warning FORD AEROSTAR 1997 1.G User Guide

77
*
[CF05200(ALL)01/96]
To clean the windshield, push in the end of the
wiper knob. For a constant spray, keep the knob
pushed in. After you release the knob, the
wipers operate for two to three cycles before
turning off (if wipers were off) or returning to
the selected setting.
[CF05250(ALL)01/96]
NOTE: The addition of bug shields to the
front of the vehicle (e.g., shields) may
adversely affect the windshield washer
system from delivering fluid to the
windshield. Devices such as shields are
not recommended for your Ford
vehicle.
*
[CF05300(ALL)08/95]
Do not try to clean the windshield when the
washer fluid container is empty or activate the
washers at any time for more than 15 seconds
continuously. This could damage the washer
pump system.
*
[CF05400(ALL)01/96]
RWARNING
Always warm up the windshield with the
defroster before you use the washer fluid.
In freezing weather, the washer solution
may freeze on the windshield and obscure
your vision.
*
[CF05450(ALL)03/96]
For information about refilling the washer fluid
or replacing your windshield wiper blades, see
Windshield washer fluid and Wipersin the Index.
%
*
[CF05475(ALL)01/96]
Gearshift Lever
[CF05495(ALL)03/96]
The gearshift lever on your Aerostar is mounted
on the steering column. On the end of the
gearshift lever is the OVERDRIVE OFF button.
For additional information about the gearshift
lever and the OVERDRIVE OFF button, see the
Drivingchapter.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

79
%*
[CF06200(ALL)05/96]
Tilt Steering (If equipped)
*
[CF06350(ALL)02/96]
RWARNING
Never adjust the steering wheel when the
vehicle is moving.
[CF06500(ALL)01/96]
one third page art:0020089-C
Turn signal and tilt steering release lever
*
[CF06750(ALL)01/96]
To change the position of the steering wheel,
pull the release lever on the column toward you.
Tip the steering wheel to the desired position.
Release the lever to lock the steering wheel in
place.
*
[CF07250(ALL)01/96]
Be sure the steering wheel locks in a notch. It is
not infinitely adjustable. Do not adjust the
steering wheel while the vehicle is in motion.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

81
you may want to shift to the next lower gear to
reduce your vehicle's speed.
[CF08450(ALL)03/96]
If your vehicle slows down more than 10 mph
(16 km/h) below your set speed on an uphill,
your speed control will disengage. Pressing
RESUME will re-engage it.
*
[CF08700(ALL)05/96]
RWARNING
Do not use the speed control in heavy
traffic or on roads that are winding,
slippery, or unpaved.
*
[CF08800(ALL)05/96]
To Set a Higher Set Speed
[CF08900(ALL)03/96]
Press and hold SET ACCEL. Release the switch
when the desired vehicle speed is reached.
[CF08950(ALL)03/96]
OR
[CF08970(ALL)03/96]
Press and release SET ACCEL. Each press will
increase the set speed by 1 mph (1.6 km/h).
[CF08975(ALL)03/96]
OR
*
[CF09000(ALL)05/96]
You may accelerate with the accelerator pedal at
any time during speed control usage. Releasing
the accelerator pedal will return your vehicle
speed to the previously programmed set speed.
*
[CF09100(ALL)05/96]
To Set a Lower Set Speed
[CF09200(ALL)03/96]
Press and hold COAST. Release the switch when
the desired speed is reached.
[CF09220(ALL)03/96]
OR
[CF09260(ALL)03/96]
Press and release COAST. Each press will
decrease the set speed by 1 mph (1.6 km/h).
[CF09280(ALL)03/96]
OR
[CF09300(ALL)03/96]
Depress the brake pedal. When the desired
vehicle speed is reached, press SET ACCEL.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

82
*
[CF09325(ALL)05/96]
RWARNING
Do not shift the transmission into N
(Neutral) with the speed control on.
*
[CF09400(ALL)05/96]
To Disengage Speed Control
[CF09500(ALL)03/96]
Depress the brake pedal.
*
[CF09600(ALL)05/96]
Disengaging the speed control will not erase the
previously programmed set speed.
*
[CF09700(ALL)05/96]
To Return to a Set Speed
[CF09800(ALL)03/96]
Press RESUME. For RESUME to operate, the
vehicle speed must be faster than 30 mph
(48 km/h).
*
[CF11950(ALL)05/96]
Use of radio transmitting equipment that is not
Federal Communications Commission (FCC) or
in Canada the Canadian Radio and
Telecommunications Commission (CRTC)
approved may cause the speed control to
malfunction. Therefore, use only properly
installed FCC (CRTC in Canada) approved radio
transmitting equipment in your vehicle.
[CF13000(ALL)05/96]Dome/Map/Reading Lamps
(If equipped)
[CF13020(ALL)05/96]
one third page art:0095104-A
Map lamps
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

