change wheel FORD ASPIRE 1996 1.G Owners Manual
[x] Cancel search | Manufacturer: FORD, Model Year: 1996, Model line: ASPIRE, Model: FORD ASPIRE 1996 1.GPages: 268, PDF Size: 2.2 MB
Page 127 of 268
126
*
[DR08800(ALL)03/95]
Parking
*
[DR08900(ALL)03/95]
To park your vehicle, shift into 1 (First), set the
parking brake fully, and turn off the ignition.
*
[DR09000(ALL)05/95]
RWARNING
Do not park your vehicle in Neutral, it
may move unexpectedly and injure
someone. Use 1 (First) gear and set the
parking brake fully.
[DR09100(ALL)04/95]
Steering Your Vehicle (Power steering if
equipped)
[DR09200(ALL)05/93]
Your car may be equipped with power steering.
Power steering uses energy from the engine to
help steer your car.
%*
[DR09250(ALL)04/95]
If the amount of effort needed to steer your
vehicle changes at a constant vehicle speed, have
the power steering system checked. If the power
steering system breaks down (or if the engine is
turned off), you can steer the vehicle manually
but it takes more effort.
*
[DR09300(ALL)01/95]
Never hold the steering wheel to the extreme
right or left for more than five seconds if the
engine is running. This can damage the power
steering pump.
*
[DR09500(ALL)03/95]
Brakes
*
[DR09600(ALL)01/95]
Applying the Brakes
[DR10000(ALL)07/93]
Your vehicle is equipped with a power front
disc/rear drum brake system that adjusts
automatically as the brake pads and linings
wear.
[DR10050(ALL)05/95]
If power assist is lost you can still stop your
vehicle by applying greater force to the brake
pedal than you normally would. The stopping
distance, however, is longer.
File:10icdrf.ex
Update:Wed Jan 24 14:53:01 1996
Page 132 of 268
131
*
[DR11600(ALL)06/95]
The parking brake is not designed to stop a
moving vehicle, but you can use the parking
brake to stop your vehicle in an emergency if
the normal brakes fail. However, since the
parking brake applies only the rear brakes, the
stopping distance will increase greatly and the
handling of your vehicle will be adversely
affected.
*
[DR14000(ALL)01/95]
Driving Under Special Conditions
*
[DR14100(ALL)01/95]
Tips for Safe Driving
*
[DR14200(ALL)07/95]
As with any new vehicle, yours may drive and
handle differently from your previous vehicle.
Use care until you become accustomed to its
various features and driving characteristics.
*
[DR14300(ALL)03/95]
Operate your vehicle within reasonable limits.
Sudden acceleration, deceleration, turning, or
combinations of these maneuvers can cause a
vehicle to behave differently than anticipated.
*
[DR14500(ALL)02/95]
q
Extreme braking can cause the front wheels
to lock and slide, making it difficult to
control the direction of the vehicle. Use a
ªsqueezeº technique Ð push on the brake
pedal with steadily increasing force. This
allows the wheels to brake yet continue to
roll so that you may steer in the direction
you want to travel. If you lock the wheels,
release the brake pedal and repeat the
ªsqueezeº technique.
*
[DR14600(ALL)02/95]
q
If you abruptly release the accelerator or
brake hard while going too fast around a
severe curve, your vehicle may change
direction. Avoid application of the brakes, if
possible. If braking is necessary, it should be
done by using the ªsqueezeº technique
described above.
File:10icdrf.ex
Update:Wed Jan 24 14:53:01 1996
Page 144 of 268
144
*
[RE07600(ALL)03/95]
Preparing to Change the Tire
*
[RE07700(ALL)02/92]
1. Make sure that your vehicle will not move
or roll. If you have an automatic transaxle,
put the gearshift in P (Park). If you have a
manual transaxle, put the gearshift in 1
(First). Set the parking brake and block the
wheel that is diagonally opposite the tire
that you are changing.
[RE08000(ALL)02/89]
half page art:0030148-A
Blocking the wheel diagonally opposite the tire being
changed
*
[RE08090(ALL)07/95]
When one of the front wheels is off the ground,
the transaxle alone will not prevent the vehicle
from moving or slipping off the jack, even if the
vehicle is in P (Park) or 1 (First). To prevent the
vehicle from moving when you change one of
the front tires, put a block behind the wheel that
is diagonally opposite to the tire.
File:12icref.ex
Update:Wed Jan 24 14:52:09 1996
Page 147 of 268
147 [RE08650(ALL)02/95]
Removing and Replacing the Tire
[RE08700(ALL)02/95]
1. Find the jack location near the door of the
tire that you are changing. Position the jack
and turn the handle of the jack clockwise
until the wheel is completely off the ground.
*
[RE08800(ALL)05/95]
RWARNING
To lessen the risk of personal injury, do
not put any part of your body under the
vehicle while changing a tire. Do not start
the engine when your vehicle is on the
jack. The jack is only meant for changing
the tire.
[RE09200(ALL)05/93]
one third page art:0032213-A
Jack mounting position
[RE09600(ALL)02/95]
2. Remove the wheel bolts by using the lug
wrench. Never loosen the hub nuts. See the
illustration following Step 1Preparing to
Change the Tireif you are not sure where to
find the wheel bolts.
[RE09700(ALL)02/95]
3. Replace the flat tire with the spare tire. Keep
the retaining tool in place.
File:12icref.ex
Update:Wed Jan 24 14:52:09 1996