JEEP COMMANDER 2009 1.G Owners Manual

JEEP COMMANDER 2009 1.G Owners Manual COMMANDER 2009 1.G JEEP JEEP https://www.carmanualsonline.info/img/16/7065/w960_7065-0.png JEEP COMMANDER 2009 1.G Owners Manual
Trending: dimensions, lights, tow bar, wheel size, wheel, seats, gas type

Page 161 of 519

JEEP COMMANDER 2009 1.G Owners Manual Enable/Disable The Rear Park Assist System
The Rear Park Assist System can be enabled and disabled
with a switch located on the upper switch bank of the
instrument panel.When the switch is pressed to

Page 162 of 519

JEEP COMMANDER 2009 1.G Owners Manual Cleaning The Rear Park Assist System
Clean the Rear Park Assist Sensors with water, car wash
soap and a soft cloth. Do not use rough or hard cloths. Do
not scratch or poke the sensors. Otherwise, you

Page 163 of 519

JEEP COMMANDER 2009 1.G Owners Manual 4. When the vehicle is shifted into REVERSE, an image of
the rear of the vehicle will appear with a caution note to
check entire surroundingsdisplayed across the top of
the screen. After five second

Page 164 of 519

JEEP COMMANDER 2009 1.G Owners Manual OVERHEAD CONSOLE — IF EQUIPPED
The overhead console contains an optional universal
garage door opener (HomeLink), storage for sunglasses,
and optional power sunroof switches.
GARAGE DOOR OPENER —

Page 165 of 519

JEEP COMMANDER 2009 1.G Owners Manual NOTE:HomeLinkis disabled when the Vehicle Secu-
rity Alarm is active.
WARNING!
•Your motorized door or gate will open and close
while you are training the Universal Transceiver.
Do not train the tr

Page 166 of 519

JEEP COMMANDER 2009 1.G Owners Manual Programming HomeLink
Before You Begin
If you have not trained any of the HomeLinkbuttons,
erase all channels before you begin training.
To do this, press and hold the two outside buttons for up
to 2

Page 167 of 519

JEEP COMMANDER 2009 1.G Owners Manual NOTE:Some gate operators and garage door openers
may require you to replace Step 3 with procedures noted
in the “Gate Operator/Canadian Programming” section.
4. Press and hold the just-trained Hom

Page 168 of 519

JEEP COMMANDER 2009 1.G Owners Manual 6. Firmly press and release the “learn” or “training”
button. The name and color of the button may vary by
manufacturer.
NOTE:There are 30 seconds in which to initiate the next
step after the

Page 169 of 519

JEEP COMMANDER 2009 1.G Owners Manual If you unplugged the device for training, plug it back in
at this time.
Then proceed with Step 4 under “Programming
HomeLink” earlier in this section.
Using HomeLink
To operate, simply press and

Page 170 of 519

JEEP COMMANDER 2009 1.G Owners Manual Troubleshooting Tips
If you are having trouble programming HomeLink, here
are some of the most common solutions:
•Replace the battery in the original transmitter.
•Press the learn button on the g
Trending: stop start, seat memory, checking oil, mirror controls, differential, Airbag, brake fluid