instrument panel CITROEN C-ELYSÉE 2022 Handbook (in English)

2
.
.
Instrument Panel 8
W arning and indicator lamps 9
I
ndicators

19
Distance recorders

2
4
Setting the date and time

2
4
Trip computer

2
6Remote control

2
9
Alarm

32
Doors

33
Boot

34
Window controls
3
6
Front seats 3 7
Rear bench seat 3 9
Steering wheel adjustment 4
0
Mirrors

4
0
Heating
4

1
Manual air conditioning
(without display screen)
4

2
Electronic air conditioning
(with display screen)

4
4
Front demist – defrost

4
5
Rear screen demist – defrost

4
6
Fittings
4

8Lighting control
5

1
Direction indicators
5
3
Headlamp adjustment
5
4
Wiper control stalk
5
4
Courtesy lamps
5
5
General safety recommendations
5
7
Hazard warning lamps
5
8
Horn 58
Emergency or assistance call 5 8
Electronic stability control (ESC)

6
0
Seat belts
6

2
Airbags


65
Child seats

6
8
Deactivating the passenger's front airbag
7

0
ISOFIX mountings
7

5
Child lock

7
9
Over view
Instruments Access
Ease of use and comfort Safety
Lighting and visibility
Eco-driving
Eco-driving 6
Contents

5
Instruments and controls (continued)
1
Headlamp adjustment
2
Deactivation of the DSC/ASR system
Stop & Start
Boot lid release
Alarm
3
Door mirrors adjustment
4
Steering wheel adjustment
5
Lighting control stalk
Direction indicators
6
Instrument panel
Warning and indicator lamps
Service indicator
Gear shift indicator ~ Gear efficiency
indicator
Distance recorders
7
Wiper control stalk
Trip computer
8
Horn
9
Speed limiter
Cruise control
.
Over view

6
Eco- driving
Optimise the use of your
gearbox
With a manual gearbox, move off gently
and change up without waiting. During
acceleration change up early.
With an automatic gearbox, give preference
to automatic mode and avoid pressing the
accelerator pedal heavily or suddenly.
Drive smoothly
Maintain a safe distance between vehicles,
use engine braking rather than the
brake pedal, and press the accelerator
progressively. These practices contribute
towards a reduction in fuel consumption and
CO
2 emissions and also help reduce the
background traffic noise.
Control the use of your electrical
equipment
Before moving off, if the passenger
compartment is too warm, ventilate it by
opening the windows and air vents before
using the air conditioning.
Above 30
mph (50 km/h), close the windows
and leave the air vents open.
Consider using equipment that can help
keep the temperature in the passenger
compartment down (sunroof blind and window
blinds, etc.).
Unless it has automatic regulation, switch off
the air conditioning as soon as the desired
temperature has been reached. Switch off the headlamps and foglamps when
the ambient light level does not require their
use.
Avoid running the engine before moving off,
particularly in winter; your vehicle will warm up
much faster while driving.
As a passenger, if you avoid connecting your
multimedia devices (film, music, video game,
etc.), you will contribute towards limiting the
consumption of electrical energy, and so of
fuel.
Disconnect your portable devices before
leaving the vehicle.
The gear shift indicator invites you to engage
the most suitable gear: as soon as the
indication is displayed in the instrument panel,
follow it straight away.
For vehicles fitted with an automatic gearbox,
this indicator appears only in manual mode. If your vehicle has cruise control, make use of
the system at speeds above 25
mph (40 km/h)
when the traffic is flowing well. Switch off the demisting and defrosting
controls, if these are not controlled
automatically.
Switch off the heated seat as soon as
possible.
Eco-driving is a range of everyday practices
that allow the motorist to optimise their fuel
consumption and CO
2 emissions.
Eco-driving

8
Instrument panel
Rev counter
Rev counter (x 1,000 rpm).
Display screen
AAutomatic gearbox information.
Gear shift indicator.
B Time.
C Range related to the fuel or the AdBlue
®
and the SCR system (miles or km).
or
Trip distance recorder.
D Fuel gauge / Diesel preheater.
E Ser vice indicator (miles or km)
then,
Odometer.
These two functions are displayed
successively when switching on the
ignition.
F Cruise control or speed limiter settings.
Speedometer
Speedometer (mph or km/h).
Control button
- Momentary information reminder:
• o n servicing,
•

o
n the remaining driving range with the
emissions fluid (AdBlue
®).
-
R
esetting of the selected function to zero
(trip distance recorder or ser vice indicator).
-

