bulb Citroen DS3 2014 1.G Owner's Manual

103
DS3_en_Chap05_amenagement_ed01
To remove the shelf:
F  u nhook   the   two   cords,
F
 
r
aise   the   shelf   slightly,   then   unclip   it   on  
e

ach   side.
Rear parcel shelf
F Raise   the   boot   carpet   by   pulling   the   strap  u
pwards   to   gain   access   to   the   storage   box.
This
  has   areas   for   storing   a   temporary   puncture  
r

epair   kit,   a   box   of   spare   bulbs,   a   first   aid   kit,  
t

wo   warning   triangles,   ...
Storage box
F refit  the   boot   floor   carpet   by   folding   it  s
lightly   in   the   middle.
Fittings

DS3_en_Chap10_info-pratiques_ed01-2014
Practical information
This section describes the use of the temporary puncture repair kit, the procedures   for   changing   a   punctured   wheel,   a   worn   wiper   blade   and   the  
v

arious   bulbs   and   fuses,   as   well   as   advice   on   charging   the   battery,   towing  
t

he   vehicle,   maintenance   recommendations   and   information   on   the   range  
o

f   accessories   available   from   the   dealer   network.

215
DS3_en_Chap10_info-pratiques_ed01-2014
Changing a bulb
The headlamps are fitted with polycarbonate   glass   with   a   protective  
c

oating:
F

d
o not clean them using a dr y
or abrasive cloth, nor with a
detergent or solvent product,
F
 
u
se   a   sponge   and   soapy   water   or   a  
p

H neutral product,
F
 
w
hen   using   a   high   pressure  
w

asher   on   persistent   marks,   do   not  
k

eep   the   lance   directed   towards  
t

he   lamps   or   their   edges   for   too  
l

ong,   so   as   not   to   damage   their  
p

rotective   coating   and   seals.
Halogen headlamps
1. direction indicators (PY21W amber).
2. S
idelamps (W5W).
3.
M

ain beam headlamps (H1-55W).
4.
di

pped beam headlamps (H7-55W).
5.
F

ront foglamps (PSX24W).
6.
L

E d
la
mps (LE d s).
Changing
 
a
 
bulb
 
should
 
only
 
be
 
done
 
a

fter
 
the
 
headlamp
 
has
 
been
 
switched
 
o

ff
 
for
 
several
 
minutes
 
(risk
 
of
 
serious
 
b

urns).
F

D

o not touch the bulb directly with
your
 
fingers,
 
use
 
a
 
lint-free
 
cloth.
It
 
is
 
imperative
 
to
 
use
 
only
 
anti-
ultraviolet (UV) type bulbs to avoid
damaging
 t

he
 h

eadlamp.
al

ways replace a failed bulb with a
new
 
bulb
 
with
 
the
 
same
 
type
 
and
 s
pecification.
Practical information

DS3_en_Chap10_info-pratiques_ed01-2014
changing direction indicator
bulbs
Rapid flashing of the direction indicator warning   lamp   (right   or   left)   indicates   the  
f

ailure   of   a   bulb   on   that   side.
F

T

urn the bulb holder a quarter of a turn and
extract
  it.
F
 
P

ull   out   the   bulb   and   change   it.
To refit, carry out these operations in reverse
o r d e r.
changing dipped beam headlamp
bulbs
F Remove   the   protective   cover   by   pulling   the  t
ab.
F
 
D
isconnect   the   bulb   connector.
F
 
S
pread   the   springs   to   release   the   bulb.
F
 
P
ull   the   bulb   out   and   change   it.
To refit, carry out these operations in reverse
o r d e r.
Amber
 
coloured
 
bulbs,
 
such
 
as
 
the
 
d

irection
 
indicators,
 
must
 
be
 
replaced
 
w

ith bulbs of identical specifications
and
 
colour.
When
 
refitting,
 
close
 
the
 
protective
 
c

over
 
carefully
 
to
 
preserve
 
the
 
sealing
 
o

f
 
the
 
headlamp.

217
DS3_en_Chap10_info-pratiques_ed01-2014
changing main beam headlamp bulbschanging sidelamp bulbs
F Remove  the   protective   cover   by   pulling   the  t
ab.
F
 
D
isconnect   the   bulb   connector.
F
 
S
pread   the   springs   to   release   the   bulb.
F
 
R
emove   the   bulb   and   change   it.
To refit, carry out these operations in reverse
o r d e r. F
 R emove   the   protective   cover   by   pulling   the  t
ab.
F
 
P
ull   the   bulb   holder   pressing   on   the   tabs   on  
bo

th
 s
ides.
F
 
P
ull   the   bulb   and   change   it.
To refit, carry out these operations in reverse
o r d e r.
LEd* / Xenon front lamps
* LED: light-emitting diode.
1.

di
rection indicators (LE
ds
).
2.
S
idelamps (LE d s).
3.
di
pped beam headlamps (Xenon).
4.
M
ain beam headlamps (LE
ds / Xe
non).
5.
da
ytime running lamps (LE d s).
6.
F
ront foglamps (PSX24W).
For   replacements   on   of   these   types   of   lamps  
(

LED   /   Xenon),   contact   a   CITROËN   dealer   or   a  
q

ualified
 w
orkshop.
Practical information

DS3_en_Chap10_info-pratiques_ed01-2014
To obtain a replacement module, contact your CITRoË N dealer or a
qualified
 w

orkshop.
If
  you   experience   any   difficulty   in  
r

eplacing   bulbs,   contact   your   CITROËN  
d

ealer   or   a   qualified   workshop.changing front foglamp bulbs
F Access  to   the   front   foglamp   is   through   the  a
perture   below   the   bumper.
F
 
