HONDA ACCORD COUPE 2007 CL7 / 7.G Manual Online

µ
µ µ
µ
You can also open both power
windows from outside the vehicle
with the remote transmitter (see
page ).
Press this button once
to unlock the driver’s door. Push it
twice to unlock the passenger’s door.
Some exterior lights will f lash twice
each time you push the button.
The ceiling light (if the ceiling light
switch is in the door activated
position) will come on when you
press the UNLOCK button. If you do
not open either door within 30
seconds, the lights f ade out. If you
relock the doors with the remote
transmitter before 30 seconds have
elapsed, the lights will go of f
immediately.
Press this button once to
lock both doors. Some exterior lights
will f lash once.
When you push the LOCK button
twice within 5 seconds, the lights will
flash and the horn will beep to verify
that the doors are locked and that
the security system has set. The
LOCK button will not work this way
if either door is not f ully closed.
When the key is in the ignition
switch, the f unctions of each button
are disabled.
Press this
button f or about 1 second to open
the trunk.
Press and hold this
button for about 2 seconds to attract
attention: the horn will sound and
the exterior lights will f lash f or about
30 seconds. To cancel panic mode,
press any other button on the remote
transmitter, or turn the ignition
switch to the ON (II) position.
If you do not open either door within
30 seconds, the doors automatically
relock and the security system sets. 92
UNL OCK
LOCK T RUNK REL EA SE
PA NIC
Remote Transmitter
78
UNLOCK
BUTTON
LOCK
BUTTON
TRUNK
RELEASE
BUTTON
PANIC
BUTTON
——y

y
(#yy

Avoid dropping or throwing the
transmitter.
Protect the transmitter from
extreme temperature.
Do not immerse the transmitter in
any liquid.
If you lose a transmitter, the
replacement needs to be
reprogrammed by your dealer.Remove the screw at the base of
the transmitter with a small
Phillips-head screwdriver.
To replace the battery:
If it takes several pushes on the
button to lock or unlock the doors,
replace the battery as soon as
possible.
Battery type: CR1616 Inside the transmitter, separate
the inner cover f rom the keypad
by releasing the two tabs on the
cover.
Separate the transmitter by prying
its middle seam with your
f ingernail.
1. 2. 3.
CONT INUED
Remote Transmitter CareReplacing the Transmitter
Battery
Remote Transmitter
Inst rument s and Cont rols
79
SCREW
TAB
BATTERY
——y

y
(#yy

´
As required by the FCC:This device complies with Part 15 of theFCC rules. Operation is subject to the
f ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept any
interf erence received, includinginterf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f or
compliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing two
conditions: (1) this device may not causeinterf erence, and (2) this device mustaccept any interf erence that may cause
undesired operation of the device.Remove the old battery, and insert
a new battery into the back of the
cover with the side f acing down.
An improperly disposed of battery
can hurt the environment.
Always conf irm local regulations
for battery disposal.
Install the parts in reverse order.
4. 5.
Remote Transmitter
80
——y

y
(#yy

Keep the trunk lid closed at all times
while driving to avoid damaging the
lid, and to prevent exhaust gas f rom
getting into the interior. Seeon page .
To protect items in the trunk when
you need to give the key to someone
else: Lock the trunk release handle
with the master key.
Give the person the valet key. As a saf ety f eature, your vehicle has
a release lever on the trunk latch so
the trunk can be opened f rom the
inside. To open the trunk, push the
release lever to the lef t.
Parents should decide if their
children should be shown how to use
this f eature. For more inf ormation
about child saf ety, see page .
Youcanopenthetrunkintwoways:
Pull the trunk release handle to
the lef t of the driver’s seat.
Press and hold the trunk release
button on the remote transmitter.
To close the trunk, press down on
the trunk lid. 1. 2.50
36
Carbon
Monoxide Hazard Emergency T runk Opener
Trunk
Inst rument s and Cont rols
81
Pull
TRUNK RELEASE HANDLE MASTER KEY
——y