86 [CF24800(ALL)01/96]
one third page art:0020190-BOpening the liftgate
[CF25300(ALL)04/96]
Make certain that you close the liftgate door and
window before driving your vehicle. If you do
not, possible damage may occur to the liftgate
door lift cylinders and attaching hardware.
*
[CF25400(ALL)01/96]
RWARNING
Make sure that the liftgate door and/or
window are closed to prevent exhaust
fumes from being drawn into the vehicle.
This will also prevent passengers and
cargo from falling out. If you must drive
with the liftgate door or window open,
keep the vents open so outside air comes
into the vehicle.
*
[CF25500(ALL)01/96]
Liftgate closing procedure
*
[CF25600(ALL)01/96]
1. To make the liftgate swing downward, reach
up and pull the lower edge of the liftgate (or
the loop handle on the inner trim panel of
vehicles with this option) and pull
downward.
*
[CF25700(ALL)01/96]
2. When you have pulled down the liftgate
enough so that you can reach the license
plate light shield, push the shield down and
forward to close the latch and liftgate. At
this point, the latch is not locked.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

88 [CF29700(ALL)01/96]When closing the dual rear cargo doors,
remember to close the left rear door first.
[CF29801(ALL)04/96]
RWARNING
Do not operate your vehicle with the rear
double doors open.
%*
[CF30100(ALL)01/96]
Power Door Locks (If equipped)
[CF30200(ALL)01/96]
The power door lock switches are located in the
front doors. To lock all doors push the switch
marked LOCK. To unlock all doors push the
switch marked UNLOCK.
[CF30300(ALL)04/96]
Memory lock (sliding door)
[CF30401(ALL)01/96]
Your vehicle has a sliding door memory lock
feature that does not require the sliding door to
be closed before using the power locks. The
locking function will activate after the door is
closed.
*
[CF30701(ALL)01/96]
The manual door locks will override the power
door lock controls.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

90 [CF31600(ALL)05/96]
one third page art:0020207-EOpening the sliding side window
%*
[CF31700(ALL)01/96]
Using the Power Windows (If equipped)
[CF31800(ALL)01/96]
Each front door has a power control that opens
and closes the window on that door. The
driver's door has a master control switch that
operates both front door windows. You must
place the ignition switch in the ON or ACC
position to use your power window controls.
*
[CF31900(ALL)01/96]
RWARNING
Make sure that the liftgate door and/or
window are closed to prevent exhaust
fumes from being drawn into the vehicle.
This will also prevent passengers and
cargo from falling out. If you must drive
with the liftgate door or window open,
keep the vents open so outside air comes
into the vehicle.
*
[CF32000(ALL)01/96]
RWARNING
Do not let children play with the power
windows.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

91 [CF32100(ALL)01/96]
quarter page art:0020201-C
Power window controls Ð driver-side shown
%*
[CF50000(ALL)03/96]
Mirrors
[CF54100(ALL)01/96]
For vehicles without rear door windows, the
right-hand side mirror is a flat glass mirror. All
other vehicles have convex right-hand side view
mirrors. Convex mirrors have a curved surface
and will show a wider view of the lane next to
and behind your vehicle.
*
[CF54400(ALL)05/96]
RWARNING
The right side view mirror makes objects
appear smaller and farther away than they
actually are.
%*
[CF54500(ALL)05/96]
Dual Electric Remote Control Mirrors
(If equipped)
*
[CF54600(ALL)05/96]
To adjust the remote controlled side mirrors:
[CF54700(ALL)01/96]
1. Locate the switch in the driver's door trim
panel.
[CF54900(ALL)01/96]
2. Select the right or left mirror by moving the
center switch to the left-hand or right-hand
position. The midway position moves neither
the left-hand or right-hand mirror.
[CF55100(ALL)01/96]
3. Press the appropriate side of the square
marked by an arrow indicating the direction
of adjustment.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

97
Seating and Safety
Restraints
%*
[SS00102(ALL)05/96]
Seats
%*
[SS00105(ALL)01/96]
Adjusting the Front Seat Manually
[SS00110(ALL)01/96]
You can move the driver seat forward or
backward. If your vehicle is equipped with the
optional reclining bucket seat, you can also tilt
the seatback up to 30 degrees rearward.
[SS00115(ALL)01/96]
The front passenger seat cannot be adjusted.
[SS00120(ALL)01/96]
one third page art:0095010-B
Seat adjustment levers
*
[SS00125(ALL)05/96]
RWARNING
Never adjust the driver's seat or seatback
when the vehicle is moving.
*
[SS00130(ALL)05/96]
RWARNING
Do not pile cargo higher than the
seatbacks to avoid injuring people in a
collision or sudden stop.
File:06cpssa.ex
Update:Thu Jun 13 08:56:07 1996

98
*
[SS00135(ALL)02/96]
RWARNING
Always drive and ride with your seatback
upright and the lap belt snug and low
across the hips.
*
[SS00140(ALL)02/96]
RWARNING
Children should always ride with the
seatback in the fully upright position.
*
[SS00145(ALL)08/95]
To move the seat forward or backward:
[SS00150(ALL)01/96]
one third page art:0095011-B*
[SS00155(ALL)08/95]
To recline the seatback:
[SS00160(ALL)01/96]
one third page art:0095012-BFile:06cpssa.ex
Update:Thu Jun 13 08:56:07 1996