D
isconnect   the   black   bulb   holder  
c

onnector,   by   pressing   on   the   tab   at   the  
t

op.
F
 
R
emove   the   bulb-holder   by   pressing   on   the  
2

  clips   (at   the   top   and   the   bottom).
F
 
R
eplace   the   module.
To refit, carry out these operations in reverse
o r d e r.
changing integrated direction
indicator side repeaters
F Insert a screwdriver towards the centre of the repeater between the repeater and the
base
  of   the   door   mirror.
F
 
T
ilt   the   screwdriver   to   extract   the   repeater  
a

nd   remove   it.
F
 
D
isconnect   the   repeater   connector.
F
 
R
eplace   the   module.
To
  refit,   carry   out   these   operations   in   reverse   order.
Contact a CITR
oË

N dealer or
a
  qualified   workshop   to   obtain   a  
r

eplacement   side   repeater   module.

DS3_en_Chap10_info-pratiques_ed01-2014
1. Brake lamps / sidelamps (P21/5W).
2. Sidelamps (P5W).
3.
di

rection indicators (PY21W amber)
4.
F

oglamp, offside (PR21W red)


R
eversing lamp, nearside (P21W).
Rear lamps
Amber or red bulbs, such as those for the direction indicators and rear
foglamp,
  must   be   replaced   by   bulbs   of  
t

he   same   rating   and   colour.
changing bulbs
F Open  the   boot.
F  R emove   the   access   flap   from   the  
c

orresponding   side   trim   panel.
F
 
U
nscrew   the   butter fly   nut   securing   the  
lam

p
 u
nit.
F
 
U
nclip   the   lamp   unit   connector.
F
 
E
xtract   the   lamp   unit   carefully   pulling   in   its  
m

iddle   towards   the   outside. F
 S pread   the   four   tabs   and   remove   the   bulb  h
o l d e r.
F

T
urn the bulb a quarter of a turn and
change
 it

.
To refit, carry out these operations in reverse
o r d e r.
Take
  care   to   engage   the   lamp   unit   in   its   guides,  
w

hile   keeping   it   in   line   with   the   vehicle.

221
DS3_en_Chap10_info-pratiques_ed01-2014
changing direction indicator (4)
and foglamp or reversing
lamp
(5) bulbs
F Turn   the   bulb   a   quarter   turn   and   change   it.
changing LEd sidelamps and
brake lamps (LEds )
For the replacement of this type of LED lamp, c
ontact a CITRoË N dealer or a qualified
workshop.
3d rear lamps
Access to the bulbs
F Open   the   boot.
F  R emove   the   access   flap   from   the  
c

orresponding   side   trim   panel.
F
 
U
nscrew   the   butter fly   nut   securing   the  
lam

p
 u
nit.
F
 
U
nclip   the   lamp   unit   connector.
F
 
E
xtract   the   lamp   unit   carefully   pulling   it   in  
l

ine   towards   the   outside.
To
  refit,   carry   out   these   operations   in   reverse   order.
Take
  care   to   engage   the   lamp   unit   in   its   guides,  
w

hile   keeping   it   in   line   with   the   vehicle.
1.
3

d
L

E
d
s

idelamps (LE
d
s).
2. L
Ed
brake lamps / sidelamps (LEds
).
3. L
E
d la
teral sidelamps (LE
d
s).
4.
di

rection indicators (PY21W amber)
5.
F

oglamp, offside (H21W red)


R

eversing lamp, nearside (H21W).
Amber
 
or
 
red
 
bulbs,
 
such
 
as
 
those
 
f

or the direction indicators and rear
foglamp,
 
must
 
be
 
replaced
 
by
 
bulbs
 
of
 
t

he
 
same
 
rating
 
and
 
colour.
Practical information

DS3_en_Chap10_info-pratiques_ed01-2014
Third brake lamp (4 W5W bulbs)
F Open  the   boot.
F  R emove   the   plugs   A   on   the   inner   panel.
F
 
P
ush   on   the   centre   of   the   lamp   using   two  
s

crewdrivers   to   lever   it   outwards.
F

D
isconnect the connector and if necessary
the
  screenwash   pipe   from   the   lamp.
F

T
urn the bulb holder for the faulty bulb a
quarter
  of   a   turn.
F
 
P
ull   out   the   bulb   and   change   it.
To refit, carry out these operations in reverse
o r d e r.
Third brake lamp (LEds )
For the replacement of this type of LED lamp, c
ontact a CITRoË N dealer or a qualified
workshop.
changing the number plate lamp
bulbs (W5W)
F Insert a thin screwdriver into one of the outer   holes   of   the   lens.
F
 
P
ush   it   outwards   to   unclip.
F
 
R
emove   the   lens.
F
 
P
ull   the   bulb   out   and   change   it.

223
DS3_en_Chap10_info-pratiques_ed01-2014
Interior lighting
Interior lamp (1 / W5W)
Detach the cover of the interior lamp 1 with a
t hin screwdriver, close to the button, to access
the
  faulty   bulb.
Map reading lamps (2 / W5W)
Detach the cover of the interior lamp 1.   To  a
ccess the faulty bulb, detach the partition for
the
  reading   lamp   2  
c
oncerned.
Boot lamp (W5W)
Detach the unit by pushing it rear wards.
Footwell and central storage
lamps (W5W)
Detach the unit for access to the bulb.
Glove box lamp (W5W)
Detach the unit for access to the bulb.
Practical information