lock HONDA S2000 2000 1.G Owner's Manual
[x] Cancel search | Manufacturer: HONDA, Model Year: 2000, Model line: S2000, Model: HONDA S2000 2000 1.GPages: 273, PDF Size: 21.58 MB
Page 65 of 273

Keys and Locks
Power Door Locks
Each door has a lock tab next to the
inside door handle. When you push
in the lock tab on the driver's door,
both doors lock.
Pulling out the lock
tab on the driver's door only unlocks
that door.
The lock tab on the
passenger's door only locks and
unlocks that door.
62 Instruments and Controls
To lock the passenger's door when
getting out of the car, push the lock
tab
in and close the door. To lock the
driver's door, remove the key from
the ignition switch, pull out either
the inside or outside door handle and
push the lock tab
in, then close the
door.
Both doors lock when you use
the
key in the driver's door. Using the
key
in the passenger's door only
locks and unlocks that door.
To unlock only the driver's door
from the outside, insert the key
in
the driver's door lock, turn the key
and release
it. If you turn the key
and hold
it, both doors will unlock.
Page 66 of 273

Remote Transmitter
You can lock and unlock your car
with the remote transmitter. When
you push the
LOCK button, both
doors lock.
The side marker lights
and taillights flash once.
When you push
the UNLOCK button
once, only the driver's door unlocks.
The parking lights and taillights
flash twice.
The passenger's door
unlocks when you push the button a
second time.
The interior light (if the interior light
switch is in
the center position) will
come on when you press the
UNLOCK button. If you do not open
either door, the light will go out in
about
30 seconds and the doors will
automatically relock.
If you relock
the doors with the remote
transmitter before
30 seconds have
elapsed, the light will go off
immediately.
You cannot lock or unlock the doors
with
the remote transmitter if either
door is not fully closed
or the key is
in the ignition switch.
To open the trunk, push and hold the
TRUNK RELEASE button for
approximately one second.
Keys and Locks
Hom Operation
The horn will sound if you push the
LOCK button a second time within
five seconds of locking the doors.
CONTINUED
Instruments and Controls 63
Page 67 of 273

Keys and Locks
Panic Mode
Panic mode allows you to remotely
activate your car's security system to
attract attention. When activated,
the
horn will sound, and the exterior
lights will flash for about
30 seconds.
To activate panic mode, press and
hold
the PANIC button for about one
second.
To cancel Panic mode before 30
seconds, press any button on the
remote transmitter. You can also
turn the ignition switch to
0 N (II).
64 Instruments and Controls
Replacing the Battery
When the remote transmitter's
battery begins to
get weak, it may
take several pushes on the button to
lock or unlock
the doors, and the
LED will
get dim. Replace the
battery as soon as possible.
Battery type: CR2025
To replace the battery, remove the
round cover on the back of the trans
mitter by turning it counterclockwise
with a coin.
Page 68 of 273

Remove the old battery and note the
polarity. Make sure the polarity of
the new battery is the same (
+ side
facing up), then insert it
in the
transmitter.
Align the
v mark on the cover
with the
0 mark on the
transmitter, then set the cover
in
place and turn it clockwise.
Transmitter Care
Avoid severe shock to the trans
mitter, such as dropping or throwing
it. Also, protect it from extreme hot
or cold temperatures.
Clean the transmitter case with a
soft cloth.
Do not use strong
cleaners or solvents that could harm
the case. Immersing the transmitter
in any liquid will harm the trans
mitter and cause it to not function
properly.
If you lose a transmitter, you will
need to have the replacement
programmed to your vehicle's
system by your Honda dealer. Any
other transmitters you have
will also
need to be reprogrammed.
Keys and Locks
As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions:
(1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that
may cause undesired
operation.
Changes
or modifications not expressly
approved
by the party responsible for
compliance could void
the user's
authority to operate
the equipment.
111is device complies with Industry
Canada Standard RSS-210.
Operation is subject
to the following two
conditions:
(1) this device may not cause
interference,
and (2) this device must
accept any interference that may cause
undesired operation
of the device.
Instruments and Controls 65
Page 69 of 273

