INFINITI QX4 2001 Factory Service Manual

INFINITI QX4 2001 Factory Service Manual QX4 2001 INFINITI INFINITI https://www.carmanualsonline.info/img/42/57027/w960_57027-0.png INFINITI QX4 2001 Factory Service Manual
Trending: brakes, buttons, wiper size, tire size, automatic transmission, seat adjustment, Theft warning system

Page 881 of 2395

INFINITI QX4 2001  Factory Service Manual 4 CHECK CMPS (PHASE) GROUND CIRCUIT FOR OPEN AND SHORT
1. Check harness continuity between CMPS (PHASE) terminal 1 and engine ground.
Continuity should exist.
2. Also check harness for short to power.

Page 882 of 2395

INFINITI QX4 2001  Factory Service Manual SEF484Y
On Board Diagnosis LogicNBEC0214The ECM monitors the switching frequency ratio of heated oxygen
sensors 1 (front) and 2 (rear).
A warm-up three way catalyst with high oxygen storage capacity
w

Page 883 of 2395

INFINITI QX4 2001  Factory Service Manual SEF344Z
DTC Confirmation ProcedureNBEC0215
SEF345Z
SEF560X
NOTE:
If ªDTC Confirmation Procedureº has been previously conducted,
always turn ignition switch ªOFFº and wait at least 10 seconds
befor

Page 884 of 2395

INFINITI QX4 2001  Factory Service Manual A: Rear heated oxygen sensor voltage switching fre-
quency
B: Front heated oxygen sensor voltage switching fre-
quency
This ratio should be less than 0.75.
If the ratio is greater than above, it means

Page 885 of 2395

INFINITI QX4 2001  Factory Service Manual 4 CHECK IGNITION TIMING
Check the following items. Refer to ªBasic Inspectionº, EC-101.
MTBL0655
OK or NG
OK©GO TO 5.
NG©Follow the ªBasic Inspectionº.
5 CHECK INJECTORS
1. Refer to WIRING DIAGR

Page 886 of 2395

INFINITI QX4 2001  Factory Service Manual 6 CHECK IGNITION SPARK
1. Turn ignition switch ªOFFº.
2. Disconnect ignition coil assembly from rocker cover.
3. Connect a known good spark plug to the ignition coil assembly.
4. Place end of spark

Page 887 of 2395

INFINITI QX4 2001  Factory Service Manual On Board Diagnosis LogicNBEC0218NOTE:
If DTC P0440 is displayed with P1448, perform trouble diagno-
sis for DTC P1448 first. (See EC-573.)
This diagnosis detects leaks in the EVAP purge line using eng

Page 888 of 2395

INFINITI QX4 2001  Factory Service Manual IEVAP purge line rubber tube bent.
IBlocked or bent rubber tube to EVAP control system pressure
sensor
ILoose or disconnected rubber tube
IEVAP canister vent control valve and the circuit
IEVAP canist

Page 889 of 2395

INFINITI QX4 2001  Factory Service Manual SEF565X
DTC Confirmation ProcedureNBEC0219
SEF566X
SEF874X
SEF567X
NOTE:
IIf DTC P0440 or P1440 is displayed with P1448, perform
trouble diagnosis for DTC P1448 first. (See EC-573.)
IIf ªDTC Confirma

Page 890 of 2395

INFINITI QX4 2001  Factory Service Manual IIf P0440, P1440 and P1447 are not displayed on the screen,
go to the following step.
10) Select ªMODE 1º with GST.
IIf SRT of EVAP system is set, the result will be OK.
IIf SRT of EVAP system is no
Trending: battery replacement, fog light bulb, automatic transmission, Battery cables connecting, Battery, AT-46, load capacity