ignition DODGE VIPER 2008 ZB II / 2.G Workshop Manual
[x] Cancel search | Manufacturer: DODGE, Model Year: 2008, Model line: VIPER, Model: DODGE VIPER 2008 ZB II / 2.GPages: 303, PDF Size: 2.65 MB
Page 211 of 303

Battery Save Feature
The Battery Save feature conserves battery power when
storing the vehicle. It allows for up to 3 months of storage
time without losing radio and engine controller memory.
Using this feature is an alternative to disconnecting the
battery.
NOTE:This vehicle is designed to sit in storage with a
fully charged battery for up to 30 days. If you plan to
store the vehicle longer than 30 days, we recommend
doing one of the following:
²Disconnect the battery.
²Use the battery charger.
²Put the vehicle into Battery Save mode (3-month
charge).
To Activate the Battery Save Feature:
1. Insert the key into the ignition switch.2. Cycle the ignition switch from OFF/LOCK to ACC
four times. Leave the switch in the OFF/LOCK position
after the fourth cycle.
3. Push the driver's Power Door Lock switch in the UP
direction. A single chime will sound and the horn will
chirp to indicate that the process has begun.
Ignition Key Positions
210 MAINTAINING YOUR VEHICLE
Page 212 of 303

4. Remove the key from the ignition switch and exit the
vehicle. The Battery Save Feature will be enabled 45
seconds after all doors are closed.
NOTE:
²Turning the ignition switch to the ON/RUN position
at any time will cancel activation of the Battery Save
Feature.
²The remote keyless entry and the exterior passenger
door handle will not work when the Battery Save
feature is enabled. Enter the vehicle by using the key to
unlock the door manually and by using the exterior
driver door handle to open the door.
²The Vehicle Security Alarm is disabled when the
Battery Save Feature is enabled. Therefore, the vehicle
is not protected when the Battery Save Feature is
enabled.
²The exterior and interior lighting functions will not
work when the Battery Save Feature is enabled.
To Deactivate the Battery Save Feature:
1. Press the exterior driver's door handle once to wake
up the vehicle. Then, press the handle again to open the
door.
NOTE:If the door does not open (vehicle is armed),
press the remote keyless entry unlock button to unlock
the vehicle.
2. Insert the key into the ignition switch.
3. Turn the ignition switch to the ON/RUN position. The
Battery Save Feature will turn off.
NOTE:If the ignition switch is NOT turned to ON/
RUN position, the Battery Save Feature will be enabled
45 seconds after the driver's door is closed.
MAINTAINING YOUR VEHICLE 211
7
Page 220 of 303

Cooling System
WARNING!
²When working near the radiator cooling fans,
disconnect each fan motor lead or turn the ignition
switch to the OFF position. The fans are tempera-
ture controlled and can start any time the ignition
switch is in the ON position.
²You or others can be badly burned by hot coolant
or steam from your radiator. If you see or hear
steam coming from under the hood, don't open the
hood until the radiator has had time to cool. Never
try to open a cooling system pressure cap when the
radiator is hot.
Coolant Checks
Check engine coolant (antifreeze) protection every 12
months (before the onset of freezing weather, where
applicable). If coolant is dirty or rusty in appearance, the
system should be drained, flushed, and refilled with
fresh coolant. Check the front of the A/C condenser/
radiator for any accumulation of bugs, leaves, etc. If dirty,
clean by gently spraying water from a garden hose
vertically down the face of the condenser/radiator.
Check the coolant recovery bottle tubing for brittle rub-
ber, cracking, tears, cuts, and tightness of the connection
at the bottle and radiator. Inspect the entire system for
leaks.
With the engine at normal operating temperature (but
not running), check the cooling system pressure cap for
proper vacuum sealing by draining a small amount of
coolant from the radiator drain cock. If the cap is sealing
properly, the engine coolant (antifreeze) will begin to
MAINTAINING YOUR VEHICLE 219
7
Page 235 of 303

FUSES (POWER DISTRIBUTION CENTERS)
Fuses (Power Distribution Center)
A power distribution center is located in the engine
compartment on the driver's side of the vehicle. This
center contains fuses and relays.
Cavity Car-
tridge
FuseMini
FuseDescription
1 40 Amp
GreenÐ Blower Motor
2 40 Amp
GreenÐ Anti-Lock Brakes (ABS)
Pump Feed/Starter
3 30 Amp
PinkÐ Body Control Module
(BCM) - Battery Feed
4 20 Amp
BlueÐ Amplifier
5 30 Amp
PinkÐ Ignition Switch Run/
Accessory Feed -
Windows/Adjustable Ped-
als
6 40 Amp
GreenÐ Body Control Module
(BCM) - Battery Feed
7 30 Amp
PinkÐ Anti-Lock Brakes (ABS)
Module
Power Distribution Center
234 MAINTAINING YOUR VEHICLE
Page 236 of 303

