INFINITI M 2010 Owners Manual
Manufacturer: INFINITI, Model Year: 2010, Model line: M, Model: INFINITI M 2010Pages: 445, PDF Size: 6.15 MB
Page 391 of 445

2. Open the engine hood and remove thecover on the battery and the fuse/fusible
link holder.
3. Remove the fuse/fusible link holder cover.
4. Remove the fuse with the fuse puller.
5. If the fuse is open
sA, replace it with a
new fuse
sB. Spare fuses are stored in the
passenger compartment fuse box.
6. If a new fuse also opens, have the elec- trical system checked and repaired by an
INFINITI retailer.
Fusible links
If any electrical equipment does not operate
and fuses are in good condition, check the
fusible links. If any of these fusible links are
melted, replace only with genuine INFINITI
parts.
SDI1753
8-26Maintenance and do-it-yourself
wÐ
Ð
05/15/09Ðpattie
X
Page 392 of 445

PASSENGER COMPARTMENT
CAUTION
Never use a fuse of a higher or lower amperage
rating than that specified on the fuse box cover.
This could damage the electrical system or
cause a fire.If any electrical equipment does not operate,
check for an open fuse.
1. Be sure the ignition switch is pushed to
the LOCK position and the headlight
switch is turned off.
2. Open the fuse box lid.
3. Remove the fuse with the fuse puller
sA. 4. If the fuse is open
sA, replace it with a
new fuse
sB. Spare fuses are stored in the
fuse box.
5. If a new fuse also opens, have the electri- cal system checked and repaired by an
INFINITI retailer.
SDI1833SDI1754
Maintenance and do-it-yourself8-27
wÐ
Ð
05/15/09Ðpattie
X
Page 393 of 445

CAUTION
Be careful not to allow children to swallow the
battery and removed parts.
INTELLIGENT KEY
To replace the battery:
1. Release the lock knob at the back of theIntelligent Key and remove the mechanical
key.
2. Insert a flat-blade screwdriver
sA
wrapped with a cloth into the slitsBof
the corner and twist it to separate the
upper part from the lower part.
3. Replace the battery with a new one.
Recommended battery:
CR2025 or equivalent
c Do not touch the internal circuit and
electric terminals as it could cause a
malfunction.
c Hold the battery by the edges. Holding
the battery across the contact points will
seriously deplete the storage capacity.
c Make sure that the + side faces the
bottom of the case.
SDI2294
BATTERY REPLACEMENT
8-28Maintenance and do-it-yourself
wÐ
Ð
05/15/09Ðpattie
X
Page 394 of 445

4. Align the tips of the upper and lowerparts, and then push them together until
it is securely closed.
5. Operate the buttons to check its opera- tion.
See an INFINITI retailer if you need any assis-
tance for replacement. FCC Notice:
This equipment has been tested and found to
comply with the limits for a Class B digital device
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential in-
stallation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the in-
structions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
±
Reorient or relocate the receiving antenna
± Increase the separation between the equip-
ment and the receiver
± Connect the equipment into an outlet on a
circuit different from that to which the re-
ceiver is connected.
± Consult the retailer or an experienced
radio/TV technician for help.
SDI1889
Maintenance and do-it-yourself8-29
wÐ
Ð
05/15/09Ðpattie
X
Page 395 of 445

1. Front turn signal light
2. Front park light/Headlight (high-beam)
3. Headlight (low-beam)
4. Map light
5. Rear personal light
6. Front fog light
7. Front side marker light
8. Front side turn signal light
9. Front sill plate light
10. Step light
11. License plate light
12. High-mounted stop light
13. Rear turn signal light
14. Trunk light
15. Back-up light
16. Tail/stop light
17. Rear side marker light
SDI2156
LIGHTS
8-30Maintenance and do-it-yourself
wÐ
Ð
05/15/09Ðpattie
X
Page 396 of 445

HEADLIGHTS
Fog may temporarily form inside the lens of the
exterior lights in the rain or in a car wash. A
temperature difference between the inside and
the outside of the lens causes the fog. This is
not a malfunction. If large drops of water collect
inside the lens, contact an INFINITI retailer.
Replacing
Xenon headlight model :
WARNING
HIGH VOLTAGE
When xenon headlights are on, they produce a
high voltage. To prevent an electric shock,
never attempt to modify or disassemble. Al-
ways have your xenon headlights replaced at
an INFINITI retailer. For additional information,
see ªHEADLIGHT AND TURN SIGNAL SWITCHº in
the ª2. Instruments and controlsº section.Use the same number and wattage as originally
installed:
Low beam (Xenon):Wattage: 35
Bulb no.: D2S
High beam (Halogen): Wattage: 60
Bulb no.: HB3
If replacement is required, see an INFINITI re-
tailer.
Maintenance and do-it-yourself8-31
wÐ
Ð
05/15/09Ðpattie
X
Page 397 of 445