Keys and Locks
Trunk
You can open the trunk in three
ways:
• Press the trunk release button in
the lower console compartment.
• Use the master key to open the
trunk lock.
The valet key does not
work in this lock.
• Press and hold the trunk release
button on the remote transmitter
for approximately one second (see
page
63 ).
66 Instruments and Controls
To close the trunk, press down on
the trunk lid.
To protect items in
the trunk when
you need to give the key to someone
else, lock the lower console
compartment with
the master key
and give
the other person the valet
key.
See page 124 for cargo loading and
weight limit information. Keep the
trunk lid closed
at all times while
driving to avoid damaging the lid,
and to prevent exhaust gas from
getting into
the interior. See Carbon
Monoxide Hazard
on page 39 .
Page 70 of 273

Console Compartments
The area between the seats has two
compartments.
Open the lower
compartment by squeezing the
handle.
Close it with a firm push.
You can lock or unlock the lower
compartment with the master key.
The lever to open the upper
compartment is inside the lower
compartment.
Push up the lever and
lift the
lid. To close, lower the lid and
push it down until it latches.
Keys and Locks
Instruments and Controls 67
Page 71 of 273

Seat Adjustments
See pages 12 -13 for important safety
information
and warnings about how to
properly position seats
and seat-backs.
Make all seat adjustments before
you start driving.
To adjust the seat forward and
backward, pull up on the lever under
the seat cushion's front edge. Move
the seat to the desired position and
release the lever.
Try to move the
seat to make sure it is locked
in
position.
68 Instruments and Controls
To change the angle of the seat-back,
pull up on the lever on the outside of
the seat bottom. Move the seat-back
to the desired position and release
the lever. Let the seat-back latch in
the new position.
Page 74 of 273

The convertible top on your Honda
lowers and raises electrically.
Before operating the convertible top,
make sure the car is parked on level
ground, and that there is enough
clearance above the top.
It is advisable to raise the top
whenever you park the car. This
helps to protect the car from
unexpected weather changes, and
from theft of your valuables.
NOTICE
• Do not operate the convertible top in
freezing weather. You can damage
the material and mechanism
of the
convertible top.
• Do not operate the top if it is wet,
dirty, or covered with ice or snow.
• Never drive the car with the
convertible top
half open.
• Do not lower or raise the top while
the engine
is running.
• Do not operate the convertible top if
the car is raised on the jack, a hoist,
or on jack stands.
Lowering the Convertible Top
Park your car in the shade whenever
possible. Extended exposure to sunlight can
cause the convertible top to
deteriorate.
1. Apply the parking brake. The
convertible top will not operate
unless
the parking brake is fully
engaged.
2. Turn the ignition switch to ON (II).
Convertible Top
3. There is a latch on each side. Push
in the tab and pull the locking
lever down.
CONTINUED
Instruments and Controls 71
Page 75 of 273

Convertible Top
4. Push the top forward while you
release the latches from the
windshield
header by pushing the
locking levers forward.
72 Instruments and Controls
5. With the latches released, pull
back on the locking levers and
push them up until they latch. 6. Pull back and hold the ROOF
switch.
Page 78 of 273

The convertible top will raise.
Release the
ROOF switch when the
top reaches
the windshield header.
5. Push in the tab on each locking
lever and pull the locking lever
down.
6. While pushing the convertible top
forward, push the locking lever
forward and
set the latch into the
windshield header.
7. Pull back on the locking lever and
push it
up until it latches. Make
sure it is securely latched.
Convertible Top
Operating the convertible top
while any part of a passenger is
in the way of the convertible top
can cause serious injury.
Make sure that you, your
passenger or any other
people
around the car are clear of the
way of the moving
convertible
top.
NOTICE
Do not put heavy items on the closed
convertible top. You can damage the
material and the mechanism.
Instruments and Controls 75