brake light FIAT PANDA 2009 169 / 2.G 4x4 Supplement Manual

3
FIAT PANDA 4 x 4
ELD - ELECTRONIC
LOCKING
DIFFERENTIAL
(for versions/markets, where provided)
The ELD (Electronic Locking Differential)
is a further aid when driving or starting the
car in poor grip conditions (snow, ice,
mud, etc.) since it enables to distribute
power adequately to the same axle when
one or more wheels are slipping.
The ELD actually brakes the wheels that
are loosing grip (or that are slipping more
than others) and it transmits power to
wheels having best grip.
This function can be turned on manually
by pressing the ELD button in the dash-
board and works below a level of 50 km/h.
When this speed is exceeded, it is auto-
matically deactivated (the LED in the ELD
button remains on) and it is reactivated as
soon as the speed goes below the level
of 50 km/h.ELD operation
At start-up the ELD system is off.
To turn the ELD system on, press button
fig. 1; the relevant button led will turn on.
The activation of the ELD system involves
the following functions being switched on:
– Permanent four wheel drive, so that the
vehicle is more responsive;
– Inhibition of the ASR function, in order
to fully exploit the engine torque;
– Differential lock effect on the front and
rear axles, via the braking system, to im-
prove drive on uneven surfaces.
If there is a problem with the ELD system,
the (ESP) warning light will come on con-
stantly.4 x 4 Drive - Signals
The warning light in fig. 2-3provides two
different types of signals:
❒signalling with flashing light: this indi-
cates that the differential lock function
(ELD) is activated, for versions with ESP
only and with the ELD button pressed;
fig. 1F0G0605mfig. 2F0Z0743m
fig. 3F0Z0742m
603_97_560 PANDA 4X4 Euro 5 GB 11-12-2009 9:31 Pagina 3

4
FIAT PANDA 4 x 4
❒signalling with light on constantly: this
indicates that there is a problem with
the 4 x 4 drive; go to a Fiat Dealership
as soon as possible (where provided,
the display will show a dedicated mes-
sage). In addition, on versions with ESP,
if the ELD is on, the LED in the button
will go out.HEADLIGHT WASHER
(for versions/markets, where provided)
The headlight washing system consists of
two nozzles for washing the external
headlight lens. This function can be acti-
vated using the windscreen washer stalk
only if dipped beams or main beams are
on. Operating the stalk to wash the wind-
screen will automatically start the head-
light washer.
This version features a windscreen wash-
er fluid reservoir with improved capaci-
ty, i.e.: 4.5 litres.
IF A TYRE
IS PUNCTURED
General instructions
The vehicle may come (for versions/mar-
kets where provided) with either a space-
saver wheel or Fix & Go quick tyre repair
kit.
Wheel changing and correct use of the jack
and space-saver spare wheel call for some
precautions as listed in the Owner Hand-
book this Supplement is attached to. In the
Owner Handbook you will also find how
to use the Fix & Go kit (quick tyre repair
kit).
To change a wheel proceed as follows:
❒stop the car in a position that is not
dangerous for oncoming traffic where
you can change the wheel safely. The
ground should be flat and adequately
firm;
❒turn the engine off and pull up the hand-
brake;
❒engage first gear or reverse;
603_97_560 PANDA 4X4 Euro 5 GB 11-12-2009 9:31 Pagina 4

8
FIAT PANDA 4 x 4
❒loosen the three fastening screws A-
fig. 16and remove the headlight cov-
er;
❒remove the cover by removing the
catches B;
❒remove the lens fig. 17by loosening
the three fastening screws A;
❒turn connector A-fig. 18counter-
clockwise and remove it;
❒remove the bulb B-fig. 18and fit the
new bulb.
To change the direction indicator bulb,
proceed as follows:
❒loosen the two fastening screws A-
fig. 19and remove the cover B;
❒loosen the fastening screws A-fig. 20
and remove the lens B;
❒remove the cap A-fig. 21from the lens
Band remove the bulb holder C;
❒remove bulb Dby pushing it slightly and
turning it counter-clockwise, then fit
the new bulb.
To change side direction indicators, third
brake light and number plate light bulbs re-
fer to paragraph “When needing to change
a bulb” in section “In an emergency” in the
attached Owner Handbook.
fig. 16F0G0620mfig. 18F0G0622m
fig. 17F0G0621mfig. 19F0G0623m
fig. 20F0G0624m
fig. 21F0G0631m
603_97_560 PANDA 4X4 Euro 5 GB 11-12-2009 9:31 Pagina 8