S

etting the time.
Instruments

19
Service indicator
Warning / indicator lampStateCause Actions / Comments
Service spanner Fixed, temporary
when the ignition is
switched on. Between 600
miles (1,000 km) and
1,800
miles (3,000 km) remain
before the next ser vice is due. The ser vice indicator is displayed for a few seconds
in the instrument panel. Depending on the version:
-

t
he distance recorder displays a line showing the
distance remaining (in miles or kilometres) before
the next ser vice is due.
-

a
n alert message indicates the distance remaining
(in miles or kilometres) as well as the period
before the next ser vice is due.
The service spanner disappears after a few seconds.
The alert may be triggered close to the due date.
Fixed, when the
ignition is switched
on. Less than 600
miles (1,000 km)
remain before the next ser vice is
due. The ser vice indicator is displayed for a few seconds
in the instrument panel. Depending on the version:
-

t
he distance recorder display line indicates the
distance remaining before the next ser vice is due.
-

a
n alert message indicates the distance remaining
as well as the period before the next ser vice is
due.
The ser vice spanner remains on to show that a
ser vice is required very soon.
The alert may be triggered close to the due date.
Indicators
1
Instruments

20
Warning / indicator lampStateCause Actions / Comments
Service spanner Flashing then fixed,
when the ignition is
switched on. Service overdue.
The ser vice indicator is displayed for a few seconds
in the instrument panel. Depending on the version:
-

t
he total distance recorder displays a line showing
the distance travelled since a ser vice was due.
The value is preceded by the "-" sign.
-

a
n alert message indicates that a ser vice is
overdue.
The ser vice spanner remains on until the ser vice has
been performed.
The alert is triggered when the due date has passed.
+ Flashing then fixed,
when the ignition
is switched on,
associated with the
service warning lamp.Ser vice overdue for BlueHDi Diesel
versions.
The ser vice indicator is displayed for a few seconds
in the instrument panel. Depending on the version:
-

t
he total distance recorder displays a line showing
the distance travelled since the ser vice was due.
The value is preceded by the "-" sign.
-

a
n alert message indicates that a ser vice is
overdue.
The ser vice spanner remains on until the ser vice has
been performed.
The alert is triggered when the due date has passed.
The distance indicated (in miles or
kilometres) is calculated according to the
mileage covered and the time elapsed
since the last ser vice.
Instruments

21
AdBlue® fluid range
indicators
Once the AdBlue® tank is on reser ve or after
detection of a fault with the SCR emissions
control system, when the ignition is switched
on, an indicator displays an estimate of the
distance that can be covered, the range, before
engine starting is prevented.
In the event of a simultaneous system fault and
low AdBlue
® level, the shortest range figure is
the one displayed.
In the event of the risk of
non-starting related to a
lack of AdBlue
®
The engine starting inhibition system
required by regulations is activated
automatically once the AdBlue
® tank is
e m pt y.
Range greater than 1,500

miles (2,400 km)
When switching on the ignition, there is no
automatic display of the range in the instrument
panel.
Resetting the service indicator
After each service, the service indicator must
be reset to zero.
Following this operation, if you wish to
disconnect the battery, lock the vehicle
and wait at least five minutes for the zero
reset to be taken into account.
Retrieving the service
information
You can access the ser vice information at any
time.
F
P
ress the trip distance recorder reset
button. The ser vice information is displayed
for a few seconds, then disappears.
The procedure for resetting to zero is as
follows:
F

S

witch off the ignition.
F

P

ress and hold the trip distance recorder
reset button.
F

S

witch the ignition on; the distance recorder
display starts a countdown.
F

R

elease the button when =0

is displayed;
the spanner disappears.
1
Instruments

22
Remaining range between 1,500 and 350 miles (2,400 and 600 km)
When driving, this message is displayed every
180 miles (300 km) until the fluid level has been
topped up.
The reser ve level has been reached; it is
recommended that you top up as soon as
possible.
It is recommended that you do not top up by
more than 10
litres of AdBlue.
For more information on AdBlue
® and
the SCR system , and, in particular,
on topping up the AdBlue
®, refer to the
corresponding section. Range below 350
miles (600 km)
When driving, this message is displayed every
30 seconds until the AdBlue level has been
topped up.
It is essential to top up as soon as possible and
before the tank is completely empty; other wise
it will not be possible to restart the engine after
the next stop.
When switching on the ignition, this warning
lamp comes on, accompanied by an audible
signal and the display of "NO START IN" and a
distance on the instrument panel, indicating the
driving range expressed in miles or kilometres
before engine starting is prevented –
(e.g. "NO START IN 900

