ESP FIAT PANDA 2009 169 / 2.G 100HP Supplement Manual

7
FIAT PANDA 100HP
DRIVING STYLE
Acceleration
Accelerating violently increasing the revs
will greatly affect consumption and emis-
sions: to contain fuel consumption accel-
eration should be gradual.
Using the SPORT function, fuel consump-
tion will be slightly higher than the values
stated in paragraph “Fuel consumption” in
this Supplement.
WARNING LIGHTS
AND MESSAGES
SPORT FUNCTION
(green)
The word SPORT on the in-
strument panel will turn on when the cor-
responding function is activated by press-
ing the relevant button. Pressing the but-
ton again will turn off the SPORT indica-
tion.SPORT
TYPES OF BULBS
Bulbs Type Power
Additional
brake light 12V 6W 6W
(third brake light)
603_97_390 Panda 100 HP GB:603_97_390 Panda 100 HP GB 7-10-2009 17:06 Pagina 7

8
FIAT PANDA 100HPfig. 9F0G0647m
If the car needs to be jacked up on one side, place the slot of the jack in correspon-
dence with the arrow (
O) on the side member: the finish under the floor is interrupted
A-fig. 9to enable fitting the jack on the groove fig. 9.
JACKING THE CAR
WITH THE JACKWITH ARM HOIST
fig. 10F0G0711m
If the car needs to be jacked up, go to a
Fiat Dealership which is equipped with
shop jacks and jack arms.
Jack up the car only by positioning the jack
arms or the shop jack in the points shown
in fig. 10.
When jacking the car using
shop jack or jack arms, make
sure the arms are not inter-
fering with the car side skirts.
603_97_390 Panda 100 HP GB:603_97_390 Panda 100 HP GB 7-10-2009 17:06 Pagina 8

12
FIAT PANDA 100HP
If the oil level is near or even below the
MINmark, add oil through the filler neck
A, until reaching the MAXmark.
Oil level shall never exceed the MAX
mark.
Use engine oil with specifications de-
scribed in paragraph “Fluids and Lubri-
cants” in section “Technical Specifications”
of the Owner Handbook this Supplement
is attached to.
ENGINE OIL CONSUMPTION
Max engine oil consumption is usually 400
grams every 1000 km.
When the car is new, the engine needs
to run in, therefore the engine oil con-
sumption can only be considered stabilised
after the first 5.000 ÷ 6.000 km.
IMPORTANT The oil consumption de-
pends on driving style and the conditions
under which the car is used.
IMPORTANT After adding or changing
the oil, let the engine turn over for a few
seconds and wait a few minutes after turn-
ing it off before you check the level. ENGINE OIL fig. 12
Check the oil level a few minutes (about
5) after the engine has stopped, with the
car parked on level ground.
The oil level shall be included between
marks MINand MAXon the dipstick B.
The gap between MINand MAXmarks
corresponds to about one litre of oil.
fig. 12F0G649m
Do not add oil with specifica-
tions other than that already
in the engine.
Used engine oil and filter con-
tain harmful substances for
the environment. Contact Fi-
at Dealership to have the oil
and filter changed, as they are
equipped to dispose of the waste oil
and filters respecting the nature and
the law.
When the engine is hot, take
care when working inside the
engine compartment to avoid burns.
Remember that when the engine is
hot, fan may cut in: danger of injury.
Scarves, ties and other loose cloth-
ing might be pulled by moving parts.
WARNING
603_97_390 Panda 100 HP GB:603_97_390 Panda 100 HP GB 7-10-2009 17:06 Pagina 12

14
FIAT PANDA 100HP
ENGINE CODES - BODYWORK VERSIONS
Version Engine code Body version
Fiat Panda 100HP169A3000 169AXE1B 0H
ENGINE
GENERAL INFORMATION
Engine code
Cycle
Number and layout of cylinders
Piston bore and stroke mm
Total displacement cm3
Compression ratio
Maximum power (EEC) kW
HP
corresponding ratio rpm
Maximum torque (EEC) Nm
kgm
corresponding ratio rpm
Spark plugs
FuelFiat Panda 100HP
169A3000
Otto
4 in line
72 x 84
1368
11
73.5
100
6000
131
13.4
4250
NGK DCPR7E - N - 10
Unleaded petrol, 95 RON (Specification EN228)
603_97_390 Panda 100 HP GB:603_97_390 Panda 100 HP GB 7-10-2009 17:06 Pagina 14

18
FIAT PANDA 100HP
Fiat Panda 100HP
975
390
730
660
1365
800
400
50
60
WEIGHTS
Weights (kg)
Kerb weight
(including fuel, space-saver spare wheel,
tools and accessories):
Payload (*) including the driver:
Maximum admitted loads (**)
– front axle:
– rear axle:
– total:
Towable loads
– trailer with brakes:
– trailer without brakes:
Maximum load on roof:
Maximum load on tow hitch
(trailer with brakes):
(*) If special equipment is fitted (tow hitch, etc.) the unladen car weight increases, thus reducing the specified payload.
(**) Loads not be exceeded. The driver is responsible for arranging the loads in the boot and/or on the roof so that they comply
with these limits.
603_97_390 Panda 100 HP GB:603_97_390 Panda 100 HP GB 7-10-2009 17:06 Pagina 18