9
FIAT PANDA 4 x 4
REAR LIGHT UNITS
The bulbs are arranged inside the light unit
as follows fig. 22:
A12V-W5W, double filament bulb for
brake lights/taillights.
B12V-P21W bulb for direction indica-
tors.
C12V-P21W bulb for rear fog light (left
headlight) or reversing light (right head-
light).To change a bulb proceed as follows:
❒loosen the three screws A-fig. 23then
pull gently the headlight outwards un-
til releasing it from the three catches;
fig. 23F0G0625mfig. 24F0G0626m
❒loosen the four screws A-fig. 24and
disconnect the two connectors;
❒remove the required bulb holder turn-
ing it counter-clockwise;
❒remove the required bulb (A, Bor C-
fig. 22), pushing it slightly and turning
it counter-clockwise (bayonet cou-
pling), then fit the new bulb.
fig. 22F0G0627m
603_97_560 PANDA 4X4 Euro 5 GB 11-12-2009 9:31 Pagina 9

12
FIAT PANDA 4 x 4
20 40 60 80 100 120 140 160 180
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●● ● ●
●●●●● ●●●●
●●●●● ●●●●
●
●● ● ●
●● ● ●
●● ● ●
SERVICE SCHEDULE
Thousands of km
Check tyre conditions/wear and adjust pressure
if required
Check light system operation (headlights, direction indicators,
hazard lights, passenger compartment lights, boot lights,
warning lights, etc.)
Check windscreen wiper/washer operation,
adjust nozzles
Check windscreen/rear window blade
position/wear
Check front disk brake pad conditions and wear
Check rear disk brake pad conditions and wear
Sight inspect the conditions of: body external parts,
underbody protection, pipes and hoses
(exhaust - fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.)
Check cleanness of locks, bonnet and boot and lever cleanness
and lubrication
Check tension and adjust accessory drive belts
(excluding engines with automatic belt tighteners)
Sight inspect accessory drive belt conditions
Check and adjust tappet clearance (petrol versions)
Check handbrake lever stroke
603_97_560 PANDA 4X4 Euro 5 GB 11-12-2009 9:31 Pagina 12

21
FIAT PANDA 4 x 4
1.2
30
4.5
–
–
4.6
2.5
2.8
–
–
2.7
0.6
0.55
4.51.3 Multijet
–
–
30
4.5
6.5
–
–
2.8
3.0
2.7
0.6
0.55
4.5
CAPACITIES
Fuel tank: litres
including a reserve of: litres
Fuel tank: litresincluding a reserve of: litres
Engine cooling system: litres
Engine sump: litres
Engine sump and filter: litres
Engine sump: litres
Engine sump and filter: litres
Gearbox/differential: litres
Rear differential: litres
Hydraulic brake circuit: kg
Windscreen/rear window and
headlight washer fluid reservoir litres
(*) For use in particularly harsh weather conditions SELENIA PERFORMER MULTIPOWERengine oil is recommended
(**) SAE 75W-85synthetic oil that passes API GL4 PLUS, MIL - L - 2105 D Lev specifications
(***) Synthetic oil SAE 75W-85. that passes API GL5, MIL - L - 2105 D Lev specificationsSpecified fuels
and recommended products
Unleaded premium petrol with no
less than 95 R.O.N
(EN 228 Specification)
Diesel fuel for motor vehicles
(EN 590 Specification)
Mixture of 50% water and 50%
PARAFLU
UP
SELENIA 20K(*)
SELENIA WR
TUTELA CAR TECHNYX (**)
TUTELA CROSS 75W85(***)
TUTELA TOP 4
Mixture of water and
TUTELA PROFESSIONAL SC 35
603_97_560 PANDA 4X4 Euro 5 GB 11-12-2009 9:31 Pagina 21