EXTERIOR AND INTERIOR LIGHTS
ItemWattage (W)Bulb No.
Front turn signal light* 21WY21W
Front fog light* 55H11
Front park light* 5 W5W
Front side turn signal light* 5 W5W
Rear combination light* back-up 18 W16W
turn signal 21 WY21W
stop/tail/side marker LED Ð
License plate light* 5 W5W
Map light 8 Ð
Rear personal light 8 Ð
Vanity mirror light 1.8 Ð
Step light* 3.4 Ð
Front sill plate light*
Trunk light* 5 Ð
High-mounted stop light* LED Ð
*: See an INFINITI retailer for replacement.
NOTE: Always check with the Parts Department at an INFINITI retailer for the latest information about
parts.
8-32Maintenance and do-it-yourself
wÐ
Ð
05/15/09Ðpattie
X
Page 398 of 445

: REMOVE
: INSTALL
Replacement procedures
All other lights are either type A, B, C, D or E.
When replacing a bulb, first remove the lens
and/or cover.
SDI2306
Map light
SDI2334
Rear personal light
SDI1838
Vanity mirror light
SDI1839
Maintenance and do-it-yourself8-33
wÐ
Ð
05/19/09Ðtbrooks
X
Page 399 of 445

If you have a flat tire, see ªFLAT TIREº in the ª6. In
case of emergencyº section.
TIRE PRESSURE
Tire Pressure Monitoring System
(TPMS)
This vehicle is equipped with the Tire Pressure
Monitoring System (TPMS). It monitors tire
pressure of all tires except the spare. When the
low tire pressure warning light is lit, one or
more of your tires is significantly under-
inflated.
The TPMS will activate only when the vehicle is
driven at speeds above 16 MPH (25 km/h). Also,
this system may not detect a sudden drop in tire
pressure (for example a flat tire while driving).
For more details, see ªLow tire pressure warn-
ing lightº in the ª2. Instruments and controlsº
section, ªTire Pressure informationº in the ª4.
Monitor, climate, audio, phone and voice rec-
ognition systemsº section, ªTIRE PRESSURE
MONITORING SYSTEM (TPMS)º in the ª5. Start-
ing and drivingº section and ªTIRE PRESSURE
MONITORING SYSTEM (TPMS)º in the ª6. In case
of emergencyº section.
Tire inflation pressure
Check the pressure of the tires (includ-
ing the spare) often and always prior to
long distance trips. The recommended
tire pressure specifications are shown
on the Tire and Loading Information
label under the ªCold Tire Pressureº
heading. The Tire and Loading Informa-
tion label is affixed to the driver side
center pillar. Tire pressures should be
checked regularly because:
cMost tires naturally lose air over time.
cTires can lose air suddenly when
driven over potholes or other objects
or if the vehicle strikes a curb while
parking.
The tire pressures should be checked
when the tires are cold. The tires are
considered COLD after the vehicle has
been parked for 3 or more hours, or
driven less than 1 mile (1.6 km) at mod-
erate speeds. Incorrect tire pressure, including under
inflation, may adversely affect tire life
and vehicle handling.
WARNING
cImproperly inflated tires can fail sud-
denly and cause an accident.
cThe Gross Vehicle Weight rating
(GVWR) is located on the F.M.V.S.S./
C.M.V.S.S. certification label. The ve-
hicle weight capacity is indicated on
the Tire and Loading Information la-
bel. Do not load your vehicle beyond
this capacity. Overloading your ve-
hicle may result in reduced tire life,
unsafe operating conditions due to
premature tire failure, or unfavorable
handling characteristics and could
also lead to a serious accident. Load-
ing beyond the specified capacity
may also result in failure of other ve-
hicle components.
WHEELS AND TIRES
8-34Maintenance and do-it-yourself
wÐ
Ð
05/15/09Ðpattie
X
Page 400 of 445

cBefore taking a long trip, or whenever
you heavily load your vehicle, use a
tire pressure gauge to ensure that the
tire pressures are at the specified
level.
cFor additional information regarding
tires, refer to ªImportant Tire Safety
Informationº (US) or ªTire Safety In-
formationº (Canada) in the Warranty
Information Booklet.
Maintenance and do-it-yourself8-35
wÐ
Ð
05/15/09Ðpattie
X