head FORD FIESTA 2007 Workshop Manual

303-1 4-23 Electronic Engine Controls 303-1 4-23
REMOVAL AND INSTALLATION
7. Remove the remains of the shear bolt from 4.
If a new PCM is being installed connect WDS.
/ the PCM using grips. Download the PCM configuration information
using the programmable modules installation
routine.
5. N0TE:Do not press the accelerator pedal
during the initialization period as this will
prevent the complete initialization of the
throttle body.
Turn the ignition key to position
I1 and wait
for one minute to initialize the throttle body.
6. Turn the ignition key to the OFF position.
Installation
I. Install a new shear bolt and securing clip,
using the special tool to push the clip onto
the shank of the bolt.
2. Install the PCM electrical connector to the
PCM.
Tighten the bolt until the head shears off.
3. Install the battery tray.
For additional information, refer to: Battery
Tray
(414-01, Removal and Installation).
procarmanuals.com

30311 4-26 Electronic Engine Controls 303-1 4-26
REMOVAL AND INSTALLATION
Removal Details
Item 1 PCM security shield shear bolts Item 4 PCM retaining bolts 1. Remove the PCM security shield shear bolts. 1. Support the PCM, PCM retaining bracket and Drill a 3 mm pilot hole in the center of the PCM mounting bracket while removing the PCM security shield shear bolts. PCM retaining bolts. Drill a 8 mm hole in the PCM security shield
shear bolts and remove the PCM security
Item 7 PCM
shield. I. Remove the PCM from the PCM retaining
bracket.
Item 2 PCM security shield
I. Remove the PCM security shield.
1. Swing the PCM security shied away from the
PCM retaining bracket.
2. Slide the PCM security shield from the PCM
retaining bracket.
Installation Details
Item 1 PCM security shield shear bolts
1. Tighten the PCM security shield shear bolts
until the head of the bolt shears off.
2006.0 Fiesta 1212006 G422234en
procarmanuals.com

Automatic Transmission/'rransaxle External
Controls -Vehicles With: 4-Speed Automatic
307-05-4 Transmission (AW81-40) 307105-4
DESCRIPTION AND OPERATION
I 1 (Ball head I
1 2 1 Selector lever cable I
1 3 I Adjustment device I
1 4 ( Selector shaft lever I
The selector lever cable is clipped onto a ball head
on the selector lever.
At the transmission end it is clipped onto the ball
head on the selector shaft lever.
The cable is moved in an axial direction by
operation of the selector lever.
The selector shaft lever converts the axial motion
into a rotation of the selector shaft.
The adjustment device for the selector lever cable
is located at the transmission end of the cable.
2006.0 Fiesta 1212006 G357360en
procarmanuals.com