miles" means
"Starting will be prevented in 900 miles").
When switching on the ignition, this warning
lamp flashes and the service warning lamp
comes on, accompanied by an audible signal
and the temporary display of "NO START
IN" and a distance on the instrument panel,
indicating the remaining range expressed in
miles or kilometres before engine starting is
prevented –
(e.g. "NO START IN 180 miles" means "Starting
will be prevented in 180 miles").
For more information on AdBlue
®
(BlueHDI engines) and, in particular, on
topping up, refer to the corresponding
section. Breakdown related to a lack of AdBlue
®
The AdBlue® tank is empty: the starting
inhibition system required by regulations
prevents starting of the engine.
To be able to restart the engine, it is
essential to add at least 4
litres of AdBlue
®
to its tank.
For more information on the AdBlue
® (BlueHDi
engines) , and, in particular, on topping up,
refer to the corresponding section. When switching on the ignition, this warning
lamp flashes and the service warning lamp
comes on, accompanied by an audible signal
and the temporary display of "NO START IN"
and 0

miles or km on the instrument panel –
("NO START IN 0

miles" means "Starting
prevented").
Instruments

23
If it is a temporary fault, the alert
disappears during the next journey,
after auto diagnosis checks of the SCR
emissions control system.
During the permitted driving phase
(between 650
and 0 miles (1,100 km and
0


km))
While driving, the message is displayed every
30

seconds while the fault with the SCR
emissions control system persists.
The alert is repeated when switching on the
ignition. Starting prevented
You have exceeded the authorised driving
limit: the starting inhibition system does
not allow the engine to be started.
To be able to restart the engine, you must call
on a CITROËN dealer or a qualified workshop.In the event of a fault with
the SCR emissions control
system
An engine starting inhibition device is
activated automatically after you have
driven a further 650 miles (1,100 km)
following confirmation of a fault with the
SCR emissions control system. Have the
system checked by a CITROËN dealer or
a qualified workshop as soon as possible.
In the event of the detection of a fault
These warning lamps come on, accompanied
by an audible signal and the display of the
message "Emissions fault".
The alert is triggered while driving as soon
as the fault is detected for the first time, then
when switching on the ignition for subsequent
journeys, while the fault persists. If a fault with the SCR system is confirmed
(after 30
miles (50 km) covered with the
permanent display of the message signalling
a fault), these warning lamps come on and the
AdBlue warning lamp flashes, accompanied
by an audible signal and the temporary display
in the instrument cluster of NO START IN
and a distance, indicating the driving range
expressed in miles or kilometres before engine
starting is prevented – (e.g. "NO START IN
350
miles" means "Starting will be prevented in
350


miles").You should go to a CITROËN dealer or a
qualified workshop as soon as possible.
Other wise you will not be able to restart the
vehicle.
When switching on the ignition, these warning
lamps comes on and the AdBlue warning lamp
flashes, accompanied by an audible signal and
the temporary display of "NO START IN" and
0
miles or kilometres on the instrument panel –
("NO START IN 0
miles" means "Starting
prevented").
1
Instruments

24
Distance recorders
Total distance recorder
System which measures the total distance
travelled by the vehicle during its life.
Trip distance recorder
System which measures a distance travelled
during a day or other period since it was reset
to zero by the driver.
The total and trip distances are displayed for
thirty seconds when the ignition is switched off,
when the driver's door is opened and when the
vehicle is locked or unlocked. F

W
ith the ignition on, press the button until
zeroes appear.
Setting the date and time
Instrument panel
Use the left-hand button on the instrument
panel to carry out the operations in the
following order:
F

P
ress the button for more than two seconds:
the minutes flash.
F

P
ress the button to increase the minutes.
F

P
ress the button for more than two seconds:
the hours flash.
F

P
ress the button to increase the hours.
F

P
ress the button for more than two seconds:
24
H or 12 H is displayed.
F

P
ress the button to select 24 H or 12 H.
F

P
ress the button for more than two seconds
to complete the adjustments.
The usual screen displays again when the
button hasn't been pressed for approximately
30


seconds.
Instruments