lock HONDA RIDGELINE 2007 1.G Owner's Manual

The dial on the instrument panel
controls the brightness of the
instrument panel lights and the
console compartment light. Turn the
dial to adjust the brightness.
With the headlight control dial of f ,
the high beam headlights and the
high beam indicator come on with
reduced brightness when you turn
the ignition switch to the ON (II)
position and release the parking
brake. They remain on until you turn
the ignition switch of f , even if you
set the parking brake.
The headlights revert to normal
operation when you turn them on
with the headlight control dial.
The instrument panel will illuminate
with reduced brightness when you
unlock and open the driver’s door.
The brightness will increase and go
to a normal level when you insert the
key in the ignition switch.If you do not insert the key in the
ignition switch af ter opening the
driver’s door, the illumination turns
of f about 30 seconds af ter you close
the door.
If you insert the key but do not turn
the ignition switch to the ON (II)
position, the illumination turns of f in
about 10 seconds.
The instrument panel brightness is
dimmedwhenyouturntheheadlight
controldialtothe‘‘ ’’or
‘‘ ’’ position to reduce glare at
night. To cancel it, turn the
instrument panel brightness control
dial upward f ully until you hear a
click.
Canadian models only
Instrument Panel Brightness
Daytime Running L ights
Headlights, Instrument Panel Brightness
78
INSTRUMENT PANEL
BRIGHTNESS CONTROL DIAL

Push the lever up to lock the
steering wheel in position.
Make sure you have securely
locked the steering wheel in place
by trying to move it up and down.
Make any steering wheel adjustment
bef ore you start driving.
Move the steering wheel so it
points toward your chest, not
toward your f ace. Make sure you
can see the instrument panel
gauges and indicators. Push the lever on the lef t side of
the steering column all the way
down.
Pushthebuttontoturnonthe
hazard warning lights (f our-way
flashers). This causes all four
outside turn signals and both turn
indicators in the instrument panel to
f lash. Use the hazard warning lights
if you need to park in a dangerous
area near heavy traffic, or if your
vehicle is disabled. 3.
4.
1.
2. Steering Wheel A djustment
Hazard Warning Button
Hazard Warning Button, Steering Wheel A djustment
Inst rument s and Cont rols
79
Adjusting the steering wheel
position while driving may
cause you to lose control of the
vehicle and be seriously injured
inacrash.
Adjust the steering wheel only
when the vehicle is stopped.

These keys contain electronic
circuits that are activated by the
immobilizer system. They will not
work to start the engine if the
circuits are damaged.
Protect the keys from direct
sunlight, high temperature, and
high humidity.
Donotdropthekeysorsetheavy
objects on them.
Keep the keys away from liquids.
If they get wet, dry them
immediately with a soft cloth.
The
master key fits all the locks on
your vehicle. The valet key works
only in the ignition and the driver’s
door lock. You can keep the glove
boxlockedwhenyouleaveyour
vehicle and the valet key at a parking
facility.
You can also keep the In-Bed Trunk
locked by using the main switch in
theglovebox(seepage ). Youshouldhavereceivedakey
number tag with your keys. You will
need this key number if you ever
have to get a lost key replaced. Use
only Honda-approved key blanks.
97
Keys
80
VALET KEY
(LIGHT GRAY)
MASTER KEY
WITH REMOTE
TRANSMITTER
KEY
NUMBER
TAG

When you turn the ignition switch to
the ON (II) position, the immobilizer
system indicator should come on f or
a f ew seconds, then go of f . If the
indicator starts to blink, it means the
system does not recognize the
coding of the key. Turn the ignition
switch to the LOCK (0) position,
remove the key, reinsert it, and turn
the ignition switch to the ON (II)
position again.The system may not recognize your
key’s coding if another immobilizer
key or other metal object (i.e. key
f ob) is near the ignition switch when
you insert the key.
Do not attempt to alter this system
or add other devices to it. Electrical
problems could result that may make
your vehicle undrivable. If the system repeatedly does not
recognize the coding of your key,
contact your dealer.
The immobilizer system protects
your vehicle f rom thef t. If an
improperly-coded key (or other
device) is used, the engine’s f uel
system is disabled.
If you have lost your key and cannot
start the engine, contact your dealer.
As required by the FCC:This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept anyinterf erence received, includinginterf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f orcompliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not causeinterf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.
Immobilizer System
Inst rument s and Cont rols
81