y
(#yy

µ
The 4-cylinder LX model has manual
driver’s seat adjustments (see next
column).
All V6 models and the 4-cylinder
EX-L models have a power
adjustable driver’s seat.
The f ront passenger’s seat in all
models adjusts manually.
Make all seat adjustments bef ore
you start driving.
To adjust the seat f orward or
backward, pull up on the bar under
the seat cushion’s f ront edge. Move
the seat to the desired position, and
releasethebar.Trytomovetheseat
to make sure it is locked in position.To change the seat-back angle of the
f ront seat, pull up the lever on the
outside of the seat bottom.
Once your seat is adjusted correctly,
rock it back and f orth to make sure it
is locked in position.
The 4-cylinder EX and SE models
have a power seat bottom height
adjustment. All other driver’s seat
adjustmentsinthismodelare
manual.
See pages f or important saf ety
inf ormation and warnings about how toproperly position the seats and seat-
backs. 13
11
Seats
Manual Seat Adjustments
82
——y

y
(#yy

The height of your driver’s seat is
power adjustable. Pull up on the
switch to raise the seat. Push it down
to lower the seat.
Make sure to pull the lever upward
or downward to its f ull range.
Make all seat adjustments bef ore
you start driving.
Make all seat adjustments bef ore
you start driving.
The height of your driver’s seat is
adjustable. To raise the seat,
repeatedly pull up the lever on the
outside of the seat cushion. To lower
the seat, push the lever down
repeatedly.
On 4-cylinder LX model
On 4-cylinder EX and SE models
Driver’s Seat Power Height
Adjustment
Driver’s Seat Manual Height
Adjustment
Seats
Inst rument s and Cont rols
83
——y

y
(#yy

µ
Raises or lowers the
seat.
Adjusts the seat-
back angle f orward
or backward.
Moves the f ront of
the seat up or down
and the rear of the
seat up or down.
Moves the seat
forward and
backward.
The controls f or the power
adjustable driver’s seat are on the
outside edge of the seat bottom. You
can adjust the seat with the ignition
switch in any position. Make all seat
adjustments before you start driving.
See pages f or important saf ety
inf ormation and warnings about how toproperly position the seats and seat-
backs.
On all V6 models, and the 4-cylinder
EX-L model 11 13
Seats
(Driver’s Seat Only)
Power Seat A djustments
84
——y
y
(#yy

To use the console lid as an armrest,
slide it to the desired position.
Make sure your passenger’s hands
orfingersareawayfromthearmrest
bef ore moving it.To get into the rear seat on the
driver’s side, open the door and pull
the release lever up on the side of
the seat-back. The seat-back will tilt
f orward to allow easier entry to the
rear seat.
To change the lumbar support, move
the lever on the right side of the
seat-back forward or backward.
Keep moving the lever f orward or
backward until you f ind a suitable
position.
CONT INUED
On all V6 models and the 4-cylinder
EX-L model
OnEX,EX-L,SE,andEX-V6models
Driver’s L umbar Support A rmrest Rear Seat A ccess
Driver’s Side
Seats
Inst rument s and Cont rols
85
RELEASE LEVER
——y
y
(#yy

To get into the rear seat on the
passenger’s side, push downward on
the release lever at the base of the
seat-back. The seat-back will tilt
f orward and the entire seat will move
f orward to allow easier entry to the
rear seat.
To get into the rear seat on the
driver’s side, open the door and pull
up on the seat-back adjustment lever.
The seat-back will tilt f orward to
allow easier entry to the rear seat. Af ter a passenger gets into the rear
seat, push the seat-back to the
upright position and push the whole
seat backwards until it latches. Make
sure the seat is f ully latched bef ore
sitting in it.
On LX, EX, and SE models
Passenger’s Side
Seats
86
SEAT-BACK ADJUSTMENT LEVER
RELEASE LEVER
To avoid damaging the seat-back angle
adjustment motor, do not operate the
seat-back angle switch when the seat-
back is tilted f orward.
——y

y
(#y
y

See page f or important saf etyinf ormation and a warning about how toproperly position the head restraints. 13
The head restraints adjust f or height.
You need both hands to adjust the
restraint. Do not attempt to adjust it
while driving. To raise it, pull upward.
To lower the restraint, push the
release button sideways, and push
the restraint down.
Your vehicle is equipped with head
restraints on the f ront seats and on
the outer rear seats.
The head restraints help protect you
and your passengers f rom whiplash
and other injuries.
Theyaremosteffectivewhenyou
adjust them so the back of the
occupant’s head rests against the
center of the restraint.
Head Restraints
Seats
Inst rument s and Cont rols
87
RELEASE BUTTON
FRONT
REAR
RELEASE BUTTON
——y
y
(#yy