remove seats HONDA CROSSTOUR 2012 1.G Owners Manual

When not using the LATCH system,
all child seats must be secured to the
vehicle with the lap part of a lap/
shoulder belt.With the child seat in the desired
seating position, route the belt
through the child seat according
to the seat maker’s instructions,
then insert the latch plate into the
buckle and remove any slack f rom
the lap portion of the belt.To activate the lockable retractor,
slowly pull the shoulder part of the
belt all the way out until it stops,
then let the belt f eed back into the
retractor.
Af ter the belt has retracted, tug on
it. If the belt is locked, you will not
be able to pull it out. If you can pull
thebeltout,itisnotlocked,and
you will need to repeat these steps.
In addition, the lap/shoulder belts in
all seating positions except the
driver’s have a lockable retractor
that must be activated to secure a
child seat.
1.2.
3.
Installing a Child Seat with a L ap/
Shoulder Belt
Installing a Child Seat
44

Driver and Passenger Saf ety

2012 Crosstour

To remove a head restraint f or
cleaning or repair, pull it up as f ar as
it will go. Push the release button,
then pull the restraint out of the seat-
back.
When a passenger is seated in the
rear seat, the head restraint should
be adjusted up or down, to match the
passenger’s height. When removing the rear outer head
restraints, tilt the rear seat f irst (see
page ).
Make sure the head restraint locks
in position when you reinstall it. When reinstalling a head restraint,
put the legs back in place. Then
adjust it to the appropriate height
while pressing the release button.
97
CONT INUED
Removing t he Head Rest raint
Seats
95
CUSHION
LEGS RELEASE
BUTTON
SEAT-BACK
Rear
Failure to reinstall, or correctly
reinstall, the head restraints can
result in severe injury during a
crash.
Always replace the head
restraints before driving.

Inst rument s and Cont rols

2012 Crosstour

You can fold down the seat-back in
two ways.Lower the rear head restraints to
their lowest positions. If you f old
down the lef t side seat-back, also
adjust the rear center head
restraint to its lowest position.
Make sure the rear seat armrest is
stored. How to use the rear seat release
lever.
Fold the seat-back forward. Unlock the seat-back by pulling up
the release lever on the outer side
of each rear seat-back.
Make sure that the folded seat-back
does not press against the f ront
passenger’s seat, as this could cause
the weight sensors to work
improperly. Remove any items from the seat
before folding down the seat-back. Each side f olds down separately, so
you can still carry one or two
passengers in the rear seat. The Easy Fold-down 60/40 Split
Rear Seatback can be f olded down
f or more cargo room.
1.
2.
3.
CONT INUED
Easy Fold-down 60/40
Seats
97
RELEASE LEVER

Inst rument s and Cont rols
Split Rear Seatback

2012 Crosstour

How to use the lever on both sides of
the cargo room.Do not put any heavy items on the
seat-back when it is folded down.
Make sure the seat-back is locked
securely and all rear shoulder belts
are positioned in f ront of the rear
seat-backs.
Make sure all items in the cargo area
are secured. Loose items can f ly
f orward and cause injury if you have
to brake hard. See
on page .
To return the seat-back to the
upright position, raise the seat-back
to make sure it is latched. If the seat-
back is not latched f ully, the seat belt
will not work properly and you will
seetheredindicatorbehindthe
release lever as shown.
Make sure there are no passengers
on the rear seats bef ore f olding the
seat-backs.
Pull the lever on either side of the
cargo area and the back of the rear
seat on that side folds down
automatically. 294
Carrying Cargo
Seats
98
LEVER RED INDICATOR
T o prevent spilling the contents of cups,
remove them bef ore f olding the seat-
back down.

Inst rument s and Cont rols

2012 Crosstour