µµ
µ µ
The ignition switch has f our
positions: LOCK (0), ACCESSORY
(I), ON (II), and START (III). You can insert or
remove the key only in this position.
To turn the key, the shift lever must
be in Park, and you must push the
key in slightly.
If the f ront wheels are turned, the
anti-theft lock may make it difficult
to turn the key. Firmly turn the
steering wheel to the lef t or right as
you turn the key.
You can
operate the audio system and the
accessory power sockets in this
position.
This is the normal key
position when driving. Several of the
indicators on the instrument panel
come on as a test when you turn the
ignition switch f rom the
ACCESSORY (I) to the ON (II)
position. Use this position
only to start the engine. The switch
returns to the ON (II) position when
you let go of the key.
You will hear a reminder beeper if
you leave the key in the ignition
switch in the LOCK (0) or the
ACCESSORY (I) position and open
the driver’s door. Remove the key to
turn of f the beeper.
TheshiftlevermustbeinPark(P)
bef ore you can remove the key f rom
the ignition switch.
LOCK (0)
A CCESSORY (I)
ON (II) ST A RT (III)
Ignition Switch
82

To lock any passenger’s door when
getting out of the vehicle, push the
lock tab down, and close the door.
To lock the driver’s door, remove the
key from the ignition switch, and
push the lock tab down, or push the
front of the master switch, then
close the door.
Withthed river’ sdooropenandthe
keyintheignition,bothm asterdoor
lockswitches will not lock, but they
will unlock. The lock feature is not
disabled if the driver’s door is closed.
Pushing the front of the switchonthe
open passenger’s door willlockall
doors and the In-Bed Trunk.
The
lock tab on each door locks and
unlocks that door. Pulling up on the
driver’s door lock tab only unlocks
the driver’s door. To unlock the
driver’s door and the In-Bed Trunk
from the outside, turn the key and
release it. If you turn it again, all the
doors unlock.
Youcanopenorclosetheside
windows by using the key in the
driver’s door (see page ).
Tolockal ldoorsandth eIn-Bed
Trunk (the tailgate does not lock),
push the front of the master doorlock
switch on either front door, pressthe
lock tab down on the driver’ sdoor,or
use the key on the outsidelocko nthe
driver’ sdoor. Thisvehiclehasautodoorlocking/
unlockingfeatures.Seepagefor
howtosetthem.
Pushingtherearofeithermaster
doorlockswitchwillunlockallofthe
doorsandth eIn-BedTrunk. 107
84
Lockout Prevention
Power Door L ocks
Door L ocks
Inst rument s and Cont rols
83
MASTER DOOR LOCK SWITCH LOCK TAB

Your vehicle has customizable
settings f or the doors to
automatically lock and unlock. Make
all settings bef ore you start driving.
T he childproof door loc
k

s are
designed to prevent children seated
in the rear f rom accidentally opening
the rear doors. Each rear door has a
lock lever near the edge. With the
lever in the LOCK position, the door
cannot be opened f rom inside
regardless of the position of the lock
tab. To open the door, pull the lock
tab up, and use the outside door
handle. Make sure the shif t lever is in the
Park (P) position.
Apply the parking brake, and close
the driver’s door.
With the auto door locking and
unlocking, the In-Bed Trunk also
locks and unlocks (the tailgate does
not lock).
T he auto door loc
k

ing f eature has
three possible settings:
The doors lock whenever you
move the shift lever out of the
Park (P) position.
The doors lock when the vehicle
speed reaches 9 mph (15 km/h).
The auto door locking is
deactivated all the time. 1.
2.
Locks all doors when the shif t lever is
moved out of Park (P).
Automatic (Auto) Door L ocking/
Unlocking
Childproof Door L ocks
A uto Door L ockingTo program the Park Lock mode:
Door L ocks
84
LOCK LEVER
Turn the ignition switch to the ON
(II) position (do not start the
engine).
3.

