sensor FIAT PANDA 2009 169 / 2.G Owners Manual

F0Z0692m
fig. 93
The beep frequency:❒
becomes louder as the distance between car and ob-
stacle decreases;
❒
becomes continuous when the distance between the
car and the obstacle is less that 30 cm and stops im-
mediately if the distance increases;
❒
is constant if the distance is unchanged.
Detection distances
Central operating radius 120 cm
Side operating radius 60 cm
If several obstacles are detected by the sensors, only the
nearest one is considered.
FAILURE WARNING
In the event of parking sensor failures, the driver is warned
when engaging reverse by a three-second beep.
OPERATION WITH TRAILER
Sensor operation is automatically deactivated when the trail-
er electric cable plug is fitted in the car tow hook socket.
The sensors are automatically reactivated when the trail-
er cable plug is removed.
PARKING SENSORS (for versions/markets where provided)
They are are located in the car rear bumper, fig. 93, and
they inform the driver, through an intermittent acoustic
signal, about the presence of obstacles behind the car.
ACTIVATION
The sensors are automatically activated when the reverse
gear is engaged.
As the obstacle behind the vehicle gets closer to the car,
the buzzer becomes more frequent.
BUZZER WARNINGS
When the reverse gear is engaged an intermittent acoustic
signal is automatically activated (short beep indicating that
the system is working).
82
KNOW YOUR
VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
065-090 PANDA EN 7-10-2009 13:45 Pagina 82

GENERAL WARNINGS❒
When parking, take the utmost care to obstacles that
may be set above or under the sensors.
❒
Objects set close to the car rear, under certain cir-
cumstances are not detected and could therefore cause
damage to the car or be damaged.
❒
Indications sent by the sensors can be altered by dirt,
snow or ice deposited on the sensors or by ultrasound
systems (e.g.: truck pneumatic brakes or pneumatic
hammers) set nearby the car.
For proper operation, sensors must always
be clean from mud, dirt, snow or ice.
Be careful not to scratch or damage the
sensors while cleaning them. Avoid using dry, rough
or hard cloths. The sensors should be washed us-
ing clean water with the addition of car shampoo
if necessary. When using special washing equipment
such as high pressure jets or steam cleaning, clean
the sensors very quickly keeping the jet more than
10 cm away.
Parking manoeuvres however are always
under the driver’s responsibility. While ma-
noeuvring, the driver shall always make sure that
no-one is standing in the area, especially children
or animals. The parking sensor is designed to as-
sist drivers, who shall never reduce attention dur-
ing potentially dangerous manoeuvres even if per-
formed at low speed.
WARNING
83KNOW YOUR
VEHICLESAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
065-090 PANDA EN 7-10-2009 13:45 Pagina 83

90
DIESEL PARTICULATE FILTER (DPF)
(for 1.3 Multijet 75 HP versions)
The Diesel Particulate Filter is a mechanical filter, inte-
gral with the exhaust system, that physically traps partic-
ulates present in the exhaust gases of diesel engines.
The diesel particulate filter has been adopted to eliminate
almost all particulates in compliance with current/future
legal regulations.
During normal use of the vehicle, the engine control unit
records a set of data (e.g.: travel time, type of route, tem-
peratures, etc.) and it will then calculate how much par-
ticulates has been trapped by the filter.
Since this filter physically traps particulate, it should be re-
generated (cleaned) at regular intervals by burning carbon
particles.
The regeneration procedure is controlled automatically by
the engine management control unit according to the fil-
ter conditions and vehicle use conditions.
There may be a limited increase in the engine idle speed
during the regeneration, a limited increase in fumes and
high temperatures at the exhaust. These are not faults;
they do not impair vehicle performance or damage the
environment.
If the dedicated message is displayed, refer to paragraph
“Warning lights and messages”.
KNOW YOUR
VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
PROTECTING THE ENVIRONMENTThe following devices are used for reducing petrol fuel
engine emissions:❒
three-way catalytic converter;
❒
oxygen sensors;
❒
evaporation control system.
In addition, do not let the engine run, even for a test, with
one or more spark plugs disconnected.
The following devices are used for reducing diesel fuel en-
gine emissions:
❒
oxidising catalytic converter;
❒
exhaust gas recirculation system (E.G.R.);
❒
diesel particulate filter (DPF).
The catalytic converter develops high tem-
perature during operation. Do not park
the car on grass, dry leaves, pine needles or oth-
er flammable material: fire hazard.
WARNING
065-090 PANDA EN 7-10-2009 13:45 Pagina 90

