HUMMER H2 2007 Owners Manual

There are several ways to lock and unlock
your vehicle.
To unlock the door from the outside, use the
keyless entry system or the key.
To unlock or lock the
door from the inside,
slide the manual
lever forward or
rearward.Power Door Locks
The power door lock
switches are located on
the driver’s and front
passenger’s armrests.
Q(Lock):Remove the ignition key and press the
lock symbol to lock all of the doors.
If the delayed locking feature is on, the doors will
not lock until ve seconds after the last door is
closed. Press the lock symbol twice to override this
feature and lock all of the doors immediately.
SeeDelayed Locking on page 102for more
information.
K(Unlock):To unlock the doors, press the
unlock symbol.
101

Delayed Locking
When locking the doors with the power lock switch
or the keyless entry transmitter and a door or
the liftgate (if equipped) is open, the delayed
locking feature will delay locking the doors until
ve seconds after the last door is closed. You will
hear three chimes to signal that the delayed
locking feature is in use.
Pressing the power lock switch or the lock button
on the keyless entry transmitter twice will
override the delayed locking feature and
immediately lock all the doors.
You can turn the delayed locking feature off or
back on again by doing the following:
1. Press and hold the power door lock switch in
the lock position.
2. Press unlock twice on the remote keyless
entry transmitter.
This feature will not operate if the key is in the
ignition.
You can also program this feature using the DIC.
SeeDIC Vehicle Customization on page 234.
Programmable Automatic
Door Locks
Your vehicle is equipped with an automatic lock/
unlock feature which enables you to program your
vehicle’s power door locks. You can program this
feature through the Driver Information Center (DIC).
SeeDIC Vehicle Customization on page 234for
more information on DIC programming.
Rear Door Security Locks
With this feature, you can lock the rear doors so
they cannot be opened from the inside.
This feature is located
on the inside edge of
the rear doors.
102

To use the security locks, do the following:
1. Open one of the rear doors.
2. Turn the lock
counterclockwise
with your
ignition key.
3. Close the door.
4. Do the same to the other rear door.If you want to open the rear door while the
security lock is engaged, unlock and open the
door from the outside.
To disengage the child security lock feature, turn
the lock clockwise with your ignition key.
Lockout Protection
This feature protects you from locking your key in
the vehicle when the key is in the ignition and
a door is open.
If the power lock switch is pressed when a door is
open and the key is in the ignition, all of the doors
will lock and then the driver’s door will unlock.
103

Liftgate (SUV)
{CAUTION:
It can be dangerous to drive with
the liftgate open because carbon
monoxide (CO) gas can come into your
vehicle. You can not see or smell CO.
It can cause unconsciousness and even
death. If you must drive with the liftgate
open or if electrical wiring or other cable
connections must pass through the seal
between the body and the liftgate:
Make sure all other windows are shut.
Turn the fan on your heating or
cooling system to its highest speed
and select the control setting that will
force outside air into your vehicle.
SeeDual Automatic Climate Control
System on page 197.
If you have air outlets on or under the
instrument panel, open them all the
way. SeeEngine Exhaust on page 137.To lock and unlock the liftgate, use any of the
power door lock switches or the remote keyless
entry (RKE) transmitter.
To open the liftgate, do the following:
1. Move the spare tire carrier out of the way.
See “Opening the Spare Tire Carrier” under
Tailgate/Spare Tire Carrier on page 108.
2. Pull the handle located in the center of
the door.
To close the liftgate, do the following:
1. Pull the liftgate down until it latches.
2. Move the spare tire carrier back into place.
See “Closing the Spare Tire Carrier” under
Tailgate/Spare Tire Carrier on page 108.
104