Locks all doors when the vehicle’s speedreaches about 9 mph (15 km/h).
Pushandholdthefrontof the
master door lock switch on the
driver’ s door. You will hear a
clicking sound, and af ter about 5
seconds, you will hear another
clicking sound.
Release the switch, and turn the
position within 5 seconds.
Make sure the shi

f t lever is in the
Park (P) position.
(II) position (do not start the
engine). Push and ho
l
d the brake pedal,
then move the shift lever out of
Park (P).
Pushandholdthefrontof the
master door lock switch on the
driver’ s door. You will hear a
clicking sound, and af ter about 5
seconds, you will hear another
clicking sound.
Release the switch, and turn the
ignition s w

itch to the
position within 5 seconds.
Apply the parking brake, and close
the driver’s door.
Turn the ignition switch to the ON
1.
2.
3. 5. 4.
6.
4.
5.
CONT INUED
Door L ocks
Inst rument s and Cont rols
85
(I)
ignition switch to the ACCESSORY
ACCESSORY
(I)
7. Move the shift lever to PARK (P).
To program the Drive Lock mode:

Pushandholdthefrontof the
master door lock switch on the
driver’s door. You will hear a
clicking sound af ter about 5
seconds.
Make sure the shif t lever is in the
Park (P) position. Release the switch, and turn the
ignition switch to the
position within 5 seconds. T
he driver’ s
door and then In-Bed
Trunk unlocks whenever you move
the shift lever to the PARK (P)
position.
All doors and the In-Bed trunk
unlocks whenever you move the
shift lever to the PARK (P) position.
T
he auto door
unloc

king f eature has
three modes (Park Unlock, Ignition
Switch, and Deactivated), with five
possible settings:
The driver’s door and the In-Bed
Trunk unlocks whenever you turn the
ignition switch to the LOCK (0) position.
All doors and the In-Bed Trunk unlocks
whenever you tur n

the ignition switch to
theLOCK (0) position.
The auto door unlocking settings
are deactivated.
Apply the parking brake, and
open
the driver’s door.
Turn the ignition switch to the ON
(II) position (do not start the engine).
1.
5. 4.
2.
3.
To turn off the Auto Lock modes:A uto Door Unlocking
Door L ocks
86
(I) ACCESSORY
Park Unlock mode:
Ignition Switch mode:
Deactivated:

Make sure the shi

f t lever is in
Park (P), and close the driver’s
door. Pushandholdtherearof the
master door lock switch on the
driver’s door. You will hear a
clicking sound. Continue to hold
down the switch:
Release the
s

witch, and turn the
ignition switch to the Make sure the shif t lever is in the
Park (P) position.
Turn the ig n

ition switch to the ON
(II) position.
Turn the ignition switch to the ON
(II) position (do not start the engine). Apply the parking brake, and close
the driver’s door.
1.
2. 4. 3.
1.
2.
3.
Unlocks driver’s door or all doors whenthe shift lever is moved to Park (P). Unlocks driver’ s door or a ll doors when
the ignition switch is out of the ON (II)posit ion.*
CONT INUED
To program the Park Unlock mode:U n l o c k mode:
Door L ocks
Inst rument s and Cont rols
87
position within 5 seconds.
(I) ACCESSORY
µ
about 5 sec
o
nds) to
activate the driver’s door unlock
f eature.
(af ter about 10 seconds) to activate the all door unlock
feature.
Or, until you hear a third click
µUntil you hear a second click
(af ter
To program the Ignition Sw itch
U n l o c k mode:
ÎIf equipped