Citroen C4 RHD 2014 2.G Owner's Guide

19
FAMILIARISATION

Passenger's front airbag
Seat belts and passenger's
front airbag
Ignition switch



1.
Open the glove box.

2.
Insert the key.

3.
Select the position:
"OFF"
(deactivation), with "rear fac-
ing" child seat,
"ON"
(activation), with front pas-
senger or "forwards facing" child
seat.

4.
Remove the key keeping the switch
in the new position.



142


A.
Front left seat belt not fastened / un-
fastened warning lamp.

B.
Front right seat belt not fastened /
unfastened warning lamp.

C.
Rear right seat belt unfastened
warning lamp.

D.
Rear centre seat belt unfastened
warning lamp.

E.
Rear left seat belt unfastened warn-
ing lamp.

F.
Passenger's front airbag deactivat-
ed warning lamp.

G.
Passenger's front airbag activated
warning lamp.



138, 142


1.
Stop
position.

2.
Ignition on
position.

3.
Starting
position.



80
When switching the ignition on or off,
the speedometer needle and the rev
counter and fuel gauge bars go full
travel and then return to 0.
PASSENGER SAFETY - STARTING

20

Electric parking brake


Manual application / release
Automatic application / release

Before leaving the ve-
hicle, check that the
brake warning lamp in
the instrument panel
and the P
warning lamp in the control
lever A
are on fi xed (not fl ashing)
.
Manual application
of the parking
brake is possible by pulling
the control
lever A
.
With the ignition on, manual release
of
the parking brake is possible by press-
ing the brake pedal
and pulling then
releasing
the control lever A
. Press the accelerator pedal and let the
clutch pedal up (manual gearbox), the
parking brake is released automatically
and progressively as you move off.
With the vehicle at rest, on switching off
the engine the parking brake is applied
automatically.



145

With the engine running, on
opening the driver's door there
is an audible warning; apply the
parking brake manually.
Do not leave a child alone inside
the vehicle with the ignition on;
they might release the parking
brake. If you are towing a trailer or car-
avan or if the slope might vary
(transport on a ferry, lorry, tow-
ing...) make a maximum manual
application with a long pull on
the control lever A
to immobilise
the vehicle. If this warning lamp is on in the
instrument panel, the automat-
ic application / release
is de-
activated
; apply and release
the parking brake manually.
DRIVING SAFELY

21
FAMILIARISATION

Electronic gearbox

Displays in the instrument panel
Moving off

This 6-speed gearbox offers a choice
between the comfort of fully automatic
operation or the pleasure of manual
gear changing.


1.
Gear lever.

2.
Steering mounted "-"
control paddle.

3.
Steering mounted "+"
control paddle.

The gear engaged or the driving mode
selected appears on the instrument
panel screen.

N.
Neutral.

R.
Reverse.

1 to 6.
Gear engaged.

AUTO.
Automated mode.


Select position N
and press the
brake pedal fi rmly while starting the
engine.


Engage fi rst gear by pulling the gear
lever 1
towards position A
or M
,
or
engage reverse by pushing the gear
lever 1 towards position R
.


Release the parking brake.


Take your foot off the brake pedal
then accelerate.



153



DRIVING SAFELY

22

Automatic gearbox


This six-speed gearbox offers the
choice between the comfort of automat-
ic operation or the pleasure of manual
gear changing.


1.
Gear lever.

2.
"S"
(sport)
button.

3.
" 
"
(snow)
button.

Displays in the instrument panel

Moving off



With your foot on the brake, select
position P
or N
.


Start the engine.


Then select position R
, D
or M
.


Take your foot off the brake pedal,
then accelerate away.



156




Hill start assist

The driving mode selected and/or the
gear engaged appear in the left hand
instrument panel screen.

P.
Park.

R.
Reverse.

N.
Neutral.

D.
Drive (automatic operation).

S.
S

port
programme.



.
Snow
programme.

1 to 6.
Gear engaged.

-.
Invalid value in manual opera-
tion. Your vehicle is fi tted with a system
which holds your vehicle stationary mo-
mentarily, the time to move your foot
from the brake to the accelerator, to
help with moving off on a gradient.
This function is only active when:


- the vehicle is completely station-
ary with your foot on the brake pedal,

- certain conditions of gradient are met,

- the driver's door is closed.



159
Do not get out of the vehicle dur-
ing the hill start assist temporary
holding phase.
DRIVING SAFELY

23
FAMILIARISATION

Stop & Start


Engine going into STOP mode
Engine going into START mode
Deactivation / Reactivation
In certain circumstances the STOP
mode may not be available; the "ECO"

warning lamp fl ashes for a few seconds
then goes off.

- with a manual gearbox;
at speeds
below 12 mph (20 km/h), when you
put the gear lever into neutral, and
you release the clutch pedal,

- with an electronic gearbox;
at
speeds below 5 mph (8 km/h), when
you press the brake pedal or you
put the gear lever in position N
.



163


- with a manual gearbox;
when you
fully
depress the clutch pedal,

- with an electronic gearbox;



●
with the gear lever in position A

or M
, when you release the brake
pedal,

●
or gear lever in position N
and
brake pedal released, when you
change to position A
or M
,

●
or engage reverse.

In certain circumstances, START mode
may engage automatically; the "ECO"

warning lamp fl ashes then goes off.



164
You can deactivate the system at any
time by pressing the "ECO OFF"
button;
the button's warning lamp comes on.



164

The "ECO"
warning lamp goes
off and the engine restarts au-
tomatically:
The "ECO"
warning lamp comes on
in the instrument panel and the engine
is put into standby automatically:
The system is reactivated auto-
matically every time you start the
engine with the key.