Midgate®(SUT)
{CAUTION:
It can be dangerous to drive with the
cargo area covered and the tailgate and
the Midgate
®open because carbon
monoxide (CO) gas can come into your
vehicle. You can not see or smell CO.
It can cause unconsciousness and even
death. If you must drive with the cargo
covers on and the tailgate and Midgate
®
CAUTION: (Continued)
CAUTION: (Continued)
open or if electrical wiring or other cable
connections must pass through the seal
between the body and the Midgate
®:
Make sure all windows are shut.
Turn the fan on your heating or
cooling system to its highest speed
on the setting that brings in outside
air. This will force outside air into your
vehicle. SeeDual Automatic Climate
Control System on page 197.
If you have air outlets on or under the
instrument panel, open them all the
way. SeeEngine Exhaust on page 137.
The Midgate
®allows you to extend the length of
your vehicle’s cargo area into the cab.
105

Lowering the Midgate®
The Midgate®window must be completely lowered
for the Midgate®to be lowered. See “Midgate®
Window” underPower Windows on page 112.
Both the Midgate
®and the Midgate®window
can be lowered while the ignition is in either
RUN or ACCESSORY, or while in Retained
Accessory Power (RAP) mode. SeeRetained
Accessory Power (RAP) on page 121for
more information.To lower the Midgate
®, do the following:
1. Fold the rear seats forward. See60/40 Split
Bench Seat on page 15. The front seats may
have to be moved forward slightly.
2.
K(Midgate®Window):Press the bottom
part of this switch to lower the Midgate®
window. SeeInstrument Panel Overview on
page 174for the location of this switch.
The window can also be operated using the
global express-down button. See “Global
Glass Feature” underPower Windows
on page 112.
106

3. Press either one of the two power Midgate®
latch release buttons. The Midgate®will move
slightly forward from its closed position.
The latch release buttons operate while the
ignition is in RUN, ACCESSORY, in RAP
mode, or up to ten minutes after removing
the key. If necessary, press the global
express-down button to reactivate the release
buttons for an additional ten minutes.4. Pull the Midgate
®inward and down to its fully
lowered position.
5. Flip the auxiliary panel on the top of the
Midgate
®into position to bridge the gap
created by the hinges in the Midgate®.
There are two nger holds on the panel.
Raising the Midgate®
To raise the Midgate®, do the following:
1. Fold the auxiliary panel back into the exterior
of the Midgate
®. The panel should snap loudly
back into position which means it is secure.
2. Reverse the steps for lowering the Midgate
®
listed previously. The Midgate®must be fully
latched on both sides before the window
can be raised.
3. Press the top part of the Midgate
®window
switch to express-up the window. To stop
the window, press the switch a second time.
107

Tailgate/Spare Tire Carrier
Opening the Spare Tire Carrier
To open the spare tire carrier, do the following:
1. Press the button on the pin (B), which is
attached to the cable (A), to remove the
pin from the latch nut (C).2. Lift up on the latch on the left side of the
vehicle to release the spare tire carrier
from the vehicle. The handle will stay in the
raised position until the spare tire carrier
is closed and latched properly.
108

{CAUTION:
If you drive with the spare tire carrier
unlatched, you could injure pedestrians or
damage the vehicle. Make sure the carrier
is secure before driving.
3. Swing the spare tire carrier to the side.
Opening the Tailgate
Lift the release handle while pulling the tailgate
toward you.
SUT Model Spare Tire Carrier shown,
SUV Model similar
109

Closing the Spare Tire Carrier
To close the spare tire carrier, do the following:
1. Swing the tailgate up until it latches rmly
into place.
{CAUTION:
The spare tire carrier must be secured so
that it does not strike and injure someone.
Always close it into the latch forcefully.
Make sure that the release handle is fully
closed (down) and that the cable is
attached.
2. Move the spare tire carrier back into place
until it latches, by closing it into the latch
forcefully. The spare tire carrier is latched
properly when the latch handle has lowered
to the closed position.3. Reinstall the cable (A) by pushing in the
button on the pin (B) and inserting the pin
into the latch bolt nut (C).
4. Pull on the spare tire carrier to make sure it is
rmly latched.
110