Cavity Car-
tridge
FuseMini
FuseDescription
8 30 Amp
PinkÐ Ignition Switch Run/
Accessory Feed
9 40 Amp
GreenÐ Headlights
10 30 Amp
PinkÐ Ignition Switch Run Feed
11 Ð 20 Amp
YellowAuto Shutdown Relay
(ASD)
12 Ð 20 Amp
YellowCigar Lighter
13 Ð 15 Amp
BlueHazard Flasher
14 Ð 20 Amp
YellowAuto Shutdown Relay
(ASD)
15 Ð 20 Amp
YellowRear Window Defogger
(EBL)Cavity Car-
tridge
FuseMini
FuseDescription
16, 17 Ð 20 Amp
YellowSelectable Power Outlet
18 Ð 15 Amp
BlueIgnition Off Draw (IOD)
19 Ð 15 Amp
BlueHorn
20 Ð 15 Amp
BlueAir Conditioning (A/C)
Clutch Relay
21 Ð 15 Amp
BlueStop Light Switch
22 Ð 25 Amp
ClearFuel Pump/Powertrain
Control Module (PCM)
23, 24 Ð 10 Amp
RedAirbag
60, 61 Ð 15 Amp
BlueIgnition Run/Start Relay
Feed
MAINTAINING YOUR VEHICLE 235
7
Page 266 of 303

Miles 93,000 96,000 99,000 102,000 105,000 108,000
(Kilometers) (155 000) (160 000) (165 000) (170 000) (175 000) (180 000)
Changeengine oilandengine oil filter,if not
replaced at 3 months.XXXXXX
Rotate the tires.LLXXX
Inspect and replace theengine air cleaner fil-
terif necessary.X
Replace thespark plugs.X
Replace theignition cables.X
Flush and replace the engine coolant, if not
replaced at 60 months.X
Inspect and replace the Auto Tension Drive
Belt if necessary. ³X
Change the transmission fluid. X
Inspect the transmission fluid.X
SCHEDULE ªBº 265
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S
Page 273 of 303
![DODGE VIPER 2008 ZB II / 2.G Workshop Manual Miles 96,000 102,000 108,000 114,000 120,000
(Kilometers) (160 000) (170 000) (180 000) (190 000) (200 000)
[Months] [96] [102] [108] [114] [120]
Changeengine oilandengine oil filter. X XXXX
Rotate th DODGE VIPER 2008 ZB II / 2.G Workshop Manual Miles 96,000 102,000 108,000 114,000 120,000
(Kilometers) (160 000) (170 000) (180 000) (190 000) (200 000)
[Months] [96] [102] [108] [114] [120]
Changeengine oilandengine oil filter. X XXXX
Rotate th](/img/12/5689/w960_5689-272.png)
Miles 96,000 102,000 108,000 114,000 120,000
(Kilometers) (160 000) (170 000) (180 000) (190 000) (200 000)
[Months] [96] [102] [108] [114] [120]
Changeengine oilandengine oil filter. X XXXX
Rotate the tires.LLX XXXX
Inspect and replace theengine air cleaner filterif
necessary.X
Inspect and replace thePCV valveif necessary. X
Replace thespark plugs.X
Replace theignition cables.X
Flush and replace the engine coolant, if not re-
placed at 60 months.X
Flush and replace the engine coolant, if not re-
placed at 102,000 miles.X
Inspect and replace the Auto Tension Drive Belt if
necessary. ³XXX
Inspect the transmission fluid. X X
272 SCHEDULE ªAº
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S
Page 293 of 303

Hazard
Driving Through Flowing, Rising, or
Shallow Standing Water................. 140
Hazard Warning Flasher.................99,176
Headlights..........................81,243
Aiming............................. 251
High Beam........................... 83
High Beam/Low Beam Select Switch......... 83
Lights On Reminder..................... 82
Passing.............................. 84
Switch............................... 81
Time Delay........................... 81
Heater.............................122,123
High Beam Indicator...................... 97
High Beam/Low Beam Select (Dimmer) Switch . . . 83
Hood Latch Maintenance.................. 215
Hood Release........................... 79
Hoses.............................224,225
Hydraulic Clutch Fluid.................... 228Ignition............................... 12
Key ................................. 12
Timing.............................. 205
Wiring System (Spark Plug Wires).......... 205
Ignition Key Removal..................... 12
Illuminated Entry........................ 16
Infant Restraint........................50,51
Inflation Pressure Tires.................... 101
Inside Rearview Mirror.................... 75
Instrument Cluster........................ 96
Instrument Panel and Controls............... 95
Instrument Panel Lens Cleaning............. 232
Interior Lighting.......................81,84
Interior Lights.........................84,85
Intermittent Wipers (Delay Wipers)............ 87
Introduction............................. 4
Jump Starting.......................... 186
292 INDEX
Page 302 of 303

Windshield Wiper Blades.................. 217
Windshield Wipers....................... 87
Wiper Blade Replacement.................. 217Wipers, Intermittent....................... 87
Wiring, Ignition (Spark Plug Wires)........... 205
INDEX 301
10