.
F

R
emove the bulb connector.
F

R
emove the bulb and replace it.
For reassembly, carry out these operations in
reverse order.
Make sure to replace the protective cover with
the tab facing upward.
Foglamps
F Insert a flat screwdriver between the lamp and the housing.
F

P
ull and lever to unclip the housing.
F

R
emove the two fastening screws of the
module.
F

R
emove the module from its housing.
8
In the event of a breakdown

165
Rear lamps
1 Brake / position lamps (P21/5W).
2Direction indicators (PY21W).
3 Reversing lamps (W16W).
4 Fog lamp (P21/5W). These bulbs are changed from inside the boot:
F

O
pen the boot.
F
R
emove the access grille from the
corresponding side trim panel.
F
D
isconnect the lamp connector.
F
L
oosen and remove the nut.
F

F
rom the outside, cautiously remove the
lamp unit straight from its housing. F
R emove the four screws and lift off the bulb
h o l d e r.
F

T
urn the failed bulb a quarter of a turn and
replace it.
For reassembly, carry out these operations in
reverse order.
Take care to engage the lamp unit in its guides,
while keeping it in line with the vehicle.
Tighten sufficiently to ensure sealing, but
without damaging the lamp.
8
In the event of a breakdown

171
Fuse in the engine
compartment
The fusebox is placed in the engine
compartment near the battery (left-hand side).
Access to the fuses
F Unclip the cover
F C hange the fuse.
F

W
hen you have finished, close the cover
very carefully to ensure correct sealing of
the fusebox. Fuse no.
Rating Functions
F14 15 AHeated lower windscreen.
F15 5 AAir conditioning compressor.
F16 15 AFront fog lamps.
F18 10 A
Right-hand main beam headlamp.
F19 10 A
Left-hand main beam headlamp.
F29 40 A
Front wiper motor.
F30 80 APre-heater plugs (Diesel).
8
In the event of a breakdown