132
KNOW YOUR
VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
ESP SYSTEM FAILURE (amber)
Turning the ignition key to MAR the warning light
turns on, but it should go off after a few seconds.
If the warning light does not go off or stays on together
with the LED on the button ASR OFF when travelling, con-
tact a Fiat Dealership.
On some versions the display shows the dedicated message.
NOTE The warning light flashing when driving indicates
that the ESP system is active.
á
GENERIC FAILURE INDICATION
(amber)
The warning light turns on in the following cir-
cumstances.
Engine oil pressure sensor failure
The warning light turns on when failure is detected in en-
gine oil pressure sensor. Contact a Fiat Dealership to have
the failure fixed as soon as possible.
Water in diesel fuel filter
See what described for warning light
c.
Inertia fuel cut-off switch tripped
The warning light comes on when the inertia fuel cut-off
switch is triggered. The display shows the dedicated
message.
è
EXTERNAL LIGHT FAILURE (amber)
The warning light will come on (some versions
only) when a failure to one of the following lights
is detected:
– side lights;
– brake lights (third brake light excluded);
– rear fog lights;
– direction indicators;
– number plate lights.
The failure referring to these lights could be: one or more
blown bulbs, a blown protection fuse or an electric con-
nection cut-off.
The display shows the dedicated message.
W
REAR FOG LIGHTS (amber)
The warning light turns on when the rear fog
lights are turned on.
4
HEATED REAR WINDOW (amber)
The warning light turns on when switching the
heated rear window on.
(
123-134 PANDA EN 7-10-2009 13:49 Pagina 132

163KNOW
YOUR VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGESIN
AN EMERGENCYCAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
5
7,5
7,5
10
7,5
15
15
7,5
7,5
7,5
7,5
5
5
15
–
–
7,5
7,5
7,5
20
10
10
10
10
F31
F35
F35
F37
F41
F45
F46
F49
F49
F49
F50
F51
F51
F54
FA
FB
F12
F13
F13
F38
F39
F39
F39
F39
FUSE SUMMARY TABLEPassenger’s compartment fuse-box - fig. 167 FUSE AMPEREReversing lights+15 radioCentral dashboard+15 stop lightsDoor mirror defroster Heated seats (pre-arrangement)Electric sun roofAutomatic climate control systemTyre pressureSensor for water presence in the diesel fuel filter +15 air bag control unit+15 Body-computer control unit+15 instrument panelSubwooferFreeFreeRight dipped beam headlightLeft dipped beam headlightHeadlight aiming adjustment+ 30 door locking deviceEOBD diagnosis socketRadioAutomatic climate control systemTyre pressure
135-168 PANDA EN 7-10-2009 14:07 Pagina 163

221KNOW
YOUR VEHICLE
SAFETY
CORRECT USE
OF THE CAR
WARNING LIGHTS
AND MESSAGES
IN
AN EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONSINDEX
– passenger compartment
ventilation and heating ......... 42
– system servicing ..................... 43
– windscreen and front side
window demisting/
defrosting ................................ 42
Mirror adjustment ....................... 36
MSR (system) ................................ 78
MSR system ................................... 78
Multifunction display ................... 17
– control buttons ...................... 19
– setup menu ............................. 20
– standard screen ..................... 17N
umber plate lights
– bulb replacement ................... 156
O
n board instruments (panel) .. 14
Paint (maintenance) ................... 188
– bodywork colour plate ........ 192
Paraflu
– level check and top-up ......... 177
– specifications .......................... 205Parking (sensors) ......................... 82
Parking lights ................................. 48
Parking sensors ............................ 82
Parking the vehicle ...................... 113
Passenger compartment light
adjustment .................................. 52
Performance ................................. 201
Pollen filter .................................... 181
Power sun roof ............................ 58
– opening/closing ...................... 59
Power windows ........................... 63
Preparation for child seats ........ 103
Q
uality specifications of fluid
and lubricants ................... 204-205
Radio transmitters and mobile
phones ......................................... 87
Radio transmitters and mobile
phones ......................................... 87
Rear door locking
emergency device ..................... 62
Rear fog light
– bulb replacement ................... 155– switching on ............................ 54
Rear fog lights ............................... 54
Rear fog lights
– bulb adjustment ..................... 156
– switching on ............................ 54
Rear light units
– bulb replacement ................... 155
Rear seats
– cleaning .................................... 190
– headrests ................................. 32
Rear view mirrors
– inside ........................................ 35
– outside ..................................... 36
Rear window washer ................... 51
– fluid level check
and top-up ............................... 178
– jet .............................................. 187
– operation ................................. 51
Rear window wiper
– blade replacement .................. 186
– operation .................................. 51
– rear window washer fluid
features ..................................... 179
215-224 PANDA EN 7-10-2009 15:09 Pagina 221