Before refuelling or doing any-
thing under the bonnet, you
must switch off the ignition with
the key.
DRIVING SAFELY

24

Blind spot sensors
Parking space sensors

One of these messages appears to in-
dicate the level of diffi culty of the ma-
noeuvre:



Activate the function by pressing
control switch A
; the button's warn-
ing lamp comes on.
The warning lamp located in the door
mirror comes to warn you of the arrival
of a vehicle in the blind spot detection
zone.



166



Select the function by pressing
control switch B
; the correspond-
ing warning lamp comes on in the
instrument panel.


Operate the direction indicators on
the side with the space to be meas-
ured; a message appears to confi rm
measurement is in progress.


Drive at a speed below 12 mph
(20 km/h) during measurement.

- Parking possible.


- Parking diffi cult.


- Parking not advised.





174


DRIVING SAFELY

25
FAMILIARISATION

Speed limiter "LIMIT"
Cruise control "CRUISE"
Display in the instrument panel


Cruise control

1.
Limiter mode On / Off.

2.
Decrease the programmed value.

3.
Increase the programmed value.

4.
Speed limiter On / Off.

5.
Display the list of memorised
speeds.


169




170


1.
Cruise control mode On / Off.

2.
Programme a speed / Decrease the
programmed value.

3.
Programme a speed / Increase the
programmed value.

4.
Cruise control Off / Resume.

5.
Display the list of memorised speeds.


169




172
The cruise control or speed limiter
mode appears in the instrument panel
when it is selected.
The values must be set with the engine
running.
In order to be programmed or activated,
the vehicle speed must be higher than
25 mph (40 km/h), with at least fourth
gear engaged on a manual gearbox
(second gear for an electronic or auto-
matic gearbox).
Speed limiter


DRIVING SAFELY

26
Eco-driving is a range of everyday practices that allow the motorist to optimise their fuel consumption and CO2 emissions.


Optimise the use of your
gearbox

With a manual gearbox, move off gen-
tly and change up without waiting.
During acceleration change up early.

With an automatic or electronic gear-
box, give preference to automatic mode
and avoid pressing the accelerator
pedal heavily or suddenly.


Drive smoothly


Maintain a safe distance between ve-
hicles, use engine braking rather than
the brake pedal, and press the accel-
erator progressively. These practices
contribute towards a reduction in fuel
consumption and CO
2 emissions and
also helps reduce the background traf-
fi c noise.

If your vehicle has cruise control, make
use of the system at speeds above
25 mph (40 km/h) when the traffi c is
fl owing well.



Control the use of your
electrical equipment

Before moving off, if the passenger
compartment is too warm, ventilate it
by opening the windows and air vents
before using the air conditioning.
Above 30 mph (50 km/h), close the
windows and leave the air vents open.
Remember to make use of equipment
that can help keep the temperature
in the passenger compartment down
(sunroof and window blinds...).
Switch off the air conditioning, unless
it has automatic regulation, as soon as
the desired temperature is attained.
Switch off the demisting and defrosting
controls, if not automatic.
Switch off the heated seat as soon as
possible.

The gear effi ciency indicator invites
you to change up: as soon as the in-
dication to change up is displayed in
the instrument panel, follow it straight
away.
With an electronic or automatic gear-
box, this indicator appears only in
manual mode.

















































ECO-DRIVING

27

Switch off the headlamps and front
foglamps when the level of light does
not require their use.

Avoid running the engine before moving
off, particularly in winter; your vehicle
will warm up much faster while driving.

As a passenger, if you avoid connecting
your multimedia devices (fi lm, music,
video game...), you will contribute to-
wards limiting the consumption of elec-
trical energy, and so of fuel.
Disconnect your portable devices be-
fore leaving the vehicle.



Limit the causes of excess
consumption

Spread loads throughout the vehicle;
place the heaviest items in the bottom
of the boot, as close as possible to the
rear seats.
Limit the loads carried in the vehicle
and reduce wind resistance (roof bars,
roof rack, bicycle carrier, trailer...). Use
a roof box in preference.
Remove roof bars and roof racks after
use.

At the end of winter, remove snow
tyres and refi t your summer tyres.



Observe the recommendations
on maintenance

Check the tyre pressures regularly,
when cold, referring to the label in the
door aperture, driver's side.
Carry out this check in particular:


- before a long journey,

- at each change of season,

- after a long period out of use.
Don't forget the spare wheel and the
tyres on any trailer or caravan.

Have your vehicle serviced regularly
(engine oil, oil fi lter, air fi lter...) and ob-
serve the schedule of operations rec-
ommended by the manufacturer.



When refuelling, do not continue after
the third cut-off of the nozzle to avoid
any overfl ow.


At the wheel of your new vehicle, it is only
after the fi rst 1 800 miles (3 000 kilometres)
that you will see the fuel consumption set-
tle down to a consistent average.

1
MONITORING
28

















TWO-TONE INSTRUMENT PANEL WITHOUT AUDIO SYSTEM

Dials and screens



1.
Rev counter (x 1 000 rpm or tr/min).

2.
Gear effi ciency indicator or gear se-
lector lever position and gear for an
electronic or automatic gearbox.

3.
Cruise control or speed limiter setting.

4.
Digital speedometer (mph or km/h).

5.
Engine oil level indicator.
6.
Service indicator
(miles or km) then,
total mileage recorder.
These two functions are displayed
successively on switching on the ig-
nition.
Lighting dimmer setting (when mak-
ing an adjustment).

7.
Trip mileage recorder (miles or km).

8.
Fuel gauge and associated low fuel
level warning lamp ( a
or b
accord-
ing to version).

9.
Time.



Control buttons



A.
Lighting dimmer (available in night
mode).

B.
Reminder of servicing information
Reset service indicator or trip mile-
age recorder.

A
and B.
Setting the time